Re: [PATCH v2] DSPBRIDGE: use dm timer framework for gpt timers

[Kevin Hilman <khilman@deeprootsystems.com>]

Nishanth Menon <nm@ti.com> writes:

> Kevin Hilman had written, on 04/28/2010 12:59 PM, the following:
>> Omar Ramirez Luna <omar.ramirez@ti.com> writes:
>>
>>> On 4/28/2010 11:36 AM, Menon, Nishanth wrote:
>>>> Kevin Hilman had written, on 04/28/2010 11:29 AM, the following:
>>>>> Omar Ramirez Luna<omar.ramirez@ti.com>  writes:
>>>>>
>>>>>> On 4/28/2010 2:46 AM, Felipe Contreras wrote:
>>>>>>> On Wed, Apr 28, 2010 at 4:29 AM, Omar Ramirez Luna<omar.ramirez@ti.com>   wrote:
>>>>>>>> This patch switches to use DM timer framework instead of
>>>>>>>> a custom one for GPT timers, currently dsp can make use of
>>>>>>>> gpt 5, 6, 7 or 8.
>>>>>>> I heard someone that was using gpt 8 for something else. Is it
>>>>>>> possible to configure dsp-bridge to not use it?
>>>>>>>
>>>>>> There are two scenarios:
>>>>>>
>>>>>> 1. The request comes from the DSP side (afaik for video use case), the
>>>>>> change should be in the DSP side binaries to request some other gpt
>>>>>> instead. I don't know how possible is to get this changed.
>>>>>>
>>>>>> 2. bridge driver also requests gpt8 whenever a mmu fault is triggered,
>>>>>> this to set a timer to interrupt the dsp after the mmu fault dump has
>>>>>> been finished, I think this can be easily replaced in bridge to use
>>>>>> some other gpt, but "1" is still there. (besides a new patch is needed
>>>>>> to remove direct access to dm timer inside ue_deh and make it to go
>>>>>> through dsp-clock)
>>>>> Why does Bridge care at all which specific timers it requests?  They
>>>>> are all the same, with the exception of GPT1 which is in the WKUP
>>>>> powerdomain and already used as the kernel clocksource.
>>>>>
>>>>> Bridge should just use the generic _request() instead of
>>>>> _request_specific()
>>>>>
>>>> trouble I believe is that DSP BIOS uses a specific timer.
>>>>
>>> yes, dsp side wants:
>>> bios --> GPT5 (only used during boot up -> baseimage load)
>>> load monitoring --> GPT 6 (used while the dsp is awake)
>>> AV Sync --> GPT 8 (based on use case)
>>>
>>> to generate the interrupt for mmu fault case it needs one connected to
>>> the dsp interrupt line and only 5, 6, 7 or 8 apply.
>>
>> Then DSP bios is broken by hard-coding *general purpose* timers.
>  /me just eats my own words.
> Not really.. I just got educated internally that DSP does not get
> interrupts from all GPTs.
> Ref: http://focus.ti.com/pdfs/wtbu/SWPU114Q_PrelimFinal_EPDF_03_05_2009.pdf
> page 1753 -> only mentioned these timers can generate interrupts for
> DSP, and hence for BIOS's usage. 

OK, now that part makes sense.

Kevin