Re: [PATCH-V4 3/3] ARM: OMAP: Make OMAP clocksource source selection using kernel param

[Kevin Hilman <khilman@ti.com>]

Vaibhav Hiremath <hvaibhav@ti.com> writes:

> Current OMAP code supports couple of clocksource options based
> on compilation flag (CONFIG_OMAP_32K_TIMER). The 32KHz sync-timer
> and a gptimer which can run on 32KHz or system clock (e.g 38.4 MHz).

[...]

> +
> +	sync32k_ick = clk_get(NULL, "omap_32ksync_ick");
> +	if (!IS_ERR(sync32k_ick))
> +		clk_enable(sync32k_ick);
> +
> +	sync32k_cnt_reg = base + OMAP2_32KSYNCNT_CR_OFF;
> +
> +	/*
> +	 * 120000 rough estimate from the calculations in
> +	 * __clocksource_updatefreq_scale.
> +	 */
> +	clocks_calc_mult_shift(&persistent_mult, &persistent_shift,
> +			32768, NSEC_PER_SEC, 120000);
> +
> +	ret = clocksource_mmio_init(base, "32k_counter", 32768, 250, 32,
> +				clocksource_mmio_readl_up);

After discussing this a bit with Vaibhav offline, we found that 'base'
here should be sync32k_cnt_reg.

Can you guys that were seeing the hang confirm that that fixes the
issue?

If so, please reply with your Tested-by.  

Thanks,

Kevin