messages from 2011-10-18 15:35:07 to 2011-10-27 08:09:53 UTC [more...]
[PATCH v3 0/4] Device tree support for regulators
2011-10-27 8:09 UTC (6+ messages)
` [PATCH v3 1/4] regulator: helper routine to extract regulator_init_data
` [PATCH v3 2/4] regulator: adapt fixed regulator driver to dt
` [PATCH v3 3/4] regulator: pass additional of_node to regulator_register()
` [PATCH v3 4/4] regulator: map consumer regulator based on device tree
[PATCH 0/3] Device tree support for TWL regulators
2011-10-27 8:04 UTC (4+ messages)
` [PATCH 1/3] regulator: twl: adapt twl-regulator driver to dt
` [PATCH 2/3] omap4: sdp: Pass regulator data from dt
` [PATCH 3/3] omap4: panda: Pass regulator data from DT
[RFC/PATCH] ARM: OMAP: Fix build for OMAP3 only builds
2011-10-27 5:32 UTC (2+ messages)
msub: error running host mode on 3.1.0rc4
2011-10-26 18:18 UTC (2+ messages)
[PATCH] of: Add a reg-names property to name reg entries
2011-10-26 17:40 UTC (12+ messages)
[PATCH 2/2] OMAPDSS: HDMI: Disable HDMI DDC internal pull up
2011-10-26 8:30 UTC (4+ messages)
[PATCH 1/2] OMAPDSS: HDMI: Move duplicate code from boardfile to
2011-10-26 8:27 UTC (4+ messages)
[PATCH 0/7] Introducing a generic AMP framework
2011-10-26 5:26 UTC (12+ messages)
` [PATCH 1/7] amp/remoteproc: add framework for controlling remote processors
` [PATCH 2/7] amp/remoteproc: add debugfs entries
` [PATCH 3/7] amp/remoteproc: create rpmsg virtio device
` [PATCH 4/7] amp/omap: add a remoteproc driver
` [PATCH 5/7] ARM: OMAP: add amp/remoteproc support
` [PATCH 6/7] amp/rpmsg: add virtio-based remote processor messaging bus
` [PATCH 7/7] samples/amp: add an rpmsg driver sample
[PATCH] ARM: remove NR_IRQS dependency for ARM-specific HARDIRQ_BITS definition
2011-10-25 13:36 UTC (3+ messages)
[PATCH v5 0/7] arm: pmu: support pmu/perf on OMAP4
2011-10-25 11:00 UTC (14+ messages)
` [PATCH v5 1/7] arm: introduce cross trigger interface helpers
` [PATCH v5 2/7] arm: pmu: allow platform specific irq enable/disable handling
` [PATCH v5 3/7] arm: perf: support device with other non-irq resources
` [PATCH v5 4/7] arm: omap4: hwmod: introduce emu hwmod
` [PATCH v5 5/7] arm: omap4: create pmu device via hwmod
` [PATCH v5 6/7] arm: omap4: support pmu
` [PATCH v5 7/7] arm: omap4: pmu: support runtime pm
I Need Your Assistance
2011-10-25 9:20 UTC
[PATCH v2 0/5] Device tree support for regulators
2011-10-25 7:42 UTC (70+ messages)
` [PATCH v2 3/5] regulator: helper routine to extract regulator_init_data
Linux 3.0 DSS support
2011-10-25 7:37 UTC (4+ messages)
[PATCH 0/2] MMC: disable multiblock reads on controllers that don't support them
2011-10-24 9:27 UTC (2+ messages)
[GIT PULL] pending DT patches and cleanup for map_io for v3.2 merge window
2011-10-24 9:17 UTC
TI OMAP4430 - UHS support
2011-10-24 8:56 UTC
Simple GPMC device driver with basic User application
2011-10-24 1:47 UTC
[PATCH 03/49] arm: irq: Remove IRQF_DISABLED
2011-10-22 9:56 UTC
Congratulations
2011-10-22 5:01 UTC
Congratulations
2011-10-22 5:03 UTC
Congratulations
2011-10-21 21:22 UTC
OMAP HSMMC data timeout calculation
2011-10-21 15:01 UTC
[RFC PATCHv5 0/7] HSI framework and drivers
2011-10-21 13:36 UTC (6+ messages)
群发软件+买家搜索机+109届广交会买家、海关数据,B2B询盘买家500万。
2011-10-21 1:08 UTC
Build error while adding debug LL support for new board
2011-10-20 18:38 UTC (6+ messages)
[PATCHv9 00/18] omap PRCM chain handler
2011-10-20 15:25 UTC (13+ messages)
` [PATCHv9 03/18] TEMP: OMAP3xxx: hwmod data: add PRM hwmod
[PATCH 2/2] OMAPDSS: HDMI: SDP: Disable HDMI DDC internal pull up
2011-10-20 10:44 UTC
[PATCH 1/2] OMAPDSS: HDMI: Panda: Disable HDMI DDC internal pull up
2011-10-20 10:43 UTC
[PATCH v7 20/21] OMAP2+: UART: Avoid uart idling on suspend for no_console_suspend usecase
2011-10-20 9:47 UTC (9+ messages)
` [PATCH v7 21/21] OMAP2+: UART: Do not gate uart clocks if used for debug_prints
Help with interfacing to OMAP2+: McBSP
2011-10-20 0:41 UTC (3+ messages)
[PATCH] ARM: OMAP3: cm-t35: fix mux mode for DSS pins
2011-10-19 16:46 UTC
[PATCH 0/2] OMAP: PM: switch from omap_pm_ functions to PM QoS
2011-10-19 14:28 UTC (3+ messages)
` [PATCH 1/2] OMAP: convert I2C driver to PM QoS for latency constraints
` [PATCH 2/2] OMAP: PM: remove the latency related functions from the API
[PATCH 0/4] ARM: OMAP3: cm-t35/cm-t3730 fixes
2011-10-19 14:01 UTC (9+ messages)
` [PATCH 1/4] ARM: OMAP3: cm-t35: add regulator supply for ads7846
` [PATCH 2/4] ARM: OMAP3: cm-t35: fix DSS regulator supply
` [PATCH 3/4] ARM: OMAP3: cm-t35: fix audio
` [PATCH 3/4 v2] "
` [PATCH 4/4] arm: omap3: cm-t35: add reset for sb-t35 usb hub
` [PATCH 4/4 v2] ARM: OMAP3: "
[PATCH v4 0/6] PM QoS: implement the OMAP low level constraints management code
2011-10-19 13:51 UTC (7+ messages)
` [PATCH 1/6] OMAP2+: powerdomain: control power domains next state
` [PATCH 2/6] OMAP2+: omap_hwmod: manage the wake-up latency constraints
` [PATCH 3/6] OMAP: PM: register to the per-device PM QoS framework
` [PATCH 4/6] OMAP3: cpuidle: next C-state decision depends on the PM QoS MPU and CORE constraints
` [PATCH 5/6] OMAP3: update cpuidle latency and threshold figures
` [PATCH 6/6] OMAP3: powerdomain data: add wake-up latency figures
[PATCH] CPUIdle: Reevaluate C-states under CPU load to favor deeper C-states
2011-10-19 13:11 UTC (2+ messages)
5430 adc to temp
2011-10-19 11:09 UTC (2+ messages)
(unknown),
2011-10-19 3:50 UTC
How feasible is to implement {voltage/power/clock}domain concepts of OMAP?
2011-10-18 23:11 UTC
[PATCH 1/1] ARM: OMAP: Add conditional compilation for board specific init functions
2011-10-18 20:01 UTC (4+ messages)
` [PATCH] ARM: OMAP: Fix early init definitions
[PATCH] ARM: OMAP: Add support for AM35xx UART4/ttyO3
2011-10-18 18:47 UTC
[PATCH v7 15/21] OMAP2+: UART: Make the RX_TIMEOUT for DMA configurable for each UART
2011-10-18 15:35 UTC (5+ messages)
` [PATCH v7 16/21] OMAP2+: UART: Remove custom activate funcs and use generic funcs
` [PATCH v7 17/21] OMAP2+: UART: Remove omap_uart_can_sleep and add pm_qos
` [PATCH v7 18/21] OMAP2+: UART: remove temporary variable used to count uart instance
` [PATCH v7 19/21] OMAP2+: UART: Use custom activate func for console uart
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).