From mboxrd@z Thu Jan 1 00:00:00 1970 Received: from smtp.kernel.org (aws-us-west-2-korg-mail-alma10-1.taild15c8.ts.net [100.103.45.18]) (using TLSv1.2 with cipher ECDHE-RSA-AES256-GCM-SHA384 (256/256 bits)) (No client certificate requested) by smtp.subspace.kernel.org (Postfix) with ESMTPS id 4BFFF1F91F6; Tue, 13 Oct 2026 12:38:45 +0000 (UTC) Authentication-Results: smtp.subspace.kernel.org; arc=none smtp.client-ip=100.103.45.18 ARC-Seal:i=1; a=rsa-sha256; d=subspace.kernel.org; s=arc-20240116; t=1791895127; cv=none; b=DJOSKAMHgL9xRA6jTwaXFEwPZEvTvonhg+ou2iC6I1xbSOeB0CNAM4eYDtjsT11vh/5KiN8TXBRtp+aS7dotsTgNj1CqQ1cpC2P1bGCAJHdBJ/2yUdtB5xjoaDOMM4uBxC2gvlvu9tJI8LHpFe2OpFgOG55+1vWAQvuQAy9ag28= ARC-Message-Signature:i=1; a=rsa-sha256; d=subspace.kernel.org; s=arc-20240116; t=1791895127; c=relaxed/simple; bh=isPByFMMjjCVCnbcbX3U4ywss+cgmtSB89vF9AqVqCY=; h=From:To:Cc:Subject:Date:Message-ID:In-Reply-To:References: MIME-Version; b=DpEBaFic4aKATSJ4BMli4kZFlGZuyMFD7nlJGd7UUgtsv2TOEMDPAEoVLFKwYXxkP9I1IF7XcLnAnlgjnnOFPMuiCHUGHBELOii9BBsDHpCKxnB/BmLhgq4p3tE2F5gB5UFWyVrPx0viBlekFjmNiino+jm7+y5gfrGvX5TqwD8= ARC-Authentication-Results:i=1; smtp.subspace.kernel.org; dkim=pass (1024-bit key) header.d=linuxfoundation.org header.i=@linuxfoundation.org header.b=PQ1c5Dpb; arc=none smtp.client-ip=100.103.45.18 Authentication-Results: smtp.subspace.kernel.org; dkim=pass (1024-bit key) header.d=linuxfoundation.org header.i=@linuxfoundation.org header.b="PQ1c5Dpb" Received: by smtp.kernel.org (Postfix) with ESMTPSA id 4CB4E1F00893; Tue, 13 Oct 2026 12:38:45 +0000 (UTC) DKIM-Signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=linuxfoundation.org; s=korg; t=1791895125; bh=cCSDH6EHgJi1LzUgSbrptTw+dMNtm6xgsiMCvcY5Yco=; h=From:To:Cc:Subject:Date:In-Reply-To:References; b=PQ1c5Dpb3EZmnOrN1weFqc1Tm2cCJMXZkGAg1J66OPp+dibzyBsCFGwTsCWvk+TY2 Lpr9Bdi1Ul0ps4l4F2a3bkjO86dcEA4e1GH19+ULBGKszKHcCAS8rLz1ylTrLkH2Ew HrVMmchWSIfh5mnhuxMALOaKAsjabv6B5od6blxU= From: Greg Kroah-Hartman To: stable@vger.kernel.org Cc: Greg Kroah-Hartman , patches@lists.linux.dev, stable@kernel.org, Simon Gassner Subject: [PATCH 6.12 169/497] serial: tegra: dont clear the Tx FIFO on an Rx-only reset Date: Tue, 13 Oct 2026 13:35:36 +0200 Message-ID: <20261013112911.900857916@linuxfoundation.org> X-Mailer: git-send-email 2.56.0 In-Reply-To: <20261013112907.864180619@linuxfoundation.org> References: <20261013112907.864180619@linuxfoundation.org> User-Agent: quilt/0.69 X-stable: review X-Patchwork-Hint: ignore Precedence: bulk X-Mailing-List: patches@lists.linux.dev List-Id: List-Subscribe: List-Unsubscribe: MIME-Version: 1.0 Content-Transfer-Encoding: 8bit 6.12-stable review patch. If anyone has any objections, please let me know. ------------------ From: Simon Gassner commit 8aebfde6e84dceb7d47fe8001e50b754eb45d5df upstream. tegra_uart_fifo_reset() applies the Tegra30 workaround for "cannot clear the Tx FIFO while FIFO mode is enabled" unconditionally: it leaves FIFO mode, writes the requested FCR clear bits, and re-enters FIFO mode. Leaving FIFO mode empties both FIFOs, so an Rx-only reset discards queued Tx data as well. The break handler in tegra_uart_decode_rx_error() calls it with UART_FCR_CLEAR_RCVR only. On a half-duplex RS485 board whose Rx line is pulled low while the transceiver drives the bus, every transmission raises a spurious break, and all but the first character of the frame is lost. Only take the FIFO-mode path when the caller actually asked for CLEAR_XMIT. Likewise only wait for TEMT in that case: with the Tx FIFO deliberately left intact, that loop would otherwise spin for a full frame time in hard IRQ context with the port lock held. Tested on a Colibri T30 (Tegra30) with Rx DMA: - Break during transmission: the reset still fires from tegra_uart_decode_rx_error(), and the complete frame now reaches the peer. Before this change only the character in the shift register was sent. - Internal loopback with a generated break: the Rx FIFO is correctly cleared by the plain FCR write, and subsequent receive works with no frame, parity or overrun errors. Fixes: e9ea096dd225 ("serial: tegra: add serial driver") Cc: stable@kernel.org Signed-off-by: Simon Gassner Link: https://patch.msgid.link/20261001060539.32659-1-simon.gassner@noxsystems.com Signed-off-by: Greg Kroah-Hartman --- drivers/tty/serial/serial-tegra.c | 18 ++++++++++++++++-- 1 file changed, 16 insertions(+), 2 deletions(-) --- a/drivers/tty/serial/serial-tegra.c +++ b/drivers/tty/serial/serial-tegra.c @@ -306,11 +306,19 @@ static void tegra_uart_fifo_reset(struct { unsigned long fcr = tup->fcr_shadow; unsigned int lsr, tmout = 10000; + bool clear_tx = !!(fcr_bits & UART_FCR_CLEAR_XMIT); if (tup->rts_active) set_rts(tup, false); - if (tup->cdata->allow_txfifo_reset_fifo_mode) { + /* + * Leaving FIFO mode below is a workaround for a Tegra30 + * restriction on clearing the Tx FIFO while FIFO mode is + * enabled. It empties both FIFOs, so applying it to an + * Rx-only reset would destroy an in-flight transmission. + * Only take that path when the caller asked for CLEAR_XMIT. + */ + if (tup->cdata->allow_txfifo_reset_fifo_mode || !clear_tx) { fcr |= fcr_bits & (UART_FCR_CLEAR_RCVR | UART_FCR_CLEAR_XMIT); tegra_uart_write(tup, fcr, UART_FCR); } else { @@ -335,9 +343,15 @@ static void tegra_uart_fifo_reset(struct */ tegra_uart_wait_cycle_time(tup, 32); + /* + * Only wait for the transmitter to drain when the Tx FIFO was + * part of the reset. For an Rx-only reset it is left intact, + * and waiting for TEMT here would spin for a full frame time. + */ do { lsr = tegra_uart_read(tup, UART_LSR); - if ((lsr & UART_LSR_TEMT) && !(lsr & UART_LSR_DR)) + if ((!clear_tx || (lsr & UART_LSR_TEMT)) && + !(lsr & UART_LSR_DR)) break; udelay(1); } while (--tmout);