From: Kevin Hilman <khilman@deeprootsystems.com>
To: Tero Kristo <tero.kristo@nokia.com>
Cc: linux-omap@vger.kernel.org
Subject: Re: [PATCH 17/17] OMAP3: PM: Force disable OTG autoidle
Date: Tue, 20 Oct 2009 11:44:27 -0700 [thread overview]
Message-ID: <87eioxsy5w.fsf@deeprootsystems.com> (raw)
In-Reply-To: 1255690150-16853-18-git-send-email-tero.kristo@nokia.com
Tero Kristo <tero.kristo@nokia.com> writes:
> From: Tero Kristo <tero.kristo@nokia.com>
>
> OMAP3 sleep can be prevented in some cases where OTG autoidle is enabled.
> This patch force disables autoidle during boot and after wakeup from off-mode.
> See omap erratas 1.164 and 1.165.
The init-at-boot step isn't needed as this is already done in
PM branch (see usb-muxb.c:usb_musb_pm_init()).
> Signed-off-by: Tero Kristo <tero.kristo@nokia.com>
> ---
> arch/arm/mach-omap2/pm34xx.c | 14 ++++++++++++++
> 1 files changed, 14 insertions(+), 0 deletions(-)
>
> diff --git a/arch/arm/mach-omap2/pm34xx.c b/arch/arm/mach-omap2/pm34xx.c
> index ae83121..5f351f2 100644
> --- a/arch/arm/mach-omap2/pm34xx.c
> +++ b/arch/arm/mach-omap2/pm34xx.c
> @@ -94,6 +94,8 @@ u32 voltage_off_while_idle;
> OMAP3430_ST_GPT5_MASK|OMAP3430_ST_GPT4_MASK|\
> OMAP3430_ST_GPT3_MASK|OMAP3430_ST_GPT2_MASK)
>
> +#define OTG_SYSCONFIG (OMAP34XX_HSUSB_OTG_BASE + 0x404)
> +
> struct power_state {
> struct powerdomain *pwrdm;
> u32 next_state;
> @@ -423,6 +425,16 @@ static void restore_table_entry(void)
> restore_control_register(control_reg_value);
> }
>
> +static inline void disable_otg_autoidle(void)
> +{
> + /*
> + * OTG autoidle can prevent core domain sleep in some cases, thus
> + * disable it. See omap erratas 1.164 and 1.165.
> + */
> + cm_set_mod_reg_bits(OMAP3430_EN_HSOTGUSB, CORE_MOD, CM_ICLKEN1);
Is the ICLK enable required as part of the fix too? I don't see
mention of enabling the iclk as part of the workaround for either of
these errata.
If the iclk needs to be enabled, it should be done at init using
the clk API.
> + omap_writel(0x0, OTG_SYSCONFIG);
omap_writel() deprecated.
> +}
> +
For readability, this should be a function in the USB core code
(either usb-musb.c or a static inline in <mach/usb.h>)
Kevin
> void omap_sram_idle(void)
> {
> /* Variable to tell what needs to be saved and restored
> @@ -628,6 +640,7 @@ void omap_sram_idle(void)
> omap3_prcm_restore_context();
> omap3_sram_restore_context();
> omap2_sms_restore_context();
> + disable_otg_autoidle();
> }
> omap_uart_resume_idle(0);
> omap_uart_resume_idle(1);
> @@ -1417,6 +1430,7 @@ static int __init omap3_pm_early_init(void)
> OMAP3_PRM_POLCTRL_OFFSET);
>
> configure_vc();
> + disable_otg_autoidle();
>
> return 0;
> }
> --
> 1.5.4.3
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
next prev parent reply other threads:[~2009-10-20 18:44 UTC|newest]
Thread overview: 61+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-10-16 10:48 [PATCH 00/17] Misc PM patches Tero Kristo
2009-10-16 10:48 ` [PATCH 01/17] PM: fix suspend control for IVA2 Tero Kristo
2009-10-16 10:48 ` [PATCH 02/17] OMAP3: PM: Dynamic check for CORE target state Tero Kristo
2009-10-16 10:48 ` [PATCH 03/17] PM: Block CORE off when DSS is active Tero Kristo
2009-10-16 10:48 ` [PATCH 04/17] OMAP3: PM: Do not enable IO wake-up on boot Tero Kristo
2009-10-16 10:48 ` [PATCH 05/17] OMAP:PM: Precedence fix Tero Kristo
2009-10-16 10:48 ` [PATCH 06/17] OMAP3: PM: Added next state check for IVA2, USB and PER into idle loop Tero Kristo
2009-10-16 10:49 ` [PATCH 07/17] OMAP3: Disable Smartreflex before pwrdm enters RET Tero Kristo
2009-10-16 10:49 ` [PATCH 08/17] OMAP2/3: GPTIMER: Clear pending interrupts when entering suspend Tero Kristo
2009-10-16 10:49 ` [PATCH 09/17] OMAP3: PM: Ack pending interrupts before " Tero Kristo
2009-10-16 10:49 ` [PATCH 10/17] OMAP3: PM: Enable system control module autoidle Tero Kristo
2009-10-16 10:49 ` [PATCH 11/17] Make USBHOST powerdomain go to sleep after warm reset Tero Kristo
2009-10-16 10:49 ` [PATCH 12/17] OMAP2/3: Do not enable AUTOIDLE in interrupt controller Tero Kristo
2009-10-16 10:49 ` [PATCH 13/17] OMAP3: Fixed ARM aux ctrl register save/restore Tero Kristo
2009-10-16 10:49 ` [PATCH 14/17] OMAP3: PM: Disabled I2C4 repeated start operation mode Tero Kristo
2009-10-16 10:49 ` [PATCH 15/17] OMAP3: PM: Added support for L2 aux ctrl register save and restore Tero Kristo
2009-10-16 10:49 ` [PATCH 16/17] OMAP3: PM: Write voltage and clock setup times dynamically in idle loop Tero Kristo
2009-10-16 10:49 ` [PATCH 17/17] OMAP3: PM: Force disable OTG autoidle Tero Kristo
2009-10-20 18:44 ` Kevin Hilman [this message]
2009-10-21 10:21 ` Tero.Kristo
2009-10-20 17:47 ` [PATCH 16/17] OMAP3: PM: Write voltage and clock setup times dynamically in idle loop Kevin Hilman
2009-10-21 9:55 ` Tero.Kristo
2009-10-21 14:15 ` Kevin Hilman
2009-10-21 15:37 ` Tero.Kristo
2009-10-16 14:39 ` [PATCH 12/17] OMAP2/3: Do not enable AUTOIDLE in interrupt controller Woodruff, Richard
2009-10-16 17:47 ` Girish S G
2009-10-16 18:04 ` Woodruff, Richard
[not found] ` <005001ca4e8b$ea107c10$3d1018ac@am.dhcp.ti! .com>
2009-10-16 18:10 ` Girish S G
2009-10-19 10:18 ` Tero.Kristo
2009-10-19 17:21 ` Woodruff, Richard
2009-10-19 18:31 ` Girish S G
2009-10-20 16:01 ` Kevin Hilman
2009-10-20 16:15 ` Tero.Kristo
2009-10-20 16:32 ` Kevin Hilman
2009-10-21 4:37 ` Gopinath, Thara
2009-10-21 15:25 ` Girish S G
2009-10-20 16:19 ` Girish S G
2009-10-20 17:39 ` [PATCH 11/17] Make USBHOST powerdomain go to sleep after warm reset Kevin Hilman
2009-10-20 17:30 ` [PATCH 09/17] OMAP3: PM: Ack pending interrupts before entering suspend Kevin Hilman
2009-10-21 10:03 ` Tero.Kristo
2009-10-21 14:19 ` Kevin Hilman
2009-10-21 16:01 ` Tero.Kristo
2009-10-20 17:36 ` [PATCH 08/17] OMAP2/3: GPTIMER: Clear pending interrupts when " Kevin Hilman
2009-10-21 10:09 ` Tero.Kristo
2009-10-16 13:16 ` [PATCH 06/17] OMAP3: PM: Added next state check for IVA2, USB and PER into idle loop Sripathy, Vishwanath
2009-10-16 13:35 ` Tero.Kristo
2009-10-16 14:57 ` Cousson, Benoit
2009-10-20 19:04 ` Kevin Hilman
2009-10-20 17:23 ` [PATCH 05/17] OMAP:PM: Precedence fix Kevin Hilman
2009-10-20 17:21 ` [PATCH 04/17] OMAP3: PM: Do not enable IO wake-up on boot Kevin Hilman
2009-10-16 15:27 ` [PATCH 03/17] PM: Block CORE off when DSS is active Cousson, Benoit
2009-10-19 9:37 ` Tero.Kristo
2009-10-20 17:19 ` Kevin Hilman
2009-10-20 16:16 ` [PATCH 02/17] OMAP3: PM: Dynamic check for CORE target state Kevin Hilman
2009-10-16 17:16 ` [PATCH 01/17] PM: fix suspend control for IVA2 Girish S G
2009-10-19 9:22 ` Tero.Kristo
2009-10-19 18:26 ` Girish S G
2009-10-20 16:10 ` Kevin Hilman
2009-10-22 10:24 ` Paul Walmsley
2009-10-22 21:21 ` Woodruff, Richard
2009-10-23 5:22 ` Artem Bityutskiy
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=87eioxsy5w.fsf@deeprootsystems.com \
--to=khilman@deeprootsystems.com \
--cc=linux-omap@vger.kernel.org \
--cc=tero.kristo@nokia.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox