From mboxrd@z Thu Jan 1 00:00:00 1970 Return-Path: Received: from puffin.external.hp.com (puffin.external.hp.com [192.25.206.4]) by dsl2.external.hp.com (Postfix) with ESMTP id CCFC2482B for ; Fri, 26 Oct 2001 12:41:44 -0600 (MDT) Message-Id: <200110261838.MAA13212@puffin.external.hp.com> To: Daniel Williams Cc: parisc-linux@lists.parisc-linux.org, grundler@puffin.external.hp.com Subject: Re: [parisc-linux] How to Boot CD on C110 In-Reply-To: Message from Daniel Williams of "Fri, 26 Oct 2001 00:32:56 CDT." Date: Fri, 26 Oct 2001 12:38:01 -0600 From: Grant Grundler Sender: parisc-linux-admin@lists.parisc-linux.org Errors-To: parisc-linux-admin@lists.parisc-linux.org List-Help: List-Post: List-Subscribe: , List-Id: parisc-linux developers list List-Unsubscribe: , List-Archive: Daniel Williams wrote: > OK, so SEArch should see the CD drive regardless. Should it also see > the FWSCSI internal HDs? Yes. > They don't have anything on them... But the > Firmware doesn't show anything after its done searching, not the 2 HDs, > the CD, or the DDS tape drive. hmm...PDC is pretty brain dead. Were those SCSI devices shipped with the C110 or installed later? > Whats that about CD option jumpers set wrong? > What should the correct configuration be? The pins that it has > on the back (its a HP branded toshiba XM-5401B 50pin narrow) are ID1, > ID2, ID4, PRTY, PRV/ALW, TEST, and TERM. ID2 and PRTY have jumpers > connected, the rest are not shorted. I don't know what they should be - I don't have the product manual. ID2/PRTY sound like they are correct. I don't konw what PRV/ALW means. (Prevent/Allow what?). TERM should probably be left disconnected. BTW, just because the drive is from HP doesn't mean it's setup to work w/ an HP workstation. Firmware on the drive could do things that confuse PDC/IODC. > nor does SEA see it. You need to figure this output first...try a different drive perhaps. The FWD drives not being seen concerns me just as much. grant