[PATCH 4.19 19/39] ARM: dts: exynos: Override thermal by label in Exynos5250

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

From: Krzysztof Kozlowski <krzk@kernel.org>

[ Upstream commit 7e86ef5cc89609cbad8b9dd2f476789c638dbb92 ]

Using full paths to extend or override a device tree node is error prone
since if there was a typo error, a new node will be created instead of
extending the node as it was desired.  This will lead to run-time errors
that could be hard to detect.

A mistyped label on the other hand, will cause a dtc compile error
(during build time).

Signed-off-by: Krzysztof Kozlowski <krzk@kernel.org>
Link: https://lore.kernel.org/r/20200901075417.22481-8-krzk@kernel.org
Stable-dep-of: 33e2c595e2e4 ("ARM: dts: exynos: correct TMU phandle in Exynos5250")
Signed-off-by: Sasha Levin <sashal@kernel.org>
---
 arch/arm/boot/dts/exynos5250.dtsi | 38 +++++++++++++++----------------
 1 file changed, 18 insertions(+), 20 deletions(-)

diff --git a/arch/arm/boot/dts/exynos5250.dtsi b/arch/arm/boot/dts/exynos5250.dtsi
index 59e5f0016b862..1883b8c2cd7b9 100644
--- a/arch/arm/boot/dts/exynos5250.dtsi
+++ b/arch/arm/boot/dts/exynos5250.dtsi
@@ -1043,26 +1043,6 @@
 		};
 	};
 
-	thermal-zones {
-		cpu_thermal: cpu-thermal {
-			polling-delay-passive = <0>;
-			polling-delay = <0>;
-			thermal-sensors = <&tmu 0>;
-
-			cooling-maps {
-				map0 {
-				     /* Corresponds to 800MHz at freq_table */
-				     cooling-device = <&cpu0 9 9>, <&cpu1 9 9>;
-				};
-				map1 {
-				     /* Corresponds to 200MHz at freq_table */
-				     cooling-device = <&cpu0 15 15>,
-						      <&cpu1 15 15>;
-			       };
-		       };
-		};
-	};
-
 	timer {
 		compatible = "arm,armv7-timer";
 		interrupts = <GIC_PPI 13 (GIC_CPU_MASK_SIMPLE(4) | IRQ_TYPE_LEVEL_LOW)>,
@@ -1078,6 +1058,24 @@
 	};
 };
 
+&cpu_thermal {
+	polling-delay-passive = <0>;
+	polling-delay = <0>;
+	thermal-sensors = <&tmu 0>;
+
+	cooling-maps {
+		map0 {
+			/* Corresponds to 800MHz at freq_table */
+			cooling-device = <&cpu0 9 9>, <&cpu1 9 9>;
+		};
+		map1 {
+			/* Corresponds to 200MHz at freq_table */
+			cooling-device = <&cpu0 15 15>,
+					 <&cpu1 15 15>;
+		};
+	};
+};
+
 &dp {
 	power-domains = <&pd_disp1>;
 	clocks = <&clock CLK_DP>;
-- 
2.39.2