messages from 2009-10-16 11:04:15 to 2009-10-20 16:33:44 UTC [more...]
[PATCH] OMAP: timekeeping: time should not stop during suspend
2009-10-20 16:33 UTC (3+ messages)
[PATCH 00/17] Misc PM patches
2009-10-20 16:32 UTC (39+ messages)
` [PATCH 01/17] PM: fix suspend control for IVA2
` [PATCH 02/17] OMAP3: PM: Dynamic check for CORE target state
` [PATCH 03/17] PM: Block CORE off when DSS is active
` [PATCH 04/17] OMAP3: PM: Do not enable IO wake-up on boot
` [PATCH 05/17] OMAP:PM: Precedence fix
` [PATCH 06/17] OMAP3: PM: Added next state check for IVA2, USB and PER into idle loop
` [PATCH 07/17] OMAP3: Disable Smartreflex before pwrdm enters RET
` [PATCH 08/17] OMAP2/3: GPTIMER: Clear pending interrupts when entering suspend
` [PATCH 09/17] OMAP3: PM: Ack pending interrupts before "
` [PATCH 10/17] OMAP3: PM: Enable system control module autoidle
` [PATCH 11/17] Make USBHOST powerdomain go to sleep after warm reset
` [PATCH 12/17] OMAP2/3: Do not enable AUTOIDLE in interrupt controller
` [PATCH 13/17] OMAP3: Fixed ARM aux ctrl register save/restore
` [PATCH 14/17] OMAP3: PM: Disabled I2C4 repeated start operation mode
` [PATCH 15/17] OMAP3: PM: Added support for L2 aux ctrl register save and restore
` [PATCH 16/17] OMAP3: PM: Write voltage and clock setup times dynamically in idle loop
` [PATCH 17/17] OMAP3: PM: Force disable OTG autoidle
24xx/n8x0 booting again, linux-omap updated to -rc5
2009-10-20 16:31 UTC (3+ messages)
[RFC][Patch] OMAP3 PM: sysfs vdd_opp change to use Constraint Framework
2009-10-20 15:51 UTC (3+ messages)
[PATCH v3 2/2] OMAP3: PM: Configure CPUidle latencies/thresholds from board file
2009-10-20 15:46 UTC (2+ messages)
[PATCH v2 1/2] OMAP3: PM: Configure PRM setup times from board files
2009-10-20 15:46 UTC (2+ messages)
[PATCH 0/2] OMAP3: introduce DPLL4 Jtype
2009-10-20 14:50 UTC (6+ messages)
` [PATCH 1/2] OMAP3: move check_revision above check_features
` [PATCH 2/2] OMAP3:clk: introduce DPLL4 jtype support
OMAP2420-HS flashing question
2009-10-20 14:28 UTC (5+ messages)
[Resend PATCH 1/2] twl4030: Do not dereference null pointer in error path
2009-10-20 13:22 UTC (2+ messages)
` [Resend PATCH 2/2] twl4030: Enable low-power mode to 32kHz oscillator
[PATCH 1/2] twl4030: Do not dereference null pointer in error path
2009-10-20 13:19 UTC (4+ messages)
[PATCH 0/4] twl4030 codec as MFD device
2009-10-20 12:01 UTC (13+ messages)
` [PATCH 1/4] MFD: twl4030: add twl4030_codec MFD as a new child to the core
` [PATCH 2/4] OMAP: Platform support for twl4030_codec MFD
` [PATCH 3/4] ASoC: TWL4030: Only update the needed bits in *set_dai_sysclk
` [PATCH 4/4] ASoC: TWL4030: Driver registration via twl4030_codec MFD
[PATCH 1/5] mfd: twl4030-power: Rename DEVGROUP to DEV_GRP
2009-10-20 9:22 UTC (13+ messages)
` [PATCH 2/5] mfd: twl4030-power: Add comments for the register and bit layout
` [PATCH 3/5] mfd: twl4030-power: Move power-related data closer together in the header file
` [PATCH 4/5] mfd: twl4030-power: Add support for remapping power states
` [PATCH 5/5] mfd: twl4030-power: Optimised power scripts for the rx51
[PATCH V2] FIX OMAP3:McBSP poll read and write for OMAP3
2009-10-20 6:41 UTC
[PATCH 00/14] Use ioremap for omap, split OMAP2_IO_ADDRESS for more space
2009-10-20 6:34 UTC (30+ messages)
` [PATCH 01/14] omap: Change low-level serial init to use ioremap
` [PATCH 02/14] omap: Use ioremap in irq.c
` [PATCH 03/14] omap: Use ioremap in dma.c
` [PATCH 04/14] omap: Use ioremap in dmtimer.c
` [PATCH 05/14] omap: Use ioremap in gpio.c
` [PATCH 06/14] omap: Use ioremap in omap_hwmod.c
` [PATCH 07/14] omap: Use getnstimeofday for omap_device
` [PATCH 08/14] omap: Use ioremap for omap4 L4 code
` [PATCH 09/14] omap: Use ioremap in dispc.c
` [PATCH 10/14] omap: Split OMAP2_IO_ADDRESS to L3 and L4
` [PATCH 11/14] omap: Remap L3, L4 to get more kernel io address space
` [PATCH 12/14] omap: Move SRAM map to claim more io space
` [PATCH 13/14] omap: Fix DEBUG_LL UART io address
` [PATCH 14/14] omap: Add OMAP4 L3 and L4 peripherals
[PATCH v2] ARM: OMAP: SDMA: Fix omap_stop_dma() API for channel linking
2009-10-20 6:29 UTC (3+ messages)
[PATCH 0/2 v2] ARM: OMAP3: add support for cm-t35 board
2009-10-20 6:27 UTC (6+ messages)
` [PATCH 1/2] ARM: OMAP3: add CompuLab CM-T35 module
MMC_CAP_SDIO_IRQ for omap 3430
2009-10-20 4:47 UTC (28+ messages)
[PATCH] omap: 3630: update is_chip variable
2009-10-19 23:47 UTC (4+ messages)
Plat header changes merged, script to convert existing patches
2009-10-19 23:15 UTC
[PATCH 0/1] dying serial console in PM branch
2009-10-19 23:04 UTC (4+ messages)
` [PATCH 1/1] OMAP3: PM: enable UART3 module wakeups
` [APPLIED] "
OMAP3 <-> FPGA boot-delay
2009-10-19 20:44 UTC
[PATCH v2 1/2] arm: a driver for on-chip ETM and ETB
2009-10-19 20:32 UTC (4+ messages)
stable kernel version
2009-10-19 17:40 UTC (14+ messages)
[PATCH] ARM: OMAP4: Fix UART4 platform data
2009-10-19 17:28 UTC (2+ messages)
` [APPLIED] "
[PATCH] ARM: OMAP4: Allow omap_serial_early_init() for OMAP4430 board
2009-10-19 17:25 UTC (2+ messages)
` [APPLIED] [PATCH] ARM: OMAP4: Allow omap_serial_early_init() for OMAP4430
Bug on "omap: ioremap fixes for omap4"
2009-10-19 17:12 UTC (2+ messages)
[PATCH 0/8] RX-51 audio drivers
2009-10-19 9:24 UTC (17+ messages)
` [PATCH 5/8] board-rx51-peripherals: split vaux3 and vmmc2 supplies
` [PATCH 6/8] RX-51: Audio: Add usage of regulator framework to control VMMC2
hrtimer_nanosleep() weirdness
2009-10-17 7:53 UTC (2+ messages)
[PATCH 12/14] arch/arm/plat-omap: Drop an unnecessary NULL test
2009-10-17 6:42 UTC
[PATCH] CPUidle: always return with interrupts enabled
2009-10-16 21:11 UTC (5+ messages)
[PATCH] omapfb: Wrong test on unsigned?
2009-10-16 20:56 UTC (2+ messages)
Patches merged to split OMAP2_IO_ADDRESS
2009-10-16 16:42 UTC (5+ messages)
` [PATCH] omap: Use ioremap for omap_hwmod instead of OMAP2_IO_ADDRESS
` [PATCH] omap: Use getnstimeofday for omap_device
[PATCH] OMAP3: PM: Removing redundant and potentially dangerous PRCM configration
2009-10-16 15:56 UTC (4+ messages)
` [PATCHV2] "
[RFC][Patch V1] OMAP3: Mux Changes
2009-10-16 15:50 UTC (5+ messages)
Dear Webmail User
2009-10-16 14:42 UTC
[PATCH v2] TWL4030: Initial support for TWL5031
2009-10-16 14:12 UTC
[PATCH] OMAP3: GPIO: Added dynamic control logic for pad wakeups
2009-10-16 12:23 UTC
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox