RE: [parisc-linux] RAID issues on my C3000

["Joel Soete" <jsoe0708@tiscali.be>]

>
>Hey all,
>I was just following the RAID HOWTO posted awile back and I ran into a few
>problems.

I do also for at least 3 of my b180 and it works fine :)


>  I've gotten all the way through creating my RAID partitions and
>copying the data over via tar, making it bootable (after upgrading my PALO
>from source - it is now 1.2), editing all the files on the new md devices,
>and then rebooting.  When I try to boot from the new degraded RAID disk
I
>get that the device is hard booted (with PALO 1.0 not 1.2), displays my
patition
>info (but displays the partitions as "unknown" and not RAID probably due
>to the Palo 1.0 version), and spits out "Selected kernal: /vmlinux from
partition
>2" then "Error: Partition 2 must be ext2".

This is typicaly the message from palo < 1.2 (I also encounter this same
message before figuring out that I forget to update palo on my actual root
disk).
So on your non-raid disk install the last palo dpkg (1.2) (I do it without
pb on a woody pre-libc 2.3.0).
[check the version with palo -? | grep version (must be now 1.2)]
relaunch:
# palo -f YourPathToNew/palo.conf -I YourRaidDIsk

It works for me and hope for you too.

Joel


---------------------------------
Vous surfez avec une ligne classique ?
Economisez jusqu'à 25% avec Tiscali Complete !
Offre spéciale : première année d'abonnement offerte.
... Plus d'info sur http://complete.tiscali.be