messages from 2011-11-11 09:59:25 to 2011-11-18 02:19:51 UTC [more...]
[PATCH v16 00/12] OMAP: dmtimer: adaptation to platform_driver
2011-11-18 2:19 UTC (7+ messages)
` [PATCH v16 09/12] OMAP: dmtimer: low-power mode support
[PATCH] arm: omap2: fix build failure
2011-11-18 1:16 UTC (5+ messages)
[PATCH 2/2] cbus: Fix initialization of cached IRQ masks
2011-11-17 22:38 UTC
[PATCH 1/2] cbus: Fix nested IRQ acking
2011-11-17 22:38 UTC
[PATCHv9 00/18] omap PRCM chain handler
2011-11-17 22:34 UTC (3+ messages)
` [PATCHv9 06/18] mfd: omap-prm: added chain interrupt handler
[PATCH] MTD: nand: Making MTD_NAND_OMAP2 depend on ARCH_OMAP2PLUS
2011-11-17 22:15 UTC (2+ messages)
[PATCHv2] ARM: OMAP: hsmmc: Fix mux for non-OMAP pins
2011-11-17 21:39 UTC
[PATCH v4 0/6] PM QoS: implement the OMAP low level constraints management code
2011-11-17 21:29 UTC (7+ messages)
` [PATCH 1/6] OMAP2+: powerdomain: control power domains next state
` [PATCH 3/6] OMAP: PM: register to the per-device PM QoS framework
` [PATCH 4/6] OMAP3: cpuidle: next C-state decision depends on the PM QoS MPU and CORE constraints
[PATCH] I2C: OMAP: fix the clearing of interrupts
2011-11-17 19:50 UTC (2+ messages)
[PATCH] ARM: omap_hwmod: Add a new state to handle hwmods left enabled at init
2011-11-17 19:35 UTC (5+ messages)
[PATCH] ARM: OMAP: PM: only register TWL with voltage layer when device is present
2011-11-17 19:20 UTC (7+ messages)
[RFC 0/3] OMAP pinmux driver
2011-11-17 13:57 UTC (12+ messages)
` [RFC 1/3] pinctrl: add a driver for the OMAP pinmux
` [RFC 2/3] ARM: omap4: Add omap4 pinmux devices for core and wkup
` [RFC 3/3] ARM: omap4: Add pinmux map in SDP and PANDA board files
[PATCH 0/4] Support for the HTKW mcx board
2011-11-17 10:26 UTC (12+ messages)
` [PATCH 1/4] AM35xx: DSS: there is no VDDS_DSI on AM35xx
` [PATCH 2/4] omap_dss: add FocalTech ETM070003DH6 display support
` [PATCH 4/4] mcx: initial support for HTKW mcx board
[PATCH 0/3] OMAP serial device tree support
2011-11-17 10:16 UTC (17+ messages)
` [PATCH 1/3] ARM: omap_device: handle first time activation of console device
` [PATCH 2/3] omap-serial: Add minimal device tree support
` [PATCH 3/3] ARM: omap: pass minimal SoC/board data for UART from dt
[PATCH 1/3] ARM: omap_hwmod: Add a new state to handle hwmods left enabled at init
2011-11-17 10:10 UTC
arm pmu interrupt on pandaboard
2011-11-17 7:53 UTC
[PATCH/RESEND #3 0/7] SmartReflex Patches
2011-11-17 7:08 UTC (14+ messages)
` [PATCH/RESEND #3 1/7] OMAP3+: PM: SR: add suspend/resume handlers
` [PATCH/RESEND #3 2/7] arm: omap: smartreflex: add missing platform_set_drvdata()
` [PATCH/RESEND #3 3/7] arm: omap: smartreflex: use dev_get_drvdata()
` [PATCH/RESEND #3 4/7] arm: omap: smartreflex: move late_initcall() closer to its argument
` [PATCH/RESEND #3 5/7] arm: omap: smartreflex: clean ups all over
` [PATCH/RESEND #3 6/7] arm: omap: smartreflex: fix IRQ handling bug
` [PATCH/RESEND #3 7/7] arm: omap: smartreflex: micro-optimization for sanity check
[PATCH 2/2 v4] net/smsc911x: Add regulator support
2011-11-17 5:07 UTC (4+ messages)
[PATCH -next] arm: omap2: fix compile failure on arch/arm/mach-omap2/cpuidle34xx.c
2011-11-17 3:03 UTC
[PATCH] am35xx-emac: move generic EMAC init to separate file
2011-11-17 0:36 UTC
[PATCH Resend] ARM: OMAP2+: Remove empty io.h
2011-11-17 0:11 UTC (2+ messages)
[PATCHv3 00/11] voltage domain cleanup
2011-11-17 0:10 UTC (5+ messages)
` [PATCHv3 10/11] omap3+: use lp params for calculating clock setup times
[PATCH v8 10/20] OMAP2+: UART: Get context loss count to context restore
2011-11-16 20:04 UTC (5+ messages)
` [PATCH v8 11/20] OMAP2+: UART: Move errata handling from serial.c to omap-serial
[PATCHv2] ARM: OMAP: hsmmc: Fix mux for non-OMAP pins
2011-11-16 18:56 UTC
[PATCH 0/4] mmc: logging neatening and mmc_host_<level>
2011-11-16 18:38 UTC (17+ messages)
` [PATCH 1/4] mmc: Update logging style
` [PATCH 3/4] mmc: Logging neatening
` [PATCH 4/4] mmc: Add mmc_host_<level> logging
[android-building] Issues running ICS on PandaBoard?
2011-11-16 16:30 UTC
[GIT PULL] ARM: OMAP: hwmod fix for 3.2-rc3
2011-11-16 16:02 UTC
[PATCH] arm:omap:serial:cleanup: use module rev instead of cpu_is_xxxx
2011-11-16 14:53 UTC (3+ messages)
[RFC PATCH] arm:omap: cleanup & split omap2/3/4_check_revision function
2011-11-16 14:06 UTC (2+ messages)
Help with clk API
2011-11-16 10:52 UTC (4+ messages)
[PATCH 0/4] OMAPDSS: HDMI: Improve the timings logic in HDMI
2011-11-16 5:31 UTC (9+ messages)
` [PATCH 1/4] OMAPDSS: HDMI: remove duplicate video interface code
` [PATCH 2/4] OMAPDSS: HDMI: update static timing table
` [PATCH 3/4] OMAPDSS: HDMI: change the timing match logic
` [PATCH 4/4] OMAPDSS: HDMI: remove duplicate code and mode parameter
[PATCH] MTD: nand: Making MTD_NAND_OMAP2 depend on ARCH_OMAP2PLUS
2011-11-16 5:19 UTC (3+ messages)
[PATCH v4-rebased 0/7] iommu: split mapping to page sizes as supported by the hardware
2011-11-15 15:49 UTC (2+ messages)
[PATCH v3 2/2] OMAPDSS: HDMI: Disable DDC internal pull up
2011-11-15 13:50 UTC
[PATCH v3 1/2] OMAPDSS: HDMI: Move duplicate code from boardfile
2011-11-15 13:50 UTC
[RFC 0/5] OMAP groundwork for IOMMU-based DMA API
2011-11-15 11:18 UTC (14+ messages)
` [RFC 3/5] ARM: OMAP: iommu: declare a private iommu binding struct
` [RFC 4/5] ARM: OMAP3: bind omap3isp_device to its iommu device
` [RFC 5/5] iommu/omap: eliminate the public omap_find_iommu_device() method
[PATCH] OMAP2+: UART: Make the SERIAL_OMAP depend on ARCH_OMAP2PLUS
2011-11-15 9:46 UTC (3+ messages)
[GIT PULL] ARM: OMAP: DSS hwmod/reset fixes for 3.2
2011-11-15 7:06 UTC (10+ messages)
[PATCH 0/4] omap hsmmc device tree support
2011-11-15 4:15 UTC (4+ messages)
` [PATCH 2/4] mmc: omap: adapt the hsmmc driver to device tree
3.2-rc1 boot broken on OMAP1 / Amstrad E3
2011-11-14 18:24 UTC (13+ messages)
` [PATCH] ARM: OMAP: Fix map_io for "
` [PATCH] ARM: OMAP: Fix reprogramming of dpll1 rate
` DEBUG_LL on OMAP1 (was Re: [PATCH] ARM: OMAP: Fix map_io for Amstrad E3)
[GIT PULL] bug fixes for gpio drivers
2011-11-14 17:46 UTC
[PATCH 0/3] OMAPDSS: fixes for rc
2011-11-14 15:01 UTC (4+ messages)
` [PATCH 1/3] OMAPDSS: HDMI: fix returned HDMI pixel clock
` [PATCH 2/3] OMAPFB: fix compilation warnings due to missing include
` [PATCH 3/3] OMAPDSS: DISPC: skip scaling calculations when not scaling
[PATCH 1/2 v4] OMAP2+: hwmod: Add API to enable IO ring wakeup
2011-11-14 12:54 UTC (4+ messages)
` [REPOST PATCH "
[PATCH v2 1/2] OMAPDSS: HDMI: Move duplicate code from boardfile to
2011-11-14 7:05 UTC (9+ messages)
` [PATCH v2 2/2] OMAPDSS: HDMI: Disable HDMI DDC internal pull up
[PATCH 1/1] OMAP: DSS2: Add TI Boxer display panel driver
2011-11-13 17:18 UTC (2+ messages)
[QUESTION] omap iommu: a generic IOMMU?
2011-11-13 14:47 UTC (4+ messages)
[PATCH v4 0/7] iommu: split mapping to page sizes as supported by the hardware
2011-11-13 1:43 UTC (14+ messages)
` [PATCH v4 2/7] iommu/core: "
` Changing IOMMU-API for generic DMA-mapping "
GoodDay
2011-11-13 1:08 UTC
Pet Peaves about Platform code, and arch_reset
2011-11-11 16:43 UTC (9+ messages)
` [PATCH] ARM: OMAP: Introduce local common.h files
[PATCH v5 0/7] arm: pmu: support pmu/perf on OMAP4
2011-11-11 15:22 UTC (12+ messages)
` [PATCH v5 4/7] arm: omap4: hwmod: introduce emu hwmod
[PATCH v7 15/21] OMAP2+: UART: Make the RX_TIMEOUT for DMA configurable for each UART
2011-11-11 10:17 UTC (8+ messages)
` [PATCH v7 17/21] OMAP2+: UART: Remove omap_uart_can_sleep and add pm_qos
[PATCH v7 00/21] OMAP2+: UART: Runtime adaptation + cleanup
2011-11-11 10:14 UTC (4+ messages)
` [PATCH v7 11/21] OMAP2+: UART: Move errata handling from serial.c to omap-serial
[PATCH v8 15/20] OMAP2+: UART: Make the RX_TIMEOUT for DMA configurable for each UART
2011-11-11 10:01 UTC (5+ messages)
` [PATCH v8 16/20] OMAP2+: UART: remove temporary variable used to count uart instance
` [PATCH v8 17/20] OMAP2+: UART: Use custom activate func for console uart
` [PATCH v8 18/20] OMAP2+: UART: Avoid uart idling on suspend for no_console_suspend usecase
` [PATCH v8 19/20] OMAP2+: UART: Do not gate uart clocks if used for debug_prints
[PATCH v8 20/20] OMAP2+: UART: Remove omap_uart_can_sleep and add pm_qos
2011-11-11 10:02 UTC
[PATCH v8 14/20] OMAP2+: UART: Allow UART parameters to be configured from board file
2011-11-11 9:59 UTC
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox