[PATCH v20 17/18] x86/resctrl: Sub-NUMA Cluster (SNC) detection

[Tony Luck <tony.luck@intel.com>]

There isn't a simple hardware bit that indicates whether a CPU is
running in Sub-NUMA Cluster (SNC) mode. Infer the state by comparing
the number of CPUs sharing the L3 cache with CPU0 to the number of CPUs in
the same NUMA node as CPU0.

If SNC mode is detected, print a single informational message to the
console.

Add the missing definition of pr_fmt() to monitor.c. This wasn't
noticed before as there are only "can't happen" console messages
from this file.

Signed-off-by: Tony Luck <tony.luck@intel.com>
---
 arch/x86/kernel/cpu/resctrl/monitor.c | 66 +++++++++++++++++++++++++++
 1 file changed, 66 insertions(+)

diff --git a/arch/x86/kernel/cpu/resctrl/monitor.c b/arch/x86/kernel/cpu/resctrl/monitor.c
index efbb84c00d79..9835706ef772 100644
--- a/arch/x86/kernel/cpu/resctrl/monitor.c
+++ b/arch/x86/kernel/cpu/resctrl/monitor.c
@@ -15,6 +15,8 @@
  * Software Developer Manual June 2016, volume 3, section 17.17.
  */
 
+#define pr_fmt(fmt)	"resctrl: " fmt
+
 #include <linux/cpu.h>
 #include <linux/module.h>
 #include <linux/sizes.h>
@@ -1108,6 +1110,68 @@ void arch_mon_domain_online(struct rdt_resource *r, struct rdt_mon_domain *d)
 	wrmsrl(MSR_RMID_SNC_CONFIG, val);
 }
 
+/* CPU models that support MSR_RMID_SNC_CONFIG */
+static const struct x86_cpu_id snc_cpu_ids[] __initconst = {
+	X86_MATCH_VFM(INTEL_ICELAKE_X, 0),
+	X86_MATCH_VFM(INTEL_SAPPHIRERAPIDS_X, 0),
+	X86_MATCH_VFM(INTEL_EMERALDRAPIDS_X, 0),
+	X86_MATCH_VFM(INTEL_GRANITERAPIDS_X, 0),
+	X86_MATCH_VFM(INTEL_ATOM_CRESTMONT_X, 0),
+	{}
+};
+
+/*
+ * There isn't a simple hardware bit that indicates whether a CPU is running
+ * in Sub-NUMA Cluster (SNC) mode. Infer the state by comparing the
+ * number CPUs sharing the L3 cache with CPU0 to the number of CPUs in
+ * the same NUMA node as CPU0.
+ * It is not possible to accurately determine SNC state if the system is
+ * booted with a maxcpus=N parameter. That distorts the ratio of SNC nodes
+ * to L3 caches. It will be OK if system is booted with hyperthreading
+ * disabled (since this doesn't affect the ratio).
+ */
+static __init int snc_get_config(void)
+{
+	struct cacheinfo *ci = get_cpu_cacheinfo_level(0, RESCTRL_L3_CACHE);
+	const cpumask_t *node0_cpumask;
+	int cpus_per_node, cpus_per_l3;
+	int ret;
+
+	if (!x86_match_cpu(snc_cpu_ids) || !ci)
+		return 1;
+
+	cpus_read_lock();
+	if (num_online_cpus() != num_present_cpus())
+		pr_warn("Some CPUs offline, SNC detection may be incorrect\n");
+	cpus_read_unlock();
+
+	node0_cpumask = cpumask_of_node(cpu_to_node(0));
+
+	cpus_per_node = cpumask_weight(node0_cpumask);
+	cpus_per_l3 = cpumask_weight(&ci->shared_cpu_map);
+
+	if (!cpus_per_node || !cpus_per_l3)
+		return 1;
+
+	ret = cpus_per_l3 / cpus_per_node;
+
+	/* sanity check: Only valid results are 1, 2, 3, 4 */
+	switch (ret) {
+	case 1:
+		break;
+	case 2 ... 4:
+		pr_info("Sub-NUMA Cluster mode detected with %d nodes per L3 cache\n", ret);
+		rdt_resources_all[RDT_RESOURCE_L3].r_resctrl.mon_scope = RESCTRL_L3_NODE;
+		break;
+	default:
+		pr_warn("Ignore improbable SNC node count %d\n", ret);
+		ret = 1;
+		break;
+	}
+
+	return ret;
+}
+
 int __init rdt_get_mon_l3_config(struct rdt_resource *r)
 {
 	unsigned int mbm_offset = boot_cpu_data.x86_cache_mbm_width_offset;
@@ -1115,6 +1179,8 @@ int __init rdt_get_mon_l3_config(struct rdt_resource *r)
 	unsigned int threshold;
 	int ret;
 
+	snc_nodes_per_l3_cache = snc_get_config();
+
 	resctrl_rmid_realloc_limit = boot_cpu_data.x86_cache_size * 1024;
 	hw_res->mon_scale = boot_cpu_data.x86_cache_occ_scale / snc_nodes_per_l3_cache;
 	r->num_rmid = (boot_cpu_data.x86_cache_max_rmid + 1) / snc_nodes_per_l3_cache;
-- 
2.45.0