From mboxrd@z Thu Jan 1 00:00:00 1970 From: James Bottomley Subject: Re: Issue booting v2.6.39 .. v3.4-rc6 on hp712/100 Date: Tue, 15 May 2012 09:09:26 +0100 Message-ID: <1337069366.3005.10.camel@dabdike.lan> References: <4FA9975C.5060708@bergerie> <41786065.U2qKzXR3uX@donald.sf-tec.de> <4FAA9382.7040802@bell.net> <4FAADE2A.9080803@bergerie> <4FAEE943.2030203@gmx.de> <4FB182F8.2040403@gmx.de> Mime-Version: 1.0 Content-Type: text/plain; charset="UTF-8" Cc: Helge Deller , Vincent , Rolf Eike Beer , linux-parisc@vger.kernel.org To: John David Anglin Return-path: In-Reply-To: List-ID: List-Id: linux-parisc.vger.kernel.org On Mon, 2012-05-14 at 18:38 -0400, John David Anglin wrote: > On 14-May-12, at 6:11 PM, Helge Deller wrote: > > > The B160L and the 715/64 (both 32bit-only PA1.X machines) crashed > > with the following trace. > > All logs attached. > > > > Any ideas? > > This is exactly the same failure as reported by Vincent. > > The most likely problem is the PA 1.1 tmpalias support in entry.S is > broken. For example, > the cache stride that is loaded in flush_dcache_page_asm to register > r1 is wrong. Probably, > the do_alias macro is wrong for PA 1.1. This is hunk of code that > should be executed > when a fdc non access fault occurs. > > nadtlb_check_alias_11: > do_alias spc,t0,t1,va,pte,prot,nadtlb_emulate > > idtlba pte,(va) > idtlbp prot,(va) > > rfir > nop > > The TLB insert instructions on PA 1.1 have a different format than on > PA 2.0. I'm not sure > how this would corrupt r1. > > On the other hand, I had asked Vincent to put a "b,n ." instruction > just before the fdc loop, > boot, hit the TOC button, and capture the setup registers for the > flush operation. It's possible > the stride variable has been clobbered. Actually, I don't think it's that. I built a PA 1.1 only kernel and booted it successfully on the C360. That exercises all the _11 paths, so I don't think there's a code fault. I do think there's a non PA1.1 instruction in there somewhere that the C360 wouldn't notice. James