RE: [PATCH 0/5] omap2+: mux: Add support for static and dynamic pads.

[Sricharan R <r.sricharan@ti.com>]

Hi Tony,

>-----Original Message-----
>From: sricharan [mailto:r.sricharan@ti.com]
>Sent: Friday, January 28, 2011 10:38 AM
>To: r.sricharan@ti.com; linux-omap@vger.kernel.org
>Cc: santosh.shilimkar@ti.com; tony@atomide.com; paul@pwsan.com
>Subject: [PATCH 0/5] omap2+: mux: Add support for static and dynamic
pads.
>
>
>1) The support to add the pad data to the device hwmod entry and to use
>   it to dynamically configure the pads based on the state of the
>   hwmod is already present.
>
>2) But using that for pads that requires only initialisation and not
>   dynamic remux, brings in a overhead to iterate over all the
>   hwmod signals of the device for every device enable/idle transitions.
>
>3) By seperating the pads that requires remux as dynamic and the
>   ones that do not as static the above overhead is avoided.
>
>4) This way the static and dynamic pads are initialised,
>   and only dynamic pads are taken for remuxing.
>
>sricharan (5):
>  omap2+: mux: Seperate the pads of a hwmod as static and dynamic.
>  omap4: board-4430sdp: Initialise the serial pads
>  omap3: board-3430sdp: Initialise the serial pads.
>  omap4: board-omap4panda: Initialise the serial pads
>  omap2+: board-n8x0: Change the flags for the serial pads.
>
Any comments on this??

Thanks,
  Sricharan