messages from 2009-10-24 20:18:28 to 2009-10-29 20:36:50 UTC [more...]
[PATCH 0/5] New mux code for 34xx
2009-10-29 20:36 UTC (6+ messages)
` [PATCH 1/5] omap2: mux: intoduce omap_mux_{read,write}
` [PATCH 2/5] omap: mux: Add new style pin multiplexing code for omap3
` [PATCH 3/5] omap: mux: Add new style pin multiplexing data for 34xx
` [PATCH 4/5] omap: mux: Add new style init functions to omap3 board-*.c files
` [PATCH 5/5] omap: mux: Add debugfs support for new mux code
[RFC PATCH 0/3] mux framework rework
2009-10-29 20:30 UTC (11+ messages)
` [PATCH 1/3] omap2: mux: intoduce omap_mux_{read,write}
` [PATCH 1/3] omap2: mux: intoduce omap_mux_{read,write}, v2
` [PATCH 2/3] omap: mux: add interface for encoded mux configration
` [PATCH 3/3] omap2: mux: implement encoded mux configuration
[PATCH 4/4] Audio: Modifying the defconfig for OMAP3517 / AM3517 EVM
2009-10-29 18:52 UTC
[PATCH 3/4] Audio: Modifying board-evm file for audio codec
2009-10-29 18:52 UTC
[PATCH 2/4] Audio: Modifying Kconfig/Makefile for AM3517 EVM
2009-10-29 18:52 UTC
[PATCH 1/4] Audio: Adding OMAP3517 / AM3517 EVM support in ASOC
2009-10-29 18:52 UTC
[PATCH 0/4] ASOC: Add AM3517 EVM support in ASOC
2009-10-29 18:52 UTC
[PATCH 1/3] omap3evm: ehci: Add EHCI padconfig for board Rev >= E
2009-10-29 18:12 UTC (15+ messages)
` [PATCH 2/3] omap3evm: ehci: Update EHCI support on OMAP3EVM (Rev >= E)
` [PATCH 3/3] omap3evm: musb: Update power capability for "
OMAP3 SDMA + RFBI_PARAM register
2009-10-29 16:14 UTC
[PATCH] am3517evm : add nand support
2009-10-29 16:04 UTC
[PATCH] omap-pm: Fixes behaviour of some shared resource framework functions
2009-10-29 15:42 UTC (11+ messages)
[PATCH] OMAP35xx: Added SDIO IRQ support
2009-10-29 14:35 UTC (7+ messages)
[PATCH] omap3: Change the default silicon
2009-10-29 14:35 UTC
[PATCHv2 2/3] OMAP UART: Add platform data for omap-serial driver
2009-10-29 14:11 UTC (4+ messages)
[PATCH] omap3evm : enable nand support
2009-10-29 13:02 UTC
[PATCH] ASoC: OMAP3EVM: Use the twl4030_setup_data for headset pop-removal
2009-10-29 10:27 UTC (4+ messages)
` [alsa-devel] "
[PATCH 0/3] PM: Misc latency fixes
2009-10-29 10:15 UTC (7+ messages)
` [PATCH 1/3] OMAP3: Only update pm-counters when needed
` [PATCH 2/3] PM: Skip PER previous state register read
` [PATCH V4 3/3] OMAP: I2C: Add mpu wake up latency constraint in i2c
[PATCH 0/3] Update CPU idle parameter passing
2009-10-29 8:30 UTC (4+ messages)
` [PATCH 1/3] OMAP:PM: Fix non-cpu idle builds using omap3_pm_init_cpuidle
` [PATCH 2/3] OMAP3: Add valid field into C-state parameter passing
` [PATCH 3/3] OMAP: RX-51: Pass cpu idle parameters
[PATCH] OMAP3: drop all IVA-related address base definitions
2009-10-29 7:33 UTC
[PATCH] OMAP: McBSP: Do not use extensive spin locks for dma_op_mode
2009-10-29 7:15 UTC (12+ messages)
` [alsa-devel] "
[PATCH 2/2 v2] OMAP3:clk - introduce DPLL4 jtype support
2009-10-29 2:39 UTC (2+ messages)
[PATCH 1/2] AM35xx: Runtime detection of the device
2009-10-28 20:17 UTC (10+ messages)
[PATCH 1/2] Added board-3630.c file
2009-10-28 22:10 UTC (9+ messages)
[PATCH] PM: Fixes warning on suspend errors
2009-10-28 22:06 UTC (4+ messages)
` [linux-pm] "
[PATCHv2 1/3] OMAP UART: Add omap-serial driver support
2009-10-28 15:53 UTC (7+ messages)
[PATCH 2/2] AM35xx: Defconfig for AM3517 EVM board
2009-10-28 14:14 UTC
[PATCH 1/2] AM35xx: Add support for AM3517 EVM board
2009-10-28 14:14 UTC
[PATCH 0/2] Introduce AM3517 EVM board support
2009-10-28 14:13 UTC
[PATCH] omap3evm: Migrate to smsc911x ethernet driver
2009-10-28 13:48 UTC
[PATCH v2] AM35xx: Runtime detection of the device
2009-10-28 13:38 UTC
[PATCH] omap3: Fix macro definitions
2009-10-28 13:09 UTC
[PATCH 0/3] Introduce Zoom3 board
2009-10-28 12:12 UTC (7+ messages)
` [PATCH 1/3] omap: zoom: reuse zoom2 board file for zoom3
` [PATCH 2/3] omap: zoom2: update makefile for boardfile name change
` [PATCH 3/3] omap: zoom3: add zoom3 board support
` Welcome: OMAPZoom Tutorial Hour
[PATCH] OMAP3: Clock: Fixed dpll3_m2x2 rate calculation
2009-10-28 11:38 UTC
[PATCH] omap3evm: Add board revision function
2009-10-28 11:38 UTC
[PATCHv2 0/11] Misc fixes [for PM branch]
2009-10-28 11:02 UTC (11+ messages)
` [PATCH 01/11] OMAP3: PM: Fixed padconf save done check
` [PATCH 02/11] OMAP3: Disable Smartreflex before pwrdm enters RET
` [PATCH 03/11] OMAP2/3: DMTIMER: Clear pending interrupts when stopping a timer
` [PATCH 04/11] OMAP3: PM: Ack pending interrupts before entering suspend
` [PATCH 05/11] OMAP3: PM: Enable system control module autoidle
` [PATCH 06/11] OMAP3: PM: Disable interrupt controller AUTOIDLE before WFI
` [PATCH 07/11] OMAP3: Fixed ARM aux ctrl register save/restore
[PATCH 1/2] OMAP3: Enable DSS2 for OMAP3EVM board
2009-10-28 10:06 UTC (2+ messages)
[PATCH 2/2] OMAP: DSS2: Add Sharp LQ043T1DG01 panel drivers
2009-10-28 10:03 UTC
OMAP3 RFBI
2009-10-28 9:27 UTC
OMAP DSS2 - bpp problem
2009-10-28 9:10 UTC
MMC_CAP_SDIO IRQ for OMAP35xx
2009-10-28 7:30 UTC (2+ messages)
[PATCHv2 3/3] OMAP UART: Add omap-serial driver support in omap_3430sdp_defconfig
2009-10-28 7:14 UTC
[PATCHv2 0/3] OMAP UART: Adding support for omap-serial driver
2009-10-28 7:12 UTC
[PATCH 0/2 v3] OMAP3: PM: refactor Smart Reflex
2009-10-28 5:17 UTC (15+ messages)
` [PATCH 1/2 v3] OMAP3: PM: SR: prepare: remove old SR code
` [PATCH 2/2 v3] OMAP3: PM: SR: SmartReflex Refactor Rev4.0
[PATCH]Set omap3630 MMC1 I/O speed to 52Mhz
2009-10-27 23:22 UTC
[PATCH] OMAP PM SRF: fix authorship, initial comment
2009-10-27 21:05 UTC (2+ messages)
[PATCH] OMAP PM: SRF: Drop unnecessary powerdomain activity hooks
2009-10-27 21:04 UTC (2+ messages)
[PATCH] OMAP PM: Remove symbol exports
2009-10-27 21:04 UTC (2+ messages)
GPMC setup help
2009-10-27 20:41 UTC
looking for presence of PMN interrupt in OMAP3530
2009-10-27 20:24 UTC
[ANNOUNCE] updated dspbridge on linux-omap
2009-10-27 20:09 UTC (3+ messages)
[PATCH 2/2] AM35xx: Define the AM3517EVM board
2009-10-27 14:02 UTC
[PATCH 0/2] Introduce support for AM35xx
2009-10-27 14:02 UTC
[PATCH] RX51: Add SDRAM init
2009-10-27 12:39 UTC
[PATCH 0/4] RX51: SDRAM settings changes
2009-10-27 12:48 UTC (7+ messages)
` [PATCH 1/4] RX51: Add SDRAM configs for different OPPs
` [PATCH 2/4] RX51: SDRAM: Cleanup the init code
` [PATCH 3/4] RX51: SDRC: change timing values to follow generic memory requirements
` [PATCH 4/4] RX51: Fix SDRAM RFR timings calculation
update: n8x0 idle power problem
2009-10-27 1:25 UTC (3+ messages)
[PATCH] [OMAP] GPIO Module is reset during initialization
2009-10-26 20:29 UTC (9+ messages)
[PATCH 0/2] OMAP3: Cpuidle fixes
2009-10-26 18:54 UTC (4+ messages)
` [PATCH 1/2] OMAP3: PM: Check BM for C2 state
` [PATCH 2/2] OMAP3: CPUidle: Fixed timer resolution
24xx/n8x0 booting again, linux-omap updated to -rc5
2009-10-26 16:08 UTC (6+ messages)
[PATCH 2/2 v3] OMAP3: PM: SR: SmartReflex Refactor Rev4.0
2009-10-26 15:13 UTC
[PATCH 4/4] OMAP: 3430SDP: Enable NAND in defconfig
2009-10-26 12:14 UTC
[PATCH-v4 3/4] OMAP: Zoom2: Enable NAND and JFFS2 support in defconfig
2009-10-26 12:13 UTC
[PATCH-v4 2/4] OMAP3: Add support for NAND on ZOOM2/LDP boards
2009-10-26 12:11 UTC
[PATCH-v4 1/4] OMAP2/3: Add support for flash on SDP boards
2009-10-26 12:10 UTC
[PATCH-v3 0/3] OMAP: Adding flash support to SDP, ZOOM2 and LDP boards
2009-10-26 12:07 UTC (3+ messages)
` [PATCH-v4 0/4] "
[PATCH 2/2] Accomodate the board file change in Kconfig
2009-10-26 11:05 UTC (2+ messages)
[PATCH] [OMAP] GPIO Module disable if all pins inactive
2009-10-26 10:46 UTC (7+ messages)
[PATCH 0/2] Introduce 3630sdp board file
2009-10-26 7:42 UTC
[PATCH 0/4 v2] MFD/OMAP/ASoC: MFD device for twl4030 codec submodule
2009-10-25 17:18 UTC (4+ messages)
` [PATCH 1/4 v2] MFD: twl4030: add twl4030_codec MFD as a new child to the core
Please advise on modifying defconfig for Amstrad Delta
2009-10-25 2:40 UTC
[GIT PULL] omap-fixes for v2.6.32-rc5
2009-10-24 21:36 UTC
[PATCH 1/1] input: lm8323: setting correct value to size_y
2009-10-24 20:18 UTC
[PATCH 0/1] input: lm8323: setting correct value to size_y
2009-10-24 20:18 UTC
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox