messages from 2008-11-27 00:05:55 to 2008-12-01 21:54:35 UTC [more...]
[patch 2.6.28-rc6-omap-git 3/5] add missing otg_put_transceiver() call
2008-12-01 21:17 UTC
[patch 2.6.28-rc6-omap-git 2/5] add new gpio_vbus "transceiver"
2008-12-01 21:16 UTC
[patch 2.6.28-rc6-omap-git 1/5] move drivers/i2c/chips/isp1301-omap.c
2008-12-01 21:15 UTC
[patch 2.6.28-rc6-omap-git 0/5] drivers/usb/otg seeding
2008-12-01 21:11 UTC
Resending: OMAP3 GPIO fixes for off-mode
2008-12-01 19:26 UTC (4+ messages)
` [PATCH] OMAP3: "
[PULL] http://www.linuxtv.org/hg/~hverkuil/v4l-dvb
2008-12-01 18:43 UTC (3+ messages)
[PULL] http://www.linuxtv.org/hg/~hverkuil/v4l-dvb-ng
2008-12-01 18:07 UTC (11+ messages)
RFC: [PATCH] Change VDD2 setopp to use bus throughput
2008-12-01 17:18 UTC
[PATCH] fix a pile of OMAP issues
2008-12-01 17:01 UTC (2+ messages)
[PATCH 0/1] OMAP3: DMA: Enable idlemodes for DMA OCP
2008-12-01 17:03 UTC (5+ messages)
` [PATCH 1/1] "
[PATCH v2 0/5] extra module resets to ensure full-chip idle
2008-12-01 16:36 UTC (7+ messages)
` [PATCH v2 1/5] OMAP3: PM: HSMMC: force MMC module reset on boot
` [PATCH v2 2/5] OMAP3: PM: Force IVA2 into idle during bootup
` [PATCH v2 3/5] OMAP3: PM: Add D2D clocks and auto-idle setup to PRCM init
` [PATCH v2 4/5] OMAP3: PM: D2D clockdomain supports SW supervised transitions
` [PATCH v2 5/5] OMAP3: PM: Ensure modem is reset during PRCM init
[ANNOUNCE] new PM branch: pm-20081119
2008-12-01 16:22 UTC (9+ messages)
[PATCH] OMAP3: PM: Prevent PER from going OFF when CORE is going INA
2008-12-01 15:53 UTC (2+ messages)
[PATCH PM 1/1] OMAP3:PM: Update SSI omapdev record
2008-12-01 14:24 UTC
[PATCH] Add OMAP2 camera driver
2008-12-01 13:34 UTC (10+ messages)
[PATCH] Add Omnivision OV9640 sensor support
2008-12-01 12:51 UTC (3+ messages)
[PATCH] OMAP2/3 clock: fix DPLL rate calculation
2008-12-01 7:43 UTC
[PATCH 0/5] extra module resets to ensure full-chip idle
2008-12-01 7:42 UTC (12+ messages)
` [PATCH 1/5] OMAP3: PM: HSMMC: force MMC module reset on boot
` [PATCH 2/5] OMAP3: PM: Force IVA2 into idle during bootup
` [PATCH 3/5] OMAP3: PM: Add D2D clocks and auto-idle setup to PRCM init
` [PATCH 4/5] OMAP3: PM: D2D clockdomain supports SW supervised transitions
` [PATCH 5/5] OMAP3: PM: Ensure modem is reset during PRCM init
[PATCH] OMAP2 STI: fix build breakage
2008-12-01 7:28 UTC
[PATCH 0/3] OMAP: PM: enable UART clock disabling when idle
2008-12-01 6:07 UTC (9+ messages)
` [PATCH 1/3] OMAP3: PM: Add wake-up bit defintiions for CONTROL_PADCONF_X
` [PATCH 2/3] OMAP3: PM: UART: disable clocks when idle
` [PATCH 3/3] OMAP3: PM: UART save/restore support for OFF-mode
[PATCH v2] v4l2_device/v4l2_subdev: final (?) version
2008-12-01 5:34 UTC (11+ messages)
v4l2_device/v4l2_subdev: please review
2008-11-30 21:40 UTC (10+ messages)
` v4l2_device/v4l2_subdev: please review (PATCH 1/3)
[PATCH 00/12] Updates for i2c-omap for 2.6.29 merge window, v5
2008-11-29 1:56 UTC (14+ messages)
` [PATCH 01/12] i2c-omap: Do not use interruptible wait call in omap_i2c_xfer_msg
` [PATCH 02/12] i2c-omap: Close suspected race between omap_i2c_idle() and omap_i2c_isr()
` [PATCH 03/12] i2c-omap: Add high-speed support to omap-i2c
` [PATCH 04/12] i2c-omap: FIFO handling support and broken hw workaround for i2c-omap
` [PATCH 05/12] i2c-omap: Add support for omap34xx
` [PATCH 06/12] i2c-omap: Mark init-only functions as __init
` [PATCH 07/12] i2c-omap: Don't compile in OMAP15xx I2C ISR for non-OMAP15xx builds
` [PATCH 08/12] i2c-omap: Clean-up i2c-omap
` [PATCH 09/12] i2c-omap: fix I2C timeouts due to recursive omap_i2c_{un, }idle()
` [PATCH 10/12] i2c-omap: convert 'rev1' flag to generic 'rev' u8
` [PATCH 11/12] i2c-omap: reprogram OCP_SYSCONFIG register after reset
` [PATCH 12/12] i2c-omap: Enable I2C wakeups for 34xx
` git-pull request for i2c-omap updates (Re: [PATCH 00/12] Updates for i2c-omap for 2.6.29 merge window, v5)
[PATCH 00/11] Omap gpio updates for review for 2.6.29 merge window
2008-11-29 1:35 UTC (13+ messages)
` [PATCH 01/11] ARM: OMAP: Enable GPIO debounce clock only when debounce is enabled v3
` [PATCH 02/11] ARM: OMAP: Extend gpio label column width in omap_gpio debugfs file
` [PATCH 03/11] ARM: OMAP: gpios implement new to_irq()
` [PATCH 04/11] ARM: OMAP: switch to standard gpio get/set calls
` [PATCH 05/11] ARM: OMAP: switch to gpio_direction_input
` [PATCH 06/11] ARM: OMAP: switch to gpio_direction_output
` [PATCH 07/11] ARM: OMAP: use gpio_to_irq
` [PATCH 08/11] ARM: OMAP: make legacy gpio request/free calls superfluous
` [PATCH 09/11] ARM: OMAP: minor gpio bugfixes
` [PATCH 10/11] ARM: OMAP: Switch to gpio_request/free calls
` [PATCH 11/11] ARM: OMAP: Switch ohci-omap "
[PATCH 00/12] Updates for i2c-omap for 2.6.29 merge window, v5
2008-11-29 1:32 UTC
[PATCH 00/12] Updates for i2c-omap for 2.6.29 merge window, v4
2008-11-29 1:31 UTC (14+ messages)
` [PATCH 01/12] i2c-omap: Do not use interruptible wait call in omap_i2c_xfer_msg
` [PATCH 02/12] i2c-omap: Close suspected race between omap_i2c_idle() and omap_i2c_isr()
` [PATCH 03/12] i2c-omap: Add high-speed support to omap-i2c
` [PATCH 04/12] i2c-omap: FIFO handling support and broken hw workaround for i2c-omap
` [PATCH 05/12] i2c-omap: Add support for omap34xx
` [PATCH 06/12] i2c-omap: Mark init-only functions as __init
` [PATCH 07/12] i2c-omap: Don't compile in OMAP15xx I2C ISR for non-OMAP15xx builds
` [PATCH 08/12] i2c-omap: Clean-up i2c-omap
` [PATCH 09/12] i2c-omap: fix I2C timeouts due to recursive omap_i2c_{un, }idle()
` [PATCH 10/12] i2c-omap: convert 'rev1' flag to generic 'rev' u8
` [PATCH 11/12] i2c-omap: reprogram OCP_SYSCONFIG register after reset
` [PATCH 12/12] i2c-omap: Enable I2C wakeups for 34xx
[PATCH 2/2] TVP514x Driver with Review comments fixed
2008-11-28 19:54 UTC (8+ messages)
[PATCH 3/3] musb: Remvoing twl4030 dependency for OMAP3EVM MUSB
2008-11-28 19:43 UTC (10+ messages)
[PATCH 2/3] TPS6235x drivers added in drivers/i2c/chips
2008-11-28 16:08 UTC (4+ messages)
[PATCH 1/2] Add Input/Output related ioctl support
2008-11-28 12:43 UTC
[PATCH] OMAP IrDA driver
2008-11-28 11:25 UTC
[PATCH 1/3] Adding-support-framework for PR785 board
2008-11-28 11:17 UTC (8+ messages)
[PATCH 1/1] Adding support for NAND partitions in OMAP3 EVM
2008-11-28 5:36 UTC
PATCH[0/3] - Framework for TPS device drivers on PR785 power
2008-11-28 5:31 UTC
PATCH[0/3] - Framework for TPS device drivers on PR785 power
2008-11-28 5:26 UTC
[PATCH] Provide the set_power at TWL4030 MMC
2008-11-27 17:12 UTC (2+ messages)
[PATCHv2 0/1] OMAP_TWL4030 SoC Audio driver
2008-11-27 15:56 UTC (5+ messages)
` [alsa-devel][PATCHv2 1/1] "
` [alsa-devel] [PATCHv2 "
` "
[PATCHv2 0/3] OMAP_LDP support in linux-git tree
2008-11-27 15:40 UTC (5+ messages)
` [PATCH 1/2] OMAP: Add OMAP_LDP platform support
` [PATCH 2/2] OMAP: Support LCD display as a FB device on ZOOM MDK
[PATCH 02/10] omap mailbox: add initial omap3 support
2008-11-27 14:39 UTC (4+ messages)
[PATCH] OMAP general SOC driver
2008-11-27 12:39 UTC (11+ messages)
[PATCH] OMAP3: GPIO fixes for off-mode
2008-11-27 11:54 UTC
OMAP VRAM patch set intro
2008-11-27 10:36 UTC (4+ messages)
` [PATCH] OMAP: Add a Video RAM manager
` [PATCH] OMAP: Change OMAPFB to use the VRAM manager
` [PATCH] OMAP3 SDP: example use of OMAP VRAM
[PATCH 1/2] Add support for GPIO LEDs on pandora
2008-11-27 10:02 UTC (2+ messages)
` [PATCH 2/2] Enable LEDs in pandora defconfig
[PATCH] i2c: i2c-omap: Fix standard and fast mode prescalers
2008-11-27 8:38 UTC (2+ messages)
[PATCH 1/9] OMAP: HSMMC: Make driver support dynamic idle
2008-11-27 8:43 UTC (3+ messages)
[PATCH 3/9] OMAP: HSMMC: Make fclk disable request driven
2008-11-27 8:40 UTC (3+ messages)
ARM : OMAP: Pass logical DMA channel number always to callback handlers
2008-11-27 7:30 UTC (5+ messages)
[patch 2.6.28-rc6-omap-git 1/2] twl4030-usb: cleanup debug code
2008-11-27 0:44 UTC
[patch 2.6.28-rc6-omap-git 2/2] twl4030-usb: get rid of OMAP1 OTG hooks
2008-11-27 0:44 UTC
[PATCH] 8250: Allow platform to register PM hook
2008-11-27 0:25 UTC (2+ messages)
` [PATCH] 8250: when waking, PM hook should be called before accessing port
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox