messages from 2009-06-24 13:21:28 to 2009-07-01 00:51:21 UTC [more...]
[PATCH] OMAP3: SR: Wait for VP idle before a VP disable
2009-07-01 0:51 UTC (2+ messages)
[ARM][OMAP] TWL4030 IRQ
2009-06-30 23:05 UTC (10+ messages)
[PATCH 1/2] OMAP3: PM: Configure PRM setup times from board files
2009-06-30 22:58 UTC (5+ messages)
` [PATCH 2/2] OMAP3: PM: Configure CPUidle latencies/thresholds "
[PATCH 01/04] OMAP3: PM: Disable PER DPLL idle before OFF, reduces OFF latency by 20ms
2009-06-30 22:32 UTC (5+ messages)
[PATCH 0/4] driver updates from PM branch for upstream
2009-06-30 16:49 UTC (14+ messages)
` [PATCH 1/4] OMAP: McSPI: enable wake-ups and smart-idle
` [PATCH 2/4] OMAP: McSPI: Convert bit shifted values into BIT format
` [PATCH 3/4] OMAP3 McSPI: Adds context save/restore
` [PATCH 4/4] I2C: OMAP3: PM: (re)init for every transfer to support off-mode
[PATCH] [RFC] ASoC: OMAP: fix OMAP1510 broken PCM pointer callback
2009-06-30 9:39 UTC (9+ messages)
` [alsa-devel] "
Raju Sana wants to chat
2009-06-30 8:44 UTC
[PATCH] OMAP3: PM: Move the clk stabilization delay to the right place
2009-06-29 23:16 UTC (2+ messages)
[PATCH 01/04] OMAP3: PM: Disable PER DPLL idle before OFF, reduces OFF latency by 20ms
2009-06-29 22:29 UTC (6+ messages)
` [PATCH 02/04] OMAP3: PM: Prevent AUTO_RET and AUTO_OFF being enabled simultaneously
` [PATCH 03/04] OMAP3: PM: Fix I2C voltage levels send to T2 for different Power modes
` [PATCH 04/04] OMAP3: PM: Update sleep/wakeup sequence and device grp associations
[PATCH 02/04] OMAP3: PM: Prevent AUTO_RET and AUTO_OFF being enabled simultaneously
2009-06-29 21:45 UTC (2+ messages)
[PATCH][RFC] OMAP3: PM: Prevent hang in prcm_interrupt_handler
2009-06-29 21:11 UTC (5+ messages)
get_irq_regs() from soft IRQ
2009-06-29 19:45 UTC (16+ messages)
[PATCH]OMAP4: McSPI Support for OMAP_4430
2009-06-29 17:58 UTC (2+ messages)
Can a phone hook switch follow alsa jack model?
2009-06-29 16:35 UTC (7+ messages)
` [alsa-devel] "
[PATCH 0/2] OMAP3: PM: Make PRM setup times and CPUidle latencies/threshold board specific
2009-06-29 14:34 UTC
[PATCH v2] OMAP2/3: DMA errata correction
2009-06-29 13:08 UTC
[PATCH] OMAP2/3: DMA errata correction
2009-06-29 12:59 UTC (3+ messages)
[PATCH v2] usb: musb: Warn and check for OTG transceiver misconfiguration
2009-06-29 9:06 UTC
musb Rx DMA (Mentor) failure when one DMA receive is started before the previous completes (??)
2009-06-29 4:51 UTC (3+ messages)
[RFC/PATCH 0/3] omap3-iommu: cleanups and remote registration
2009-06-28 0:18 UTC (5+ messages)
Approved Award Winner
2009-06-27 17:19 UTC
v4l2_int_device vs v4l2_subdev?
2009-06-27 12:58 UTC (5+ messages)
[PATCH -pm] OMAP3: GPIO: Only enable WAKEUPEN for edge detection GPIOs
2009-06-27 3:52 UTC (2+ messages)
[PATCH v5 0/2] watchdog:OMAP3:Add support for IVA2, SECURE WDTs
2009-06-26 21:24 UTC (5+ messages)
` [PATCH v5 1/2] watchdog:OMAP3:Register IVA and SECURE WDT, make clks ac
` [PATCH v5 2/2] watchdog:OMAP3:Enable support for IVA2 and SECURE
RFC: Reclaim address space on omaps, Tony on vacation in July
2009-06-26 21:21 UTC (8+ messages)
` "
[PATCH -pm 0/2] SDRC tweaks for stuck DLL state machine
2009-06-26 16:07 UTC (10+ messages)
` [PATCH -pm 1/2] SDRC: check for stuck DLL state machine and kick
[PATCH 1/2] Support OMAP3 VC adaptation with different Power IC
2009-06-26 14:57 UTC (2+ messages)
[PATCH] OMAP3: RX51: Updated rx51_defconfig
2009-06-26 13:24 UTC
[PATCH] usb: musb: Check for NULL pointers when no OTG transceiver used
2009-06-26 13:23 UTC
[PATCH 1/1] ARM TCM (Tightly-Coupled Memory) support v1
2009-06-26 10:43 UTC
[PATCH 0/1] ARM TCM (Tightly-Coupled Memory) support v1
2009-06-26 10:43 UTC
[PATCH 0/2] fixup merge mistakes in l-o master
2009-06-26 9:13 UTC (5+ messages)
` [PATCH 1/2] OMAP3: Kconfig: remove duplicate board entries
` [PATCH 2/2] OMAP3: omap3evm: undo ehci change to board-omap3evm.c
` [APPLIED] "
` [APPLIED] [PATCH 1/2] OMAP3: Kconfig: remove duplicate board entries
[PATCH] [RFC] OMAP4: sDMA: Update the request lines and new registers
2009-06-26 6:52 UTC (5+ messages)
[PATCH] OMAP: update OMAP3 Beagle defconfig
2009-06-26 5:58 UTC
[RESUBMIT][PATCH][RFC] OMAP4: McSPI Support for OMAP_4430
2009-06-26 5:52 UTC (5+ messages)
marc info dead?
2009-06-26 1:20 UTC (3+ messages)
[PATCH 2/2] OMAP3: Implement separate function to send bypass command through VC
2009-06-25 23:56 UTC
[PATCH v2 0/3] OMAP2/3 clock: fix module IDLEST code for unusual devs
2009-06-25 23:38 UTC (4+ messages)
` [PATCH v2 1/3] OMAP2/3 clock: split, rename omap2_wait_clock_ready()
` [PATCH v2 2/3] OMAP2 clock: 2430 I2CHS uses non-standard CM_IDLEST register
` [PATCH v2 3/3] OMAP3 clock: correct module IDLEST bits: SSI; DSS; USBHOST; HSOTGUSB
[PATCH 1/2] Support OMAP3 VC adaptation with different Power IC
2009-06-25 21:18 UTC (6+ messages)
[PATCH 1/2] Support OMAP3 VC adaptation with different Power IC
2009-06-25 20:10 UTC (4+ messages)
[PATCH v2 1/1] i2c:OMAP3:Errata workaround for spurious RDR event
2009-06-25 18:45 UTC (10+ messages)
[PATCH 00/11] OMAP fixes from PM branch for .31-rc
2009-06-25 17:17 UTC (14+ messages)
` [PATCH 01/11] OMAP: SDRC: Add several new register definitions
` [PATCH 02/11] OMAP2/3: PM: make PM __init calls static
` [PATCH 03/11] OMAP3: PM: CM_REGADDR macros using wrong name
` [PATCH 04/11] OMAP3: PM: Ensure PRCM interrupts are cleared at boot
` [PATCH 05/11] OMAP3: PM: Clear pending PRCM reset flags on init
` [PATCH 06/11] OMAP3: PM: prevent module wakeups from waking IVA2
` [PATCH 07/11] OMAP3: PM: Do not build suspend code if SUSPEND is not enabled
` [PATCH 08/11] OMAP3: PM: reset USB OTG module on boot
` [PATCH 09/11] OMAP4: UART: cleanup special case IRQ handling
` [PATCH 10/11] OMAP3: Fixed crash bug with serial + suspend
` [PATCH 11/11] OMAP2/3/4: UART: Allow per-UART disabling wakeup for serial ports
` [PATCH 12/11] OMAP: PM: CPUfreq: obey min/max settings of policy
[PATCH] [RFC][OMAP3:I2C]Workaround for OMAP3430 I2C silicon errata 1.153
2009-06-25 17:17 UTC (5+ messages)
bootarg mpurate is ignored
2009-06-25 17:06 UTC
[PATCH] OMAP: PM: Correct the use of cpufreq
2009-06-25 16:48 UTC (2+ messages)
[PATCH -pm v5] OMAP3: PM: reset USB OTG module on boot
2009-06-25 14:55 UTC
git tree
2009-06-25 14:40 UTC (4+ messages)
[PATCH v2] serial: 8250: add IRQ trigger support
2009-06-25 13:19 UTC (2+ messages)
About DSS2 in Kevin's l-o PM tree
2009-06-25 13:08 UTC
[PATCH 00/12] Omap fixes for 2.6.31
2009-06-25 12:35 UTC (3+ messages)
` Git pull request for omap-fixes for 2.6.31 (Re: [PATCH 00/12] Omap fixes for 2.6.31)
[ANNOUNCE] TI dspbridge Omapzoom tree
2009-06-25 10:33 UTC (4+ messages)
[PATCH] I2C:OMAP: fix status ack
2009-06-25 7:40 UTC
[PATCH] OMAP2/3 SDRC: don't set SDRC_POWER.PWDENA on boot
2009-06-25 7:11 UTC
[PATCH v2] OMAP3: PM: reset USB OTG module on boot
2009-06-25 6:28 UTC (7+ messages)
[PATCH v4] OMAP2/3/4: PM: reset USB OTG module on boot
2009-06-24 22:27 UTC (2+ messages)
[PATCH v3] OMAP2/3/4: PM: reset USB OTG module on boot
2009-06-24 21:08 UTC (3+ messages)
[PATCH 00/07] pm: remove late/early platform driver pm callbacks V2
2009-06-24 20:34 UTC (8+ messages)
` [PATCH 06/07] usb: rework musb suspend()/resume_early()
` [PATCH 07/07] pm: remove platform device suspend_late()/resume_early() V2
[RFC][PATCH] Add support for hook switch on ams-delta
2009-06-24 14:36 UTC (7+ messages)
` [APPLIED] "
[PATCH] OMAP3: PM: reset USB OTG module on boot
2009-06-24 14:09 UTC (6+ messages)
[PATCH] Missing implementation of omap3evm_flash_init()
2009-06-24 13:42 UTC (7+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox