From: Kevin Hilman <khilman@deeprootsystems.com>
To: Roger Quadros <rogerq@ti.com>
Cc: Jean Pihet <jean.pihet@newoldbits.com>,
tony@atomide.com, paul@pwsan.com, linux-omap@vger.kernel.org,
linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH] perf: Use pre-empt safe cpu_get/put insted of smp_processor_id
Date: Fri, 07 Sep 2012 14:50:32 -0700 [thread overview]
Message-ID: <87k3w5jydz.fsf@deeprootsystems.com> (raw)
In-Reply-To: <50499A5C.60006@ti.com> (Roger Quadros's message of "Fri, 7 Sep 2012 09:55:24 +0300")
Roger Quadros <rogerq@ti.com> writes:
> Hi Jean,
>
> My bad, I didn't follow up with this. My guess is that it has not been
> picked up. Tony, Kevin?
>
Wasn't picked up by me (but should've been, sorry.) Care to refresh
against v3.6-rc4 and resend?
Thanks,
Kevin
>
> On 09/06/2012 09:59 PM, Jean Pihet wrote:
>> Fixed Paul's email address
>>
>> On Thu, Sep 6, 2012 at 8:56 PM, Jean Pihet <jean.pihet@newoldbits.com> wrote:
>>> Hi Roger,
>>>
>>> On Fri, Aug 10, 2012 at 4:05 PM, Roger Quadros <rogerq@ti.com> wrote:
>>>> gets rid of below messages with CONFIG_DEBUG_PREEMPT enabled
>>>>
>>>> [ 28.832916] debug_smp_processor_id: 18 callbacks suppressed
>>>> [ 28.832946] BUG: using smp_processor_id() in preemptible [00000000] code: modprobe/1763
>>>> [ 28.841491] caller is pwrdm_set_next_pwrst+0x54/0x120
>>>>
>>>> Signed-off-by: Roger Quadros <rogerq@ti.com>
>>>
>>> What his the status of the patch? Has it been reviewed and taken in an
>>> integration tree? I cannot find anything about it in l-o and
>>> linux-next.
>>>
>>> I have some changes on-going in the OMAP PM code and I would like to
>>> know if $SUBJECT is applicable.
>>>
>>> Regards,
>>> Jean
>>>
>>>> ---
>>>> arch/arm/mach-omap2/clock.c | 9 ++++++---
>>>> arch/arm/mach-omap2/pm34xx.c | 12 ++++++++----
>>>> arch/arm/mach-omap2/powerdomain.c | 6 ++++--
>>>> 3 files changed, 18 insertions(+), 9 deletions(-)
>>>>
>>>> diff --git a/arch/arm/mach-omap2/clock.c b/arch/arm/mach-omap2/clock.c
>>>> index ea3f565..06747b6 100644
>>>> --- a/arch/arm/mach-omap2/clock.c
>>>> +++ b/arch/arm/mach-omap2/clock.c
>>>> @@ -285,7 +285,8 @@ void omap2_clk_disable(struct clk *clk)
>>>> pr_debug("clock: %s: disabling in hardware\n", clk->name);
>>>>
>>>> if (clk->ops && clk->ops->disable) {
>>>> - trace_clock_disable(clk->name, 0, smp_processor_id());
>>>> + trace_clock_disable(clk->name, 0, get_cpu());
>>>> + put_cpu();
>>>> clk->ops->disable(clk);
>>>> }
>>>>
>>>> @@ -339,7 +340,8 @@ int omap2_clk_enable(struct clk *clk)
>>>> }
>>>>
>>>> if (clk->ops && clk->ops->enable) {
>>>> - trace_clock_enable(clk->name, 1, smp_processor_id());
>>>> + trace_clock_enable(clk->name, 1, get_cpu());
>>>> + put_cpu();
>>>> ret = clk->ops->enable(clk);
>>>> if (ret) {
>>>> WARN(1, "clock: %s: could not enable: %d\n",
>>>> @@ -380,7 +382,8 @@ int omap2_clk_set_rate(struct clk *clk, unsigned long rate)
>>>>
>>>> /* dpll_ck, core_ck, virt_prcm_set; plus all clksel clocks */
>>>> if (clk->set_rate) {
>>>> - trace_clock_set_rate(clk->name, rate, smp_processor_id());
>>>> + trace_clock_set_rate(clk->name, rate, get_cpu());
>>>> + put_cpu();
>>>> ret = clk->set_rate(clk, rate);
>>>> }
>>>>
>>>> diff --git a/arch/arm/mach-omap2/pm34xx.c b/arch/arm/mach-omap2/pm34xx.c
>>>> index e4fc88c..81fec2e 100644
>>>> --- a/arch/arm/mach-omap2/pm34xx.c
>>>> +++ b/arch/arm/mach-omap2/pm34xx.c
>>>> @@ -357,18 +357,22 @@ void omap_sram_idle(void)
>>>>
>>>> static void omap3_pm_idle(void)
>>>> {
>>>> + unsigned cpu;
>>>> +
>>>> local_fiq_disable();
>>>>
>>>> if (omap_irq_pending())
>>>> goto out;
>>>>
>>>> - trace_power_start(POWER_CSTATE, 1, smp_processor_id());
>>>> - trace_cpu_idle(1, smp_processor_id());
>>>> + cpu = get_cpu();
>>>> + trace_power_start(POWER_CSTATE, 1, cpu);
>>>> + trace_cpu_idle(1, cpu);
>>>>
>>>> omap_sram_idle();
>>>>
>>>> - trace_power_end(smp_processor_id());
>>>> - trace_cpu_idle(PWR_EVENT_EXIT, smp_processor_id());
>>>> + trace_power_end(cpu);
>>>> + trace_cpu_idle(PWR_EVENT_EXIT, cpu);
>>>> + put_cpu();
>>>>
>>>> out:
>>>> local_fiq_enable();
>>>> diff --git a/arch/arm/mach-omap2/powerdomain.c b/arch/arm/mach-omap2/powerdomain.c
>>>> index 69b36e1..138bf86 100644
>>>> --- a/arch/arm/mach-omap2/powerdomain.c
>>>> +++ b/arch/arm/mach-omap2/powerdomain.c
>>>> @@ -169,7 +169,8 @@ static int _pwrdm_state_switch(struct powerdomain *pwrdm, int flag)
>>>> ((state & OMAP_POWERSTATE_MASK) << 8) |
>>>> ((prev & OMAP_POWERSTATE_MASK) << 0));
>>>> trace_power_domain_target(pwrdm->name, trace_state,
>>>> - smp_processor_id());
>>>> + get_cpu());
>>>> + put_cpu();
>>>> }
>>>> break;
>>>> default:
>>>> @@ -491,7 +492,8 @@ int pwrdm_set_next_pwrst(struct powerdomain *pwrdm, u8 pwrst)
>>>> if (arch_pwrdm && arch_pwrdm->pwrdm_set_next_pwrst) {
>>>> /* Trace the pwrdm desired target state */
>>>> trace_power_domain_target(pwrdm->name, pwrst,
>>>> - smp_processor_id());
>>>> + get_cpu());
>>>> + put_cpu();
>>>> /* Program the pwrdm desired target state */
>>>> ret = arch_pwrdm->pwrdm_set_next_pwrst(pwrdm, pwrst);
>>>> }
>>>> --
>>>> 1.7.4.1
>>>>
>
> --
> To unsubscribe from this list: send the line "unsubscribe linux-omap" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at http://vger.kernel.org/majordomo-info.html
prev parent reply other threads:[~2012-09-07 21:50 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-08-10 14:05 [PATCH] perf: Use pre-empt safe cpu_get/put insted of smp_processor_id Roger Quadros
2012-09-06 18:56 ` Jean Pihet
2012-09-06 18:59 ` Jean Pihet
2012-09-07 6:55 ` Roger Quadros
2012-09-07 21:50 ` Kevin Hilman [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=87k3w5jydz.fsf@deeprootsystems.com \
--to=khilman@deeprootsystems.com \
--cc=jean.pihet@newoldbits.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-omap@vger.kernel.org \
--cc=paul@pwsan.com \
--cc=rogerq@ti.com \
--cc=tony@atomide.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox