Linux on ARM based TI OMAP SoCs
 help / color / mirror / Atom feed
From: Adrian Hunter <adrian.hunter@intel.com>
To: Kishon Vijay Abraham I <kishon@ti.com>,
	Ulf Hansson <ulf.hansson@linaro.org>
Cc: Rob Herring <robh+dt@kernel.org>,
	Mark Rutland <mark.rutland@arm.com>,
	linux-mmc@vger.kernel.org, devicetree@vger.kernel.org,
	linux-kernel@vger.kernel.org, linux-omap@vger.kernel.org,
	Tony Lindgren <tony@atomide.com>
Subject: Re: [PATCH v4 01/12] mmc: sdhci-omap: Fix when capabilities are obtained from SDHCI_CAPABILITIES reg
Date: Thu, 26 Apr 2018 10:57:33 +0300	[thread overview]
Message-ID: <e083256d-96f8-3f1e-76d1-8062dcfd1a21@intel.com> (raw)
In-Reply-To: <20180425120937.29867-2-kishon@ti.com>

On 25/04/18 15:09, Kishon Vijay Abraham I wrote:
> sdhci_omap_config_iodelay_pinctrl_state() requires caps and caps2 to be
> initialized (speed mode capabilities like UHS/HS200) before it is
> invoked. While mmc_of_parse() initializes caps/caps2 if capabilities is
> populated in device tree, it will remain uninitialized for capabilities
> obtained from SDHCI_CAPABILITIES register.
> Fix sdhci_omap_config_iodelay_pinctrl_state() to be used even while
> getting the capabilities from SDHCI_CAPABILITIES register by invoking
> sdhci_setup_host() before sdhci_omap_config_iodelay_pinctrl_state().
> 
> Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
> Acked-by: Tony Lindgren <tony@atomide.com>

Acked-by: Adrian Hunter <adrian.hunter@intel.com>

> ---
>  drivers/mmc/host/sdhci-omap.c | 17 ++++++++++++-----
>  1 file changed, 12 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/mmc/host/sdhci-omap.c b/drivers/mmc/host/sdhci-omap.c
> index 1456abd5eeb9..9bb53702e0e5 100644
> --- a/drivers/mmc/host/sdhci-omap.c
> +++ b/drivers/mmc/host/sdhci-omap.c
> @@ -916,10 +916,6 @@ static int sdhci_omap_probe(struct platform_device *pdev)
>  		goto err_put_sync;
>  	}
>  
> -	ret = sdhci_omap_config_iodelay_pinctrl_state(omap_host);
> -	if (ret)
> -		goto err_put_sync;
> -
>  	host->mmc_host_ops.get_ro = mmc_gpio_get_ro;
>  	host->mmc_host_ops.start_signal_voltage_switch =
>  					sdhci_omap_start_signal_voltage_switch;
> @@ -930,12 +926,23 @@ static int sdhci_omap_probe(struct platform_device *pdev)
>  	sdhci_read_caps(host);
>  	host->caps |= SDHCI_CAN_DO_ADMA2;
>  
> -	ret = sdhci_add_host(host);
> +	ret = sdhci_setup_host(host);
>  	if (ret)
>  		goto err_put_sync;
>  
> +	ret = sdhci_omap_config_iodelay_pinctrl_state(omap_host);
> +	if (ret)
> +		goto err_cleanup_host;
> +
> +	ret = __sdhci_add_host(host);
> +	if (ret)
> +		goto err_cleanup_host;
> +
>  	return 0;
>  
> +err_cleanup_host:
> +	sdhci_cleanup_host(host);
> +
>  err_put_sync:
>  	pm_runtime_put_sync(dev);
>  
> 

  reply	other threads:[~2018-04-26  7:57 UTC|newest]

Thread overview: 19+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2018-04-25 12:09 [PATCH v4 00/12] mmc: sdhci-omap: Add UHS/HS200 mode support Kishon Vijay Abraham I
2018-04-25 12:09 ` [PATCH v4 01/12] mmc: sdhci-omap: Fix when capabilities are obtained from SDHCI_CAPABILITIES reg Kishon Vijay Abraham I
2018-04-26  7:57   ` Adrian Hunter [this message]
2018-04-25 12:09 ` [PATCH v4 02/12] mmc: sdhci-omap: Remove setting ADMA capability in driver Kishon Vijay Abraham I
2018-04-25 12:09 ` [PATCH v4 03/12] mmc: sdhci-omap: Workaround for Errata i843 Kishon Vijay Abraham I
2018-04-25 12:09 ` [PATCH v4 04/12] mmc: sdhci-omap: Invoke sdhci_get_of_property to read sdhci dt properties Kishon Vijay Abraham I
2018-04-25 12:09 ` [PATCH v4 05/12] mmc: sdhci: Disable HS200/HS400 mode if controller can't support 1.8v Kishon Vijay Abraham I
2018-04-26  8:55   ` Adrian Hunter
2018-04-26 10:08     ` Kishon Vijay Abraham I
2018-04-26 10:40       ` Adrian Hunter
2018-04-25 12:09 ` [PATCH v4 06/12] mmc: sdhci: Add quirk to disable HW timeout Kishon Vijay Abraham I
2018-04-25 12:09 ` [PATCH v4 07/12] mmc: sdhci: Factor out target_timeout calculation Kishon Vijay Abraham I
2018-04-25 12:09 ` [PATCH v4 08/12] mmc: sdhci: Program a relatively accurate SW timeout value Kishon Vijay Abraham I
2018-04-26  7:52   ` Adrian Hunter
2018-04-25 12:09 ` [PATCH v4 09/12] mmc: sdhci-omap: Workaround for Errata i834 Kishon Vijay Abraham I
2018-04-26  7:53   ` Adrian Hunter
2018-04-25 12:09 ` [PATCH v4 10/12] dt-bindings: sdhci-omap: Add K2G specific binding Kishon Vijay Abraham I
2018-04-25 12:09 ` [PATCH v4 11/12] mmc: sdhci-omap: Add support for MMC/SD controller in k2g SoC Kishon Vijay Abraham I
2018-04-25 12:09 ` [PATCH v4 12/12] mmc: sdhci-omap: Add sdhci_omap specific ops for enable_sdio_irq Kishon Vijay Abraham I

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=e083256d-96f8-3f1e-76d1-8062dcfd1a21@intel.com \
    --to=adrian.hunter@intel.com \
    --cc=devicetree@vger.kernel.org \
    --cc=kishon@ti.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mmc@vger.kernel.org \
    --cc=linux-omap@vger.kernel.org \
    --cc=mark.rutland@arm.com \
    --cc=robh+dt@kernel.org \
    --cc=tony@atomide.com \
    --cc=ulf.hansson@linaro.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox