messages from 2013-11-21 15:08:48 to 2013-11-25 21:45:13 UTC [more...]
[PATCH 0/7] AES/DES hwmod data and dmtimer fix
2013-11-25 21:44 UTC (7+ messages)
` [PATCH 1/7] ARM: OMAP: hwmod: Add SYSC offsets for AES IP
` [PATCH 2/7] ARM: DRA7xx: hwmod: Add hwmod data for DES IP
` [PATCH 3/7] ARM: DRA7xx: hwmod: Add hwmod data for AES IP
` [PATCH 4/7] ARM: OMAP4: "
` [PATCH 5/7] ARM: OMAP4: hwmod: add hwmod data for DES IP
` [PATCH 7/7] OMAP: AM33xx: hwmod: Correct AES module SYSC type
[PATCH v2 0/4] musb/dsps: suspend related patches for 3.14 (rebased)
2013-11-25 21:32 UTC (8+ messages)
` [PATCH v2 1/4] usb: musb: unconditionally save and restore the context on suspend
` [PATCH v2 2/4] usb: musb: call musb_port_suspend from musb_bus_suspend
` [PATCH v2 3/4] usb: musb: dsps: add {tx,rx}_mode to wrapper
` [PATCH v2 4/4] usb: musb: dsps: add support for suspend and resume
[PATCH v2 0/7] Make dwc3 use Generic PHY Framework
2013-11-25 21:32 UTC (5+ messages)
` [PATCH v2 1/7] usb: dwc3: get "usb_phy" only if the platform indicates the presence of PHY's
[PATCH] Allow MUSB DSPS to use "force host" mode
2013-11-25 21:24 UTC (9+ messages)
[PATCH v3 00/10] Make dwc3 use Generic PHY Framework
2013-11-25 21:21 UTC (12+ messages)
` [PATCH v3 01/10] usb: dwc3: invoke phy_resume after phy_init
` [PATCH v3 02/10] usb: dwc3: power off usb phy in error path
` [PATCH v3 03/10] usb: dwc3: preparation for adapting dwc3 to generic phy framework
` [PATCH v3 04/10] usb: dwc3: use quirks to know if a particualr platform doesn't have PHY
` [PATCH v3 05/10] usb: dwc3: adapt dwc3 core to use Generic PHY Framework
` [PATCH v3 06/10] Documentation: dt bindings: move ..usb/usb-phy.txt to ..phy/ti-phy.txt
` [PATCH v3 07/10] drivers: phy: usb3/pipe3: Adapt pipe3 driver to Generic PHY Framework
` [PATCH v3 08/10] usb: phy: omap-usb2: remove *set_suspend* callback from omap-usb2
` [PATCH v3 09/10] phy: omap-usb2: move omap_usb.h from linux/usb/ to linux/phy/
` [PATCH v3 10/10] arm/dts: added dt properties to adapt to the new phy framwork
ARM: v3.13-rc1: USB regression
2013-11-25 21:12 UTC (5+ messages)
[PATCH 0/5] musb/dsps: suspend related patches for 3.14 (rebased)
2013-11-25 20:55 UTC (29+ messages)
` [PATCH 1/5] usb: musb: conditionally save and restore the context on suspend
` [PATCH 2/5] usb: musb: call musb_port_suspend from musb_bus_suspend
` [PATCH 3/5] usb: musb: dsps: add {tx,rx}_mode to wrapper
` [PATCH 4/5] usb: musb: dsps: add support for suspend and resume
` [PATCH 5/5] usb: musb: dsps: indentation and whitespace fixes
[PATCH] ARM: dts: Fix omap serial wake-up when booted with device tree
2013-11-25 20:11 UTC
[PATCH 0/2] ARM: OMAP5: Couple of patches for KVM
2013-11-25 19:44 UTC (12+ messages)
` [PATCH 1/2] ARM: dts: OMAP5: Add maintenance interrupt for virtualisation
` [PATCH 2/2] ARM: OMAP5: Add HYP mode entry support for secondary CPUs
` HYP Kernel boot requirements [Was ...Re: [PATCH 2/2] ARM: OMAP5: Add HYP mode entry support for secondary CPUs]
` HYP Kernel boot requirements
[PATCH 0/4] Add support for charging battery in Nokia RX-51
2013-11-25 19:16 UTC (20+ messages)
` [PATCH v2 0/3] "
` [PATCH v2 1/3] power_supply: Add power_supply notifier
` [PATCH v2 2/3] bq2415x_charger: Use power_supply notifier for automode
` [PATCH v2 3/3] RX-51: Add platform data for bq24150a charger
[PATCH v2 2/3] bq2415x_charger: Use power_supply notifier for automode
2013-11-25 18:32 UTC
[PATCH] usb: musb: Fix unstable init of OTG_INTERFSEL
2013-11-25 17:56 UTC (2+ messages)
OMAP build failure after this merge window - caused by usb or phy Kconfig krap
2013-11-25 17:55 UTC (3+ messages)
Help needed to force USB host mode on AM335x CPU
2013-11-25 17:50 UTC (2+ messages)
[PATCH v6] ARM: omap: edma: add suspend suspend/resume hooks
2013-11-25 17:34 UTC (2+ messages)
[PATCH v2 2/3] bq2415x_charger: Use power_supply notifier for automode
2013-11-25 17:14 UTC (2+ messages)
[PATCH v2] ARM: configs: OMAP2+: Enable PREEMPT and crypto USER API config
2013-11-25 17:05 UTC
[PATCH] ARM: configs: OMAP2+: Enable PREEMPT and crypto USER API config
2013-11-25 16:47 UTC
OMAP baseline test results for v3.13-rc1 (toolchain Debian 4.7.2-5)
2013-11-25 16:30 UTC (3+ messages)
[PATCH] ARM: dts: omap3-beagle: Fix USB host on beagle boards (for 3.13)
2013-11-25 15:50 UTC (2+ messages)
[PATCH v2 00/11]: add remaining support for IGEP boards
2013-11-25 15:30 UTC (2+ messages)
[PATCH v3 0/3] mmc: omap_hsmmc: Enable SDIO IRQ
2013-11-25 13:26 UTC (4+ messages)
` [PATCH v3 1/3] "
` [PATCH v3 2/3] mmc: omap_hsmmc: Pin remux workaround to support SDIO interrupt on AM335x
` [PATCH v3 3/3] mmc: omap_hsmmc: Extend debugfs for SDIO IRQ, GPIO and pinmux
[PATCH 0/6] OMAPDSS: suspend/resume improvements
2013-11-25 1:29 UTC (5+ messages)
` [PATCH 1/6] OMAPDSS: APPLY: set infos to dirty on enable
` [PATCH 6/6] OMAPDSS: use runtime PM's autosuspend
[PATCH 0/3] DT support for bq2415x
2013-11-25 13:07 UTC (7+ messages)
` [PATCH 1/3] power_supply: add power_supply_get_by_phandle
` [PATCH 2/3] bq2415x_charger: add DT support
` [PATCH 3/3] dt: binding documentation for bq2415x charger
верните себе реальность превосходно замечать
2013-11-25 9:16 UTC
OMAP baseline test results for v3.13-rc1 (toolchain CodeSourcery 2010.09-50)
2013-11-25 7:31 UTC
[PATCH 0/5] Prepare making omap3 device tree only and convert LDP
2013-11-23 21:09 UTC (8+ messages)
` N900 board code in 3.14
[PATCH 0/5] N900 DT support for N900 panel
2013-11-23 20:57 UTC (6+ messages)
` [PATCH 1/5] OMAPDSS: ACX565AKM: Add basic DT support
` [PATCH 2/5] DTS: ARM: OMAP3-N900: Add vendor prefixes to SPI devices
` [PATCH 3/5] DTS: ARM: OMAP3-N900: Add reset gpio to lcd node
` [PATCH 4/5] OMAPDSS: SDI: Use V28 as regulator for N900
` [PATCH 5/5] Documentation: dt: Document ACX565AKM DT binding
[PATCH v4 0/4] pm: Add power off control
2013-11-23 17:23 UTC (5+ messages)
` [rtc-linux] "
[PATCH 0/8] OMAP: timers: Preparation for migration to clocksource
2013-11-23 16:26 UTC (26+ messages)
` [PATCH 1/8] ARM: OMAP: Move public portion of dmtimer.h to include/linux/omap-timer.h
` [PATCH 2/8] rc: ir-rx51: Use clk API to get clock rate
` [PATCH 3/8] rc: ir-rx51: Turn ON ir-rx51 as it should work for MULTIPLATFORM
` [PATCH 4/8] ARM: OMAP4: timer: Remove non-DT code for TWD timer
` [PATCH 5/8] ARM: OMAP2+: timer: Introduce OF-friendly clocksource/clockevent system timers
` [PATCH 6/8] devicetree: doc: Document ti,timer-parent property
` [PATCH 7/8] ARM: DTS: am33xx: Provide the "
` [PATCH 8/8] ARM: AM33xx: Move to using omap_generic_timer_init for init_time
[PATCH 0/2] OMAP3 ROM Random Number Generator support
2013-11-23 12:09 UTC (5+ messages)
` [PATCH v2 2/3] hwrng: "
PRIVATE MESSAGE
2013-11-23 10:36 UTC
[BUG] PandaBoard hangs before starting init while booting v3.12
2013-11-23 3:27 UTC (5+ messages)
Status of 1GHz support on am37xx
2013-11-22 23:01 UTC
[PATCH 0/3] Yet more fixes for booting omaps with device tree
2013-11-22 17:14 UTC (8+ messages)
` [PATCH 1/3] ARM: OMAP2+: Fix more missing data for omap3.dtsi file
` [PATCH 2/3] ARM: OMAP2+: Add fixed regulator to omap2plus_defconfig
` [PATCH 3/3] ARM: OMAP2+: Fix eMMC on n900 with device tree
Personal email(22 November 2013)
2013-11-22 5:38 UTC
commit c368e5fc2a190923b786f2de3e79430ea3566a25 regresses MMC
2013-11-22 1:56 UTC (12+ messages)
[RFCv2 0/3] OMAP SSI driver
2013-11-21 23:38 UTC (6+ messages)
` [RFCv2 3/3] ARM: dts: N900: Add SSI information
[PATCH] ARM: OMAP2+: Fix populating the hwmod data from device tree
2013-11-21 20:48 UTC (7+ messages)
[PATCH 0/2] ARM: dts: omap4: Fix pin muxing for wl12xx
2013-11-21 17:27 UTC (4+ messages)
` [PATCH 1/2] ARM: dts: omap4-panda-common: "
[PATCH v2 06/10] mmc: omap_hsmmc: add support for pbias configuration in dt
2013-11-21 17:03 UTC (6+ messages)
` [RFC PATCH v3 0/8] mmc: omap_hsmmc: pbias dt and cleanup
` [RFC PATCH v3 1/8] mmc: omap_hsmmc: use devm_regulator API
` [RFC PATCH v3 6/8] ARM: dts: add pbias-supply
безразлично какая синьора увидит Оргазм
2013-11-21 15:59 UTC
[PATCHv5 10/20] arm: dts: add omap4430 thermal data
2013-11-21 15:36 UTC (3+ messages)
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox