Re: [PATCH 5/6] phy: omap-usb2: Balance pm_runtime_enable() on probe failure

[Kishon Vijay Abraham I <kishon@ti.com>]

Hi Roger,

On Wednesday 02 July 2014 05:33 PM, Roger Quadros wrote:
> If probe fails then we need to call pm_runtime_disable() to balance
> out the previous pm_runtime_enable() call. Else it will cause
> unbalanced pm_runtime_enable() call in the succeding probe call.
> 
> This anomaly was observed when the call to devm_phy_create() failed
> with -EPROBE_DEFER.
> 
> Signed-off-by: Roger Quadros <rogerq@ti.com>
> ---
>  drivers/phy/phy-omap-usb2.c | 8 ++++++--
>  1 file changed, 6 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/phy/phy-omap-usb2.c b/drivers/phy/phy-omap-usb2.c
> index 7007c11..c6f9809 100644
> --- a/drivers/phy/phy-omap-usb2.c
> +++ b/drivers/phy/phy-omap-usb2.c
> @@ -265,15 +265,19 @@ static int omap_usb2_probe(struct platform_device *pdev)
>  	pm_runtime_enable(phy->dev);
>  
>  	generic_phy = devm_phy_create(phy->dev, &ops, NULL);
> -	if (IS_ERR(generic_phy))
> +	if (IS_ERR(generic_phy)) {
> +		pm_runtime_disable(phy->dev);
>  		return PTR_ERR(generic_phy);
> +	}

Maybe we can move pm_runtime_enable to just before phy_provider_register?
>  
>  	phy_set_drvdata(generic_phy, phy);
>  
>  	phy_provider = devm_of_phy_provider_register(phy->dev,
>  			of_phy_simple_xlate);
> -	if (IS_ERR(phy_provider))
> +	if (IS_ERR(phy_provider)) {
> +		pm_runtime_disable(phy->dev);
>  		return PTR_ERR(phy_provider);
> +	}

Noticed pm_runtime_disable was missing in omap_usb2_remove too. Would be good
to fix it here.

Cheers
Kishon