From: Santosh Shilimkar <santosh.shilimkar@ti.com>
To: Afzal Mohammed <afzal@ti.com>
Cc: linux-omap@vger.kernel.org, linux-arm-kernel@lists.infradead.org,
devicetree-discuss@lists.ozlabs.org, linux-doc@vger.kernel.org,
linux-kernel@vger.kernel.org,
Russell King <linux@arm.linux.org.uk>,
Tony Lindgren <tony@atomide.com>,
Marc Zyngier <marc.zyngier@arm.com>,
Nicolas Pitre <nico@linaro.org>,
Will Deacon <will.deacon@arm.com>,
Linus Walleij <linus.walleij@linaro.org>,
Rob Herring <rob.herring@calxeda.com>,
Grant Likely <grant.likely@secretlab.ca>,
Rob Landley <rob@landley.net>, Sekhar Nori <nsekhar@ti.com>,
Syed Mohammed Khasim <khasim@ti.com>
Subject: Re: [PATCH, RFC 0/8] ARM: AM43 (OMAP2+) boot support
Date: Tue, 19 Feb 2013 15:39:32 +0530 [thread overview]
Message-ID: <51234F5C.6050500@ti.com> (raw)
In-Reply-To: <cover.1361186097.git.afzal@ti.com>
On Monday 18 February 2013 05:05 PM, Afzal Mohammed wrote:
> (Resending, since it seems, LAKML doesn't accept patches with subject
> prefix only as "RFC", but requires "PATCH" prefix also)
>
> Hi,
>
> This series adds minimal support to boot Linux on platforms having
> AM43 based SoC's.
>
> This is being sent as an RFC to seek opinion about modification in
> twd to register percpu local timer clock event for scheduler tick in
> the case of one core SMP.
>
> AM43 SoC's are based on ARM Cortex-A9. It is an ARM Cortex-A9 SMP
> configuration with one core (not uniprocessor configuration). AM43 is
> similar to AM335x in it's peripheral capabilities, with many of the
> peripheral register mapping's similar like that of uart.
>
After looking at the specs, you don't need the SMP mode since ACP
isn't being used.
> AM43 is in pre-silicon stage and currently there are no public
> documents.
>
> This series has been tested on a pre-silicon platform that emulates
> AM43 SoC, changes proposed here are minimal - to get it booting.
> Kernel was directly run without the help of bootloader - Images were
> directly loaded onto a pre-initialized RAM and ARM registers updated
> as required for booting.
>
> Changes have been made over linux-next (next-20130213) with three "OF"
> related reverts (which otherwise causes problem in other platforms
> also) and compiled with omap2plus_defconfig. Multiplatform option was
> enabled, while most of CONFIG options were deselected for a faster
> boot. Beagle bone boots as earlier with these changes.
>
> An interesting observation is that it may be possible to boot this
> platform to console without any platform specific modification to
> proper Kernel (by that I mean excluding DT sources) using Arnd's,
>
> "[PATCH,RFC] default machine descriptor for multiplatform",
>
> along with a "CLOCKSOURCE_OF_DECLARE" for smp twd.
>
TWD use for AM437x is also limited because these times stops in
low power sates and there you will need broad-cast mechanism which
again more of SMP machine feature.
So I suggest to use the wakeup timer(GPT1) clock-event instead
of local timer for the mentioned reason.
Regards,
Santosh
next prev parent reply other threads:[~2013-02-19 10:09 UTC|newest]
Thread overview: 32+ messages / expand[flat|nested] mbox.gz Atom feed top
2013-02-18 11:35 [PATCH, RFC 0/8] ARM: AM43 (OMAP2+) boot support Afzal Mohammed
2013-02-18 11:36 ` [PATCH, RFC 1/8] ARM: localtimer: return percpu clkevt on register Afzal Mohammed
2013-02-19 10:22 ` Santosh Shilimkar
[not found] ` <e7cbb10903841ba23a93f71e7a06ae34a43adc70.1361186097.git.afzal-l0cyMroinI0@public.gmane.org>
2013-02-19 12:10 ` Felipe Balbi
2013-02-18 11:37 ` [PATCH, RFC 2/8] ARM: twd: register clock event for 1 core SMP Afzal Mohammed
2013-02-19 10:14 ` Santosh Shilimkar
2013-02-19 12:14 ` Felipe Balbi
[not found] ` <20130219121400.GP23197-S8G//mZuvNWo5Im9Ml3/Zg@public.gmane.org>
2013-02-19 12:20 ` Santosh Shilimkar
[not found] ` <cover.1361186097.git.afzal-l0cyMroinI0@public.gmane.org>
2013-02-18 11:37 ` [PATCH, RFC 3/8] ARM: twd: clock rate from DT (if no DT clk tree) Afzal Mohammed
2013-02-19 10:18 ` Santosh Shilimkar
2013-02-18 11:38 ` [PATCH, RFC 5/8] ARM: OMAP2+: am43: Kconfig Afzal Mohammed
2013-02-19 10:27 ` Santosh Shilimkar
[not found] ` <5123537B.8050709-l0cyMroinI0@public.gmane.org>
2013-02-19 10:56 ` Felipe Balbi
2013-02-19 11:01 ` Santosh Shilimkar
2013-02-18 11:38 ` [PATCH, RFC 6/8] ARM: OMAP2+: am43: basic dt support Afzal Mohammed
2013-02-19 10:32 ` Santosh Shilimkar
2013-02-18 11:37 ` [PATCH, RFC 4/8] ARM: am33xx: ll debug config help Afzal Mohammed
2013-02-19 10:25 ` Santosh Shilimkar
2013-02-19 10:30 ` Mohammed, Afzal
2013-02-19 11:02 ` Santosh Shilimkar
2013-02-18 11:38 ` [PATCH, RFC 7/8] ARM: dts: am4372: initial support Afzal Mohammed
2013-02-18 18:22 ` Felipe Balbi
2013-02-19 9:10 ` Mohammed, Afzal
[not found] ` <C8443D0743D26F4388EA172BF4E2A7A93EAA85B2-Er742YJ7I/eIQmiDNMet8wC/G2K4zDHf@public.gmane.org>
2013-02-19 9:17 ` Felipe Balbi
2013-02-18 11:38 ` [PATCH, RFC 8/8] ARM: dts: am43-pre-silicon support Afzal Mohammed
2013-02-19 10:35 ` Santosh Shilimkar
2013-02-19 10:52 ` Mohammed, Afzal
[not found] ` <C8443D0743D26F4388EA172BF4E2A7A93EAA86DE-Er742YJ7I/eIQmiDNMet8wC/G2K4zDHf@public.gmane.org>
2013-02-19 11:00 ` Santosh Shilimkar
2013-02-19 11:03 ` Mohammed, Afzal
2013-02-19 11:11 ` Santosh Shilimkar
2013-02-19 10:09 ` Santosh Shilimkar [this message]
2013-02-19 11:24 ` [PATCH, RFC 0/8] ARM: AM43 (OMAP2+) boot support Mohammed, Afzal
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=51234F5C.6050500@ti.com \
--to=santosh.shilimkar@ti.com \
--cc=afzal@ti.com \
--cc=devicetree-discuss@lists.ozlabs.org \
--cc=grant.likely@secretlab.ca \
--cc=khasim@ti.com \
--cc=linus.walleij@linaro.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-doc@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=linux@arm.linux.org.uk \
--cc=marc.zyngier@arm.com \
--cc=nico@linaro.org \
--cc=nsekhar@ti.com \
--cc=rob.herring@calxeda.com \
--cc=rob@landley.net \
--cc=tony@atomide.com \
--cc=will.deacon@arm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).