messages from 2010-06-23 09:28:45 to 2010-06-25 14:28:32 UTC [more...]
ZOOM2 doesn't boot on upstream kernel
2010-06-25 14:28 UTC (6+ messages)
[PATCH] smsc95xx: Add module parameter to override MAC address
2010-06-25 14:20 UTC (5+ messages)
[PATCH 3/9 v2] omap: generic: introduce a single check_revision
2010-06-25 13:55 UTC (4+ messages)
` [PATCH 6/9 v2] omap: move generic omap3 features to generic
[PATCH 2/2] arm: Make VFPv3 usable on ARMv6
2010-06-25 13:50 UTC (5+ messages)
[pm-wip/uart][PATCH v3] Serial: Avoid using hwmod lookup using name string
2010-06-25 13:41 UTC (3+ messages)
` [pm-wip/uart][PATCH] Serial: Avoid populating uart_list in early init phase
[PATCH 1/4] omap mailbox: extend API to take a callback param
2010-06-25 13:20 UTC (11+ messages)
` [PATCH 3/4] omap mailbox: remove mbox_configured scheme
[PATCH 0/9 v2] introduce generic OMAP SOC features
2010-06-25 13:18 UTC (4+ messages)
` [PATCH 3/9] omap: generic: introduce a single check_revision
[PATCH v2 00/13] OMAP: CM, hwmod, omap_device fixes and updates
2010-06-25 13:16 UTC (15+ messages)
` [PATCH v2 01/13] OMAP24xx: CM: fix mask used for checking IDLEST status
` [PATCH v2 02/13] OMAP: hwmod: allow idle after HWMOD_INIT_NO_IDLE
` [PATCH v2 03/13] OMAP2/3: hwmod: L3 and L4 CORE/PER/WKUP hwmods don't have IDLEST
` [PATCH v2 04/13] OMAP: hwmod: Fix the missing braces
` [PATCH v2 05/13] OMAP2&3: hwmod: Remove _hwmod prefix in name string
` [PATCH v2 06/13] OMAP: hwmod: add non-locking versions of enable and idle functions
` [PATCH v2 07/13] OMAP: hwmod: don't auto-disable hwmod when !CONFIG_PM_RUNTIME
` [PATCH v2 08/13] OMAP4: hwmod: Enable omap_device build for OMAP4
` [PATCH v2 09/13] OMAP: omap_device: ensure hwmod tracks attached omap_device pointer
` [PATCH v2 10/13] OMAP: create omap_devices for MPU, DSP, L3
` [PATCH v2 11/13] OMAP: hwmod data: add class for IVA hwmods
` [PATCH v2 12/13] OMAP2&3: hwmod: Replace l3 -> l3_main
` [PATCH v2 13/13] OMAP3: hwmod data: add data for OMAP3 IVA2
[PM-SR] [PATCH] OMAP: PM: Remove the usage of vdd id's
2010-06-25 13:15 UTC (3+ messages)
[RFC] omap: hwspinlock: Added hwspinlock driver
2010-06-25 8:11 UTC (2+ messages)
[PATCH 0/8] OMAP3: Adding Smartreflex and Voltage driver support
2010-06-25 8:04 UTC (8+ messages)
` [PATCH 1/8] OMAP3: PM: Adding voltage driver support for OMAP3
` [PATCH 2/8] OMAP3: PM: Adding smartreflex driver support
[RFC] mm: iommu: An API to unify IOMMU, CPU and device memory management
2010-06-25 6:48 UTC (3+ messages)
[PATCHv3 1/1] OMAP3: AM3505/3517 do not have IO wakeup capability
2010-06-25 6:53 UTC
[PATCH] Add OMAP4 Panda Support
2010-06-25 1:29 UTC (2+ messages)
Recall: [RFC] omap:
2010-06-25 0:40 UTC
[RFC] omap:
2010-06-25 0:39 UTC
[PATCH v2 0/3] OMAP: add runtime PM support at bus-level
2010-06-24 23:43 UTC (4+ messages)
` [PATCH v2 1/3] OMAP: PM: initial runtime PM core support
` [PATCH v2 2/3] OMAP: bus-level PM: enable use of runtime PM API for suspend/resume
` [PATCH v2 3/3] OMAP1: PM: add simple runtime PM layer to manage clocks
[PATCH] OMAP2&3: hwmod: Replace l3 -> l3_main and fix iva2
2010-06-24 22:39 UTC (2+ messages)
[PATCH 00/13] OMAP: CM, hwmod, omap_device fixes and updates
2010-06-24 21:47 UTC (45+ messages)
` [PATCH 01/13] OMAP24xx: CM: fix mask used for checking IDLEST status
` [PATCH 02/13] OMAP: hwmod: allow idle after HWMOD_INIT_NO_IDLE
` [PATCH 03/13] OMAP2/3: hwmod: L3 and L4 CORE/PER/WKUP hwmods don't have IDLEST
` [PATCH 04/13] OMAP: hwmod: Fix the missing braces
` [PATCH 05/13] OMAP2&3: hwmod: Remove _hwmod prefix in name string
` [PATCH 06/13] OMAP: hwmod: add non-locking versions of enable and idle functions
` [PATCH 07/13] OMAP: hwmod: don't auto-disable hwmod when !CONFIG_PM_RUNTIME
` [PATCH 08/13] OMAP4: hwmod: Enable omap_device build for OMAP4
` [PATCH 09/13] OMAP: omap_device: ensure hwmod tracks attached omap_device pointer
` [PATCH 10/13] OMAP: omap_device: add flag to disable automatic bus-level suspend/resume
` [PATCH 11/13] OMAP: create omap_devices for MPU, DSP, L3
` [PATCH 12/13] OMAP: hwmod data: add class for DSP hwmods
` [PATCH 13/13] OMAP3: hwmod data: add data for OMAP3 IVA2
[PM-SR][PATCH 0/4] Janitor series: kill sparse warnings
2010-06-24 21:29 UTC (5+ messages)
` [PM-SR] [PATCH 1/4] omap: sr: export sr_dbg_dir
` [PM-SR] [PATCH 2/4] omap3: sr: sr_exit should be static
` [PM-SR][PATCH 3/4] omap3: voltage: make required variables static
` [PM-SR][PATCH 4/4] omap3: voltage: expose omap_change_voltscale_method
[PATCH] select NOP_USB_XCEIV for OMAP4
2010-06-24 18:43 UTC (13+ messages)
[PATCH 00/12] rework OPP layer to handle device-based OPPs
2010-06-24 18:09 UTC (8+ messages)
` [PATCH 05/12] OMAP: create omap_devices for MPU, DSP, L3
[PATCH 0/3] OMAP: add runtime PM support at bus-level
2010-06-24 17:34 UTC (6+ messages)
` [PATCH 1/3] OMAP: PM: initial runtime PM core support
` [PATCH 2/3] OMAP: PM: use omap_device API for suspend/resume
` [PATCH 3/3] OMAP1: PM: add simple runtime PM layer to manage clocks
[PATCH 0/4] runtime PM support at the bus level
2010-06-24 17:24 UTC (12+ messages)
` [PATCH 3/4] OMAP: PM: use omap_device API for suspend/resume
[patch-2.6.35-rc3+ 0/8] musb patches
2010-06-24 17:01 UTC (21+ messages)
` [PATCH 1/8] musb_core: make disconnect and suspend interrupts work again
` [PATCH 2/8] MUSB: make non-OMAP platforms build with CONFIG_PM=y
` [PATCH 3/8] musb: fix compilation warning in host only mode
` [PATCH 4/8] USB: musb: suppress warning about unused flags
` [PATCH 5/8] usb: musb: fix Blackfin ulpi stubs
` [PATCH 6/8] usb: musb: Enable the maximum supported burst mode for DMA
` [PATCH 7/8] musb: Kill board specific pinmux from driver file
On the APIs for Enabling and Disabling Wakeup capability
2010-06-24 15:04 UTC (11+ messages)
USB urb synchronization EL2NSYNC
2010-06-24 14:50 UTC
[PATCH 00/11] staging: add ti dspbridge driver
2010-06-24 13:40 UTC (16+ messages)
` [PATCH 01/11] staging: ti dspbridge: add driver documentation
` [PATCH 02/11] staging: ti dspbridge: add core driver sources
` [PATCH 03/11] staging: ti dspbridge: add platform manager code
` [PATCH 04/11] staging: ti dspbridge: add resource manager
` [PATCH 05/11] staging: ti dspbridge: add MMU support
` [PATCH 06/11] staging: ti dspbridge: add generic utilities
` [PATCH 07/11] staging: ti dspbridge: add services
` [PATCH 08/11] staging: ti dspbridge: add DOFF binaries loader
` [PATCH 09/11] staging: ti dspbridge: add header files
` [PATCH 10/11] staging: ti dspbridge: add TODO file
` [PATCH 11/11] staging: ti dspbridge: enable driver building
[PATCH] Disable the non working eMMC on Zoom2/3
2010-06-24 12:04 UTC (16+ messages)
[PATCH] OMAP: DSS: Fix for dsi_pll to dpll4 clk switch
2010-06-24 10:51 UTC (2+ messages)
[PATCHv2] OMAP3: AM3505/3517 do not have IO wakeup capability
2010-06-24 10:20 UTC
[PATCH 00/13 v3] OMAP: GPIO: Implement GPIO in HWMOD way
2010-06-24 8:44 UTC (9+ messages)
` [PATCH 01/13 v3] OMAP: GPIO: Modify init() in preparation for platform device implementation
` [PATCH 02/13 v3] OMAP: GPIO: Populate GPIO base address in omapxxxx.h
` [PATCH 03/13 v3] OMAP: GPIO: Include platform_data structure for GPIO
` [PATCH 04/13 v3] OMAP: GPIO: Introduce support for OMAP15xx chip GPIO init
` [PATCH 05/13 v3] OMAP: GPIO: Introduce support for OMAP16xx "
` [PATCH 06/13 v3] OMAP: GPIO: Introduce support for OMAP7xx "
` [PATCH 07/13 v3] OMAP: GPIO: add GPIO hwmods structures for OMAP3
[PATCH:v4 00/13] OMAP: GPIO: Implement GPIO in HWMOD way
2010-06-24 7:03 UTC (5+ messages)
` [PATCH:v4 01/13] OMAP: GPIO: Modify init() in preparation for platform device implementation
` [PATCH:v4 02/13] OMAP: GPIO: Populate GPIO base address in omapxxxx.h
` [PATCH:v4 03/13] OMAP: GPIO: Include platform_data structure for GPIO
[PATCH] OMAP3: wait on IDLEST after enabling USBTLL fclk
2010-06-24 6:28 UTC (6+ messages)
[PATCH 0/2] Make ARMv6 behave with TLS, VFPv3, and NEON
2010-06-24 0:28 UTC (11+ messages)
` [PATCH 1/2] arm: Replace CONFIG_HAS_TLS_REG with HWCAP_TLS and check for it on V6
[PATCH] OMAP: hwmod regression fix for 2.6.35-rc
2010-06-24 0:24 UTC (2+ messages)
` [PATCH] OMAP: hwmod: Fix the missing braces
pm_debug/voltage_off_while_idle has gone?
2010-06-23 18:04 UTC (2+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).