From: Kevin Hilman <khilman@ti.com>
To: "Govindraj.R" <govindraj.raja@ti.com>
Cc: linux-omap@vger.kernel.org, linux-serial@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
Tony Lindgren <tony@atomide.com>,
Benoit Cousson <b-cousson@ti.com>, Paul Walmsley <paul@pwsan.com>,
Rajendra Nayak <rnayak@ti.com>
Subject: Re: [PATCH 2/7] OMAP2+: mux: Enable wakeup for wakeup enable requested pads
Date: Fri, 04 Mar 2011 17:27:00 -0800 [thread overview]
Message-ID: <87bp1q5pcr.fsf@ti.com> (raw)
In-Reply-To: <1299064343-28534-1-git-send-email-govindraj.raja@ti.com> (Govindraj R.'s message of "Wed, 2 Mar 2011 16:42:23 +0530")
"Govindraj.R" <govindraj.raja@ti.com> writes:
> For device pads which have OMAP_DEVICE_PAD_WAKEUP set (which means they
> are wakeup capable) enable the IO-daisy wakeup capability.
> During re-muxing avoid direct write with val as this can disturb if any
> mux done at bootloader level so read the pad then write back.
>
> Also add an API to fetch the wake-up status bit is set for given omap-hwmod
> device using available mux info which is added during omap_hwmod_mux_init.
> Wakeup status bit is needed for uart_resume_idle call from sram_idle path
> based on wake-up event has occurred for given uart we can enable clocks back.
>
> Signed-off-by: Rajendra Nayak <rnayak@ti.com>
> Signed-off-by: Govindraj.R <govindraj.raja@ti.com>
Another issue with this patch...
This actually is a change in behavior from the previous code. The
current code (albiet hacky) only enables IO-ring wakeups when
device_may_wakeup() == true.
This code should probably also do the same.
Kevin
> ---
> arch/arm/mach-omap2/mux.c | 28 ++++++++++++++++++++++++++
> arch/arm/mach-omap2/mux.h | 13 ++++++++++++
> arch/arm/mach-omap2/omap_hwmod.c | 13 ++++++++++++
> arch/arm/plat-omap/include/plat/omap_hwmod.h | 1 +
> 4 files changed, 55 insertions(+), 0 deletions(-)
>
> diff --git a/arch/arm/mach-omap2/mux.c b/arch/arm/mach-omap2/mux.c
> index 98148b6..50edcea 100644
> --- a/arch/arm/mach-omap2/mux.c
> +++ b/arch/arm/mach-omap2/mux.c
> @@ -317,6 +317,29 @@ err1:
> return NULL;
> }
>
> +/* Gets the wakeup status of given pad from omap-hwmod */
> +int omap_hwmod_mux_wakeup(struct omap_hwmod_mux_info *hmux)
> +{
> + int i;
> + unsigned int val;
> + u8 ret = 0;
> +
> + for (i = 0; i < hmux->nr_pads; i++) {
> + struct omap_device_pad *pad = &hmux->pads[i];
> +
> + if (pad->flags & OMAP_DEVICE_PAD_WAKEUP) {
> + val = omap_mux_read(pad->partition,
> + pad->mux->reg_offset);
> + if (val & OMAP_WAKEUP_EVENT) {
> + ret = 1;
> + break;
> + }
> + }
> + }
> +
> + return ret;
> +}
> +
> /* Assumes the calling function takes care of locking */
> void omap_hwmod_mux(struct omap_hwmod_mux_info *hmux, u8 state)
> {
> @@ -342,6 +365,9 @@ void omap_hwmod_mux(struct omap_hwmod_mux_info *hmux, u8 state)
> break;
> flags &= ~OMAP_DEVICE_PAD_ENABLED;
> val = pad->idle;
> + if (flags & OMAP_DEVICE_PAD_WAKEUP)
> + val |= OMAP_WAKEUP_EN;
> +
> pr_debug("%s: Idling %s %x\n", __func__,
> pad->name, val);
> break;
> @@ -358,6 +384,8 @@ void omap_hwmod_mux(struct omap_hwmod_mux_info *hmux, u8 state)
> };
>
> if (val >= 0) {
> + val |= omap_mux_read(pad->partition,
> + pad->mux->reg_offset);
> omap_mux_write(pad->partition, val,
> pad->mux->reg_offset);
> pad->flags = flags;
> diff --git a/arch/arm/mach-omap2/mux.h b/arch/arm/mach-omap2/mux.h
> index a4ab17a..84a8fc2 100644
> --- a/arch/arm/mach-omap2/mux.h
> +++ b/arch/arm/mach-omap2/mux.h
> @@ -220,8 +220,21 @@ omap_hwmod_mux_init(struct omap_device_pad *bpads, int nr_pads);
> */
> void omap_hwmod_mux(struct omap_hwmod_mux_info *hmux, u8 state);
>
> +
> +/**
> + * omap_hwmod_mux_wakeup - omap hwmod check given pad had wakeup event
> + * @hmux: Pads for a hwmod
> + *
> + * Called only from omap_hwmod.c, do not use.
> + */
> +int omap_hwmod_mux_wakeup(struct omap_hwmod_mux_info *hmux);
> #else
>
> +static inline int omap_hwmod_mux_wakeup(struct omap_hwmod_mux_info *hmux)
> +{
> + return 0;
> +}
> +
> static inline int omap_mux_init_gpio(int gpio, int val)
> {
> return 0;
> diff --git a/arch/arm/mach-omap2/omap_hwmod.c b/arch/arm/mach-omap2/omap_hwmod.c
> index 9e89a58..893dae1 100644
> --- a/arch/arm/mach-omap2/omap_hwmod.c
> +++ b/arch/arm/mach-omap2/omap_hwmod.c
> @@ -2239,3 +2239,16 @@ u32 omap_hwmod_get_context_loss_count(struct omap_hwmod *oh)
>
> return ret;
> }
> +
> +/**
> + * omap_hwmod_pad_wakeup_status - get pad wakeup status if mux is available.
> + * @oh: struct omap_hwmod *
> + *
> + * Returns the wake_up status bit of available pad mux pin.
> + */
> +int omap_hmwod_pad_wakeup_status(struct omap_hwmod *oh)
> +{
> + if (oh->mux)
> + return omap_hwmod_mux_wakeup(oh->mux);
> + return -EINVAL;
> +}
> diff --git a/arch/arm/plat-omap/include/plat/omap_hwmod.h b/arch/arm/plat-omap/include/plat/omap_hwmod.h
> index fedd829..4100be0 100644
> --- a/arch/arm/plat-omap/include/plat/omap_hwmod.h
> +++ b/arch/arm/plat-omap/include/plat/omap_hwmod.h
> @@ -588,6 +588,7 @@ int omap_hwmod_for_each_by_class(const char *classname,
> int omap_hwmod_set_postsetup_state(struct omap_hwmod *oh, u8 state);
> u32 omap_hwmod_get_context_loss_count(struct omap_hwmod *oh);
>
> +int omap_hmwod_pad_wakeup_status(struct omap_hwmod *oh);
> /*
> * Chip variant-specific hwmod init routines - XXX should be converted
> * to use initcalls once the initial boot ordering is straightened out
next prev parent reply other threads:[~2011-03-05 1:27 UTC|newest]
Thread overview: 16+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-03-02 11:12 [PATCH 2/7] OMAP2+: mux: Enable wakeup for wakeup enable requested pads Govindraj.R
2011-03-04 23:54 ` Kevin Hilman
2011-03-05 1:57 ` Kevin Hilman
2011-03-08 11:44 ` Govindraj
2011-03-08 17:26 ` Tony Lindgren
2011-03-08 18:31 ` Kevin Hilman
2011-03-08 19:16 ` Paul Walmsley
2011-03-08 19:21 ` Paul Walmsley
2011-03-09 12:06 ` Govindraj
2011-03-08 12:19 ` Govindraj
2011-03-09 1:14 ` Kevin Hilman
2011-03-09 14:45 ` Govindraj
2011-03-05 1:27 ` Kevin Hilman [this message]
-- strict thread matches above, loose matches on Subject: below --
2011-02-28 14:39 [PATCH 0/7] OMAP2+: UART: runtime conversion + cleanup Govindraj.R
2011-02-28 14:39 ` [PATCH 2/7] OMAP2+: mux: Enable wakeup for wakeup enable requested pads Govindraj.R
2011-03-02 4:49 ` Varadarajan, Charulatha
2011-03-02 10:40 ` Govindraj
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=87bp1q5pcr.fsf@ti.com \
--to=khilman@ti.com \
--cc=b-cousson@ti.com \
--cc=govindraj.raja@ti.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-omap@vger.kernel.org \
--cc=linux-serial@vger.kernel.org \
--cc=paul@pwsan.com \
--cc=rnayak@ti.com \
--cc=tony@atomide.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox