No OMAP PM code on the PM branch???

No OMAP PM code on the PM branch???

[Peter Barada]

I'm looking through Kevin's PM branch, and I've done a quick-port of
2.6.30-rc1 to Logic's OMAP3530 LV SOM starting with the rk21 board code,
and "echo mem > /sys/power/state" does nothing.  Worse,
"cat /sys/power/state" doesn't show anything.

This is due to no code calling suspend_set_ops() which used to be in
arch/arm/mach-omap2/pm34xx.c - this isn't in either Tony or Kevin's
current tree.

1) Am I way off base (i.e. am I missing something obvious here)?

-- 
Peter Barada <peterb@logicpd.com>

Re: No OMAP PM code on the PM branch???

[Eugeny S. Mints]

Peter,

Peter Barada wrote:
> I'm looking through Kevin's PM branch, and I've done a quick-port of
> 2.6.30-rc1 to Logic's OMAP3530 LV SOM starting with the rk21 board code,
> and "echo mem > /sys/power/state" does nothing.  Worse,
> "cat /sys/power/state" doesn't show anything.
>
> This is due to no code calling suspend_set_ops() which used to be in
> arch/arm/mach-omap2/pm34xx.c - this isn't in either Tony or Kevin's
> current tree.
>
> 1) Am I way off base (i.e. am I missing something obvious here)?
>   
check out Kevin's email "Re: n800 high idle power consumption" on 4/24 
on this list. TBH
I haven't checked pm branch recently so have no idea if re-basing is 
complete and if it
causes the issue you found.

Thanks,
Eugeny

Re: No OMAP PM code on the PM branch???

[Kevin Hilman]

Peter Barada <peterb@logicpd.com> writes:

> I'm looking through Kevin's PM branch, and I've done a quick-port of
> 2.6.30-rc1 to Logic's OMAP3530 LV SOM starting with the rk21 board code,
> and "echo mem > /sys/power/state" does nothing.  Worse,
> "cat /sys/power/state" doesn't show anything.

Since 2.6.30, there is no OMAP PM code in linux-omap master branch.
The only working PM is now in the PM branch.

I am currently rebasing the PM branch to 2.6.30-rc series and it
should be published this week.

Kevin