messages from 2011-06-06 17:25:57 to 2011-06-09 13:30:20 UTC [more...]
[PATCH v3 00/12] MFD/ASoC/Input: TWL4030/TWL60X0 changes
2011-06-09 13:30 UTC (3+ messages)
` [PATCH v3 01/12] OMAP: New twl-common for common TWL configuration
` [PATCH v3 02/12] OMAP4: Move common twl6030 configuration to twl-common
[PATCH 0/3] PRCM chain interrupt handler
2011-06-09 13:25 UTC (4+ messages)
` [PATCH 1/3] omap: prcm: switch to a chained IRQ handler mechanism
` [PATCH 2/3] PRCM: Add support for PAD wakeup interrupts
` [PATCH 3/3] HACK: OMAP: Serial: use PRCM wakeup events to enable clocks
[RFC] dmaengine: add new api for preparing simple slave transfer
2011-06-09 12:47 UTC (2+ messages)
[PATCH 0/8] Fix module-mode enable sequence on OMAP4
2011-06-09 10:54 UTC (9+ messages)
` [PATCH 1/8] OMAP2+: clockdomain: Add an api to read idle mode
` [PATCH 2/8] OMAP2+: clockdomain: Add SoC support for clkdm_is_idle
` [PATCH 3/8] OMAP2+: PM: Initialise sleep_switch to a non-valid value
` [PATCH 4/8] OMAP2+: PM: idle clkdms only if already in idle
` [PATCH 5/8] OMAP4: PM: TEMP: Prevent l3init from idling/force sleep
` [PATCH 6/8] OMAP2+: hwmod: Follow the recomended PRCM clock enable sequence
` [PATCH 7/8] OMAP: clock: Add flags to identify optional clock nodes
` [PATCH 8/8] OMAP: clock: Enable clockdomain only for optional clocks
rtc-twl: catch22 in 2.6.37 and 2.6.38 when clock was never set
2011-06-09 9:23 UTC (10+ messages)
` [PATCH] arm: omap3: beagle: Ensure msecure is mux'd to be able to set the RTC
[RFC 0/6] iommu: generic api migration and grouping
2011-06-09 6:42 UTC (23+ messages)
` [RFC 1/6] omap: iommu: generic iommu api migration
` [RFC 2/6] omap: iovmm: "
Clock & PM breakage in 3.0-rc2
2011-06-09 6:10 UTC (3+ messages)
[linux-pm] calling runtime PM from system PM methods
2011-06-09 5:29 UTC (10+ messages)
[PATCH v3 00/12] OMAP2+: Serial: Runtime adaptation + cleanup
2011-06-09 4:35 UTC (15+ messages)
` [PATCH v3 01/12] OMAP2+: UART: Remove certain uart calls from sram_idle
` [PATCH v3 02/12] OMAP2+: UART: Remove uart clock handling code from serial.c
` [PATCH v3 03/12] OMAP2+: Serial: Add default mux for all uarts
` [PATCH v3 04/12] Serial: OMAP: Add runtime pm support for omap-serial driver
` [PATCH v3 05/12] OMAP: Serial: Hold console lock for console usage
` [PATCH v3 06/12] Serial: OMAP2+: Move erratum handling from serial.c
` [PATCH v3 07/12] OMAP: Serial: Allow UART parameters to be configured from board file
` [PATCH v3 08/12] Serial: OMAP2+: Make the RX_TIMEOUT for DMA configurable for each UART
` [PATCH v3 09/12] OMAP3: Serial: Remove uart pads from 3430 board file
` [PATCH v3 10/12] OMAP: Serial: Use resume call from prcm to enable uart
` [PATCH v3 11/12] OMAP2: Serial: Add has_async_wake flag
` [PATCH v3 12/12] OMAP4: Serial: Set TX_FIFO_THRESHOLD if uart in dma mode for es2.0
[PATCH 0/2] OMAP1: amsdelta: reserve memory for videobuf_contig
2011-06-08 22:44 UTC (6+ messages)
` [RESEND] [PATCH 1/2] OMAP1: allow reserving memory for camera
[PATCH 0/4] drivers/iommu/ relocations
2011-06-08 22:27 UTC (17+ messages)
` [PATCH 1/4] drivers: iommu: move to a dedicated folder
` [PATCH 2/4] msm: iommu: move to drivers/iommu/
` [PATCH 3/4] x86: amd_iommu: "
` [PATCH 4/4] x86: intel-iommu: "
[pm-wip/cpufreq][PATCH 0/3] OMAP2+: cpufreq: fixes
2011-06-08 21:03 UTC (12+ messages)
` [pm-wip/cpufreq][PATCH 1/3] OMAP2+: cpufreq: minor flow beautification
` [pm-wip/cpufreq][PATCH 2/3] OMAP2+: cpufreq: notify even with bad boot frequency
` [pm-wip/cpufreq][PATCH 3/3] OMAP2+: cpufreq: do lateinit
[PATCH 00/27] OMAP DSS runtime PM adaptation
2011-06-08 20:39 UTC (24+ messages)
` [PATCH 19/27] OMAP: DSS2: Use PM runtime & HWMOD support
[PATCH 00/11] crypto: omap-sham driver fixes
2011-06-08 19:36 UTC (3+ messages)
[PATCH] omap: iovmm: s/sg_dma_len(sg)/sg->length/
2011-06-08 16:03 UTC (2+ messages)
[RFC] omap3: pm: Downgrade WARN for no wakeup source
2011-06-08 16:01 UTC
[GIT PULL] GPIO: OMAP fixes for v3.0-rc
2011-06-08 15:17 UTC (2+ messages)
Dear Winner
2011-06-08 11:04 UTC
[PATCH 0/2] OMAP3 IOMMU fixes
2011-06-08 10:48 UTC (2+ messages)
[PATCH v2 2/2] omap3: iovmm: Support non page-aligned buffers in iommu_vmap
2011-06-08 10:33 UTC (6+ messages)
` [PATCH v3 1/2] omap3: iovmm: Work around sg_alloc_table size limitation in IOMMU
[PATCH] OMAP4: McBSP: Clear rx_irq at probe time
2011-06-08 7:51 UTC (4+ messages)
[RFC PATCHv4 0/7] HSI framework and drivers
2011-06-08 7:12 UTC (8+ messages)
[PATCH v2 00/12] MFD/ASoC/Input: TWL4030/TWL60X0 changes
2011-06-08 6:51 UTC (15+ messages)
` [PATCH v2 01/12] OMAP: New pmic-common for common TWL configuration
` [PATCH v2 02/12] OMAP4: Move common twl6030 configuration to pmic-common
` [PATCH v2 03/12] OMAP3: Move common pmic "
` [PATCH v2 04/12] OMAP3: Move common regulator "
` [PATCH v2 05/12] MFD: twl4030-codec: Rename internals from codec to audio
` [PATCH v2 06/12] MFD: twl4030-codec -> twl4030-audio: Rename the driver
` [PATCH v2 07/12] MFD: twl4030-audio: Rename platform data
` [PATCH v2 08/12] mfd: twl6040: Add initial support
` [PATCH v2 09/12] ASoC: twl6040: Convert into TWL6040 MFD child
` [PATCH v2 10/12] MFD: twl6040: Change platform data for soc codec driver
` [PATCH v2 11/12] input: Add initial support for TWL6040 vibrator
` [PATCH v2 12/12] OMAP4: SDP4430: Add twl6040 vibrator platform support
[PATCH pm_wip/cpufreq] OMAP2+: cpufreq: Enable all CPUs in shared policy mask
2011-06-08 6:01 UTC (2+ messages)
[pm-wip/voltdm_nm][PATCH 10/10] OMAP2+: PM: init_voltages: handle non compliant bootloaders
2011-06-08 2:09 UTC (3+ messages)
[pm-wip/voltdm_nm][PATCH 10/10] OMAP2+: PM: init_voltages: handle non compliant bootloaders
2011-06-08 0:39 UTC
[PATCH] OMAP1: PM: register notifiers with generic clock ops even when !PM_RUNTIME
2011-06-08 0:05 UTC
[PATCH] OMAP1: enable GENERIC_IRQ_CHIP
2011-06-08 0:02 UTC
[RFC] OMAP: McBSP not working if CONFIG_PM_RUNTIME not set
2011-06-07 23:48 UTC (4+ messages)
[PATCH 3.0-rc1] PM / runtime: fix broken iteration over clock ids
2011-06-07 22:27 UTC (7+ messages)
[PATCH v7] OMAP3: beagle: add support for beagleboard xM revision C
2011-06-07 22:26 UTC (2+ messages)
[PATCH 0/3] I2C: OMAP: PM related cleanup
2011-06-07 18:22 UTC (4+ messages)
` [PATCH 1/3] I2C: OMAP: remove unneccesary use of pdev
` [PATCH 2/3] I2C: OMAP: remove dev->idle, use usage counting provided by runtime PM
` [PATCH 3/3] I2C: OMAP: remove racy suspend/resume callbacks
[PATCH v2 1/2] ARM: omap4: gpio: fix setting IRQWAKEN bits
2011-06-07 16:37 UTC (6+ messages)
` [PATCH v2 2/2] ARM: omap4: gpio: add locking around calls to _set_gpio_triggering
[PATCH v4 00/18] I2C: OMAP: I2C fixes, removal of cpu_is... from driver
2011-06-07 13:41 UTC (2+ messages)
[PATCH 0/9] MAP: DSS2: DSI2 for secondary lcd panel on OMAP4
2011-06-07 13:11 UTC (14+ messages)
` [PATCH 1/9] OMAP: DSS2: Change DSI platform device name from "omapdss_dsi1" to "omapdss_dsi"
problem with "undefined instruction"
2011-06-07 11:53 UTC (3+ messages)
[pm-wip/voltdm_nm][PATCH 00/10] OMAP2+: voltage: fixes
2011-06-07 2:16 UTC (10+ messages)
` [pm-wip/voltdm_nm][PATCH 01/10] OMAP3+: VC: fix mutant channel handling
` [pm-wip/voltdm_nm][PATCH 02/10] OMAP4: PM: VC: allow channels use of default channel i2c_slaveaddr
` [pm-wip/voltdm_nm][PATCH 03/10] OMAP4: PM: VC: allow channels to use cmdra reg
` [pm-wip/voltdm_nm][PATCH 04/10] OMAP4: PM: VC: allow channels use of default channel volt_reg_addr
` [pm-wip/voltdm_nm][PATCH 05/10] OMAP4: PM: VC: allow channels use of default channel cmd_reg_addr
` [pm-wip/voltdm_nm][PATCH 06/10] OMAP3+: PM: VC: support configuring PMIC over I2C_SR
` [pm-wip/voltdm_nm][PATCH 07/10] OMAP3+: PM: VP: use uV for max and min voltage limits
` [pm-wip/voltdm_nm][PATCH 08/10] OMAP3+: PM: introduce a central pmic control
` [pm-wip/voltdm_nm][PATCH 09/10] OMAP2+: PM: secure OPP access using rcu locks
[PATCH 3.0-rc2] OMAP: ams-delta: fix broken uevent sysfs entries
2011-06-07 1:16 UTC
[GIT PULL] OMAP PM fixes for v3.0-rc
2011-06-06 23:29 UTC
[PATCH] ARM: omap4: gpio: fix setting IRQWAKEN bits
2011-06-06 23:25 UTC (5+ messages)
[PATCH][pm-wip/cpufreq] OMAP2+: CPUfreq: Remove superfluous check in target() for online CPU's
2011-06-06 23:04 UTC (3+ messages)
Regulator cleanups in mach-omap2, take three
2011-06-06 19:25 UTC (5+ messages)
` [PATCH 1/2] cleanup regulator supply definitions in mach-omap2
` [PATCH 2/2] Remove old-style supply.dev assignments common in hsmmc init
[PATCH 4/4] mfd: global Suspend and resume support of ehci and ohci
2011-06-06 18:03 UTC (4+ messages)
calling runtime PM from system PM methods
2011-06-06 18:01 UTC (2+ messages)
Regulator cleanups in mach-omap2, take two
2011-06-06 17:36 UTC (8+ messages)
` [PATCH 1/2] cleanup regulator supply definitions in mach-omap2 to use REGULATOR_SUPPLY
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).