messages from 2013-02-26 17:31:21 to 2013-03-04 11:57:52 UTC [more...]
[PATCH 00/14] ARM: OMAP2+: GPMC clean-up and DT update
2013-03-04 11:57 UTC (25+ messages)
` [PATCH 04/14] ARM: OMAP2+: Add function for configuring GPMC settings
` [PATCH 06/14] ARM: OMAP2+: Convert NAND to use gpmc_cs_program_settings()
` [PATCH 10/14] ARM: OMAP2+: Add function to read GPMC settings from device-tree
` [PATCH 11/14] ARM: OMAP2+: Add device-tree support for NOR flash
` [PATCH 12/14] ARM: OMAP2+: Add additional GPMC timing parameters
` [PATCH 13/14] ARM: OMAP2+: Convert NAND to retrieve GPMC settings from DT
` [PATCH 14/14] ARM: OMAP2+: Convert ONENAND "
[RFC PATCH 2/3] ARM: AM33XX: hwmod: Add hwmod data for debugSS
2013-03-04 11:35 UTC
[RFC PATCH 3/3] ARM: OMAP2+: Add command line parameter for debugSS module control
2013-03-04 11:35 UTC
[RFC PATCH 0/3] ARM: OMAP2+: Add command line parameter for debugSS module control
2013-03-04 11:35 UTC
[RFC PATCH 1/3] ARM: AM33XX: clock: Add debugSS clock nodes to clock tree
2013-03-04 11:35 UTC
Latest randconfig build errors
2013-03-04 9:51 UTC
3.9.0-rc1 - [ BUG: swapper/0/1 still has locks held! ]
2013-03-04 9:33 UTC
[PATCH v2 00/10] usb: dwc3/xhci/phy: Enable runtime power management
2013-03-04 8:08 UTC (16+ messages)
` [PATCH v2 02/10] USB: dwc3: Adjust runtime pm to allow autosuspend
` [PATCH v2 03/10] usb: dwc3: Enable runtime pm only after PHYs are initialized
` [PATCH v2 01/10] usb: phy: Add APIs for runtime power management
` [PATCH v2 04/10] usb: dwc3: Add runtime power management callbacks
` [PATCH v2 06/10] usb: xhci: Enable runtime pm in xhci-plat
` [PATCH v2 05/10] usb: dwc3: exynos: Enable runtime power management
` [PATCH v2 07/10] usb: phy: samsung: Enable runtime power management on usb3phy
` [PATCH v2 08/10] usb: phy: samsung: Add support for external reference clock
` [PATCH v2 09/10] usb: phy: samsung: Add support for PHY ref_clk gpio
[PATCH resend] hsi: fix kernel-doc warnings
2013-03-04 2:58 UTC (3+ messages)
[PATCH 0/5] usb: musb: am335x support
2013-03-03 23:53 UTC (9+ messages)
[PATCH 0/2] gpio/omap: updates for v3.10
2013-03-02 19:40 UTC (11+ messages)
` [PATCH 1/2] gpio/omap: convert gpio irq domain to linear mapping
` [PATCH 2/2] gpio/omap: warn if bank is not enabled on setting irq type
[PATCH] ASoC: omap: Check regulator enable for DAC on Pandora
2013-03-03 9:11 UTC (3+ messages)
[PATCH 08/14] MAINTAINERS: fix mach-omap2 clockdomain/powerdomain
2013-03-03 1:53 UTC
[PATCH 0/5] gpio/omap: Cleanup and adaptation to Device Tree
2013-03-02 20:05 UTC (32+ messages)
` [PATCH 3/5] gpio/omap: Add DT support to GPIO driver
[PATCH RFC] usb: dwc3: Set GCTL.PrtCapDir based on selected mode
2013-03-02 13:25 UTC (2+ messages)
` [PATCH] usb: dwc3: Set DWC3 context's mode "
[PATCH 00/15] ARM: OMAP5: PM: Add MPUSS suspend and CPUidle support
2013-03-02 6:47 UTC (42+ messages)
` [PATCH 01/15] ARM: OMAP4+: PM: Consolidate MPU subsystem PM code for re-use
` [PATCH 02/15] ARM: OMAP5: PM: Update CPU context register offset
` [PATCH 03/15] ARM: OMAP4+: PM: Consolidate and use OMAP4 PM code for OMAP5
` [PATCH 04/15] ARM: OMAP5: PM: Set MPUSS-EMIF clock-domain static dependency
` [PATCH 05/15] ARM: OMAP5: PM: Enables ES2 PM mode by default
` [PATCH 06/15] ARM: OMAP5: PM: Enable Mercury retention mode on CPUx powerdomains
` [PATCH 07/15] ARM: OMAP5: Add init_late() hook to enable pm initialization
` [PATCH 08/15] ARM: OMAP5: PM: Add CPU power off mode support
` [PATCH 09/15] ARM: OMAP4+: PM: Restore CPU power state to ON with clockdomain force wakeup method
` [PATCH 10/15] ARM: OMAP5: PM: Add MPU Open Switch Retention support
` [PATCH 11/15] ARM: OMAP5: PM: Add L2 memory power down support
` [PATCH 12/15] ARM: OMAP4+: CPUidle: Cleanup idle driver for OMAP5 support
` [PATCH 13/15] ARM: OMAP4+: CPUidle: Deprecate use of omap4_mpuss_read_prev_context_state()
` [PATCH 14/15] ARM: OMAP4+: CPUidle: Add OMAP5 idle driver support
` [PATCH 15/15] ARM: OMAP5: PM: handle device instance for for coldreset
[PATCH] arm: dts: Add uart1 and uart2 to igep boards
2013-03-02 1:52 UTC (7+ messages)
omap: IORESOURCE_IRQ flags not set when defining a GPIO-IRQ from DT
2013-03-02 0:00 UTC (4+ messages)
[PATCH] arm: omap: RX-51: ARM errata 430973 workaround
2013-03-01 23:51 UTC (2+ messages)
DT GPMC SRAM and NOR flash support ?
2013-03-01 22:23 UTC (12+ messages)
omapdss wakeup issues
2013-03-01 21:06 UTC (3+ messages)
[PATCH] arm/dts: Add basic support for gta04 (Openmoko next generation) board
2013-03-01 20:40 UTC (2+ messages)
[PATCH] arm: omap: RX-51: ARM errata 430973 workaround
2013-03-01 14:38 UTC (2+ messages)
[PATCH 1/3] mtd nand : onfi need to be probed in 8 bits mode
2013-03-01 14:02 UTC (11+ messages)
AM335x pinctrl error -19 (-ENODEV)
2013-03-01 13:06 UTC (3+ messages)
[PATCH] arm: omap: RX-51: ARM errata 430973 workaround
2013-03-01 9:43 UTC (3+ messages)
1GHz support for OMAP3
2013-03-01 8:17 UTC
[PATCH RFC] usb: dwc3: Get PHY from platform specific dwc3 dt node
2013-03-01 6:41 UTC (8+ messages)
[PATCH] arm/omap2: Fix build failures
2013-02-28 21:51 UTC (2+ messages)
[PATCH] OMAP3 ROM Random Number Generator support
2013-02-28 18:05 UTC
OMAP CLK / CM data move to /drivers/clk
2013-02-28 13:48 UTC (4+ messages)
[PATCH] board-overo.c: enable TWL4030 power off
2013-02-28 12:44 UTC
crypto: omap-sham, omap-aes and dma_request_slave_channel_compat()
2013-02-28 4:24 UTC (4+ messages)
[PATCH RESEND 0/1] ARM: DTS: OMAP4: Add OMAP4 Blaze Tablet support
2013-02-27 11:43 UTC (2+ messages)
` [PATCH RESEND 1/1] "
[PATCH 00/15] staging: omap-thermal fixes and ports
2013-02-27 10:51 UTC (18+ messages)
` [PATCH 01/15] staging: omap-thermal: Add print when TSHUT temperature reached
` [PATCH 02/15] staging: omap-thermal: introduce clock feature flag
` [PATCH 03/15] staging: omap-thermal: update OMAP54xx conv_table
` [PATCH 04/15] staging: omap-thermal: standardize register nomenclature to use 'GPU'
` [PATCH 05/15] staging: omap-thermal: remove from register map soc and mode on OMAP5
` [PATCH 06/15] staging: omap-thermal: introduce new features of OMAP54xx
` [PATCH 07/15] staging: omap-thermal: update OMAP54xx clock sources
` [PATCH 08/15] staging: omap-thermal: update feature bitfield for OMAP54xx
` [PATCH 09/15] staging: omap-thermal: remove dedicated counter register for OMAP5
` [PATCH 10/15] staging: omap-thermal: introduze FREEZE_BIT feature
` [PATCH 11/15] staging: omap-thermal: update DT entry documentation
` [PATCH 12/15] staging: omap-thermal: add DT example for OMAP54xx devices
` [PATCH 13/15] staging: omap-thermal: Remove double conv_table reference
` [PATCH 14/15] staging: omap-thermal: name data files accordingly
` [PATCH 15/15] staging: omap-thermal: update clock prepare count
[PATCH 0/4] usb: dwc3/xhci: Enable runtime power management
2013-02-27 8:53 UTC (6+ messages)
` [PATCH 2/4] USB: dwc3: Adjust runtime pm the dwc3 driver to allow runtime suspend
[PATCH V2] ARM: dts: omap3-devkit8000: Enable audio support
2013-02-27 2:42 UTC (3+ messages)
FW: [PATCH V4] ARM: dts: add minimal DT support for DevKit8000
2013-02-27 2:33 UTC
[PATCH V3 0/2] ARM: dts: Add DT bindings for OMAP SDMA
2013-02-26 18:27 UTC (3+ messages)
` [PATCH V3 1/2] ARM: dts: OMAP2+: Add SDMA controller bindings and nodes
` [PATCH V3 2/2] dmaengine: OMAP: Register SDMA controller with Device Tree DMA driver
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox