Re: [PATCH] clk: qcom: rpmh: Add note about sleep/wake state for BCMs

[Alex Elder <elder@linaro.org>]

On 5/17/22 2:16 PM, Alex Elder wrote:
> On 5/17/22 2:09 PM, Stephen Boyd wrote:
>> The sleep/wake state doesn't need to be set here because of specific
>> RPMh behavior that carries over the active state when sleep/wake state
>> hasn't been modified. Add a note to the code so we aren't tempted to set
>> the sleep/wake states.
>>
>> Cc: Alex Elder <elder@linaro.org>
>> Cc: Taniya Das <quic_tdas@quicinc.com>
>> Signed-off-by: Stephen Boyd <swboyd@chromium.org>
> 
> Looks good to me.  Thanks Stephen.
> 
> Reviewed-by: Alex Elder <elder@linaro.org>

Taniya, do you have anything to say about this patch?  -Alex

> 
>> ---
>>
>> This superseedes a previous patch[1] I sent that tried to fix this.
>>
>>   drivers/clk/qcom/clk-rpmh.c | 5 +++++
>>   1 file changed, 5 insertions(+)
>>
>> diff --git a/drivers/clk/qcom/clk-rpmh.c b/drivers/clk/qcom/clk-rpmh.c
>> index aed907982344..c07cab6905cb 100644
>> --- a/drivers/clk/qcom/clk-rpmh.c
>> +++ b/drivers/clk/qcom/clk-rpmh.c
>> @@ -274,6 +274,11 @@ static int clk_rpmh_bcm_send_cmd(struct clk_rpmh 
>> *c, bool enable)
>>           cmd.addr = c->res_addr;
>>           cmd.data = BCM_TCS_CMD(1, enable, 0, cmd_state);
>> +        /*
>> +         * Send only an active only state request. RPMh continues to
>> +         * use the active state when we're in sleep/wake state as long
>> +         * as the sleep/wake state has never been set.
>> +         */
>>           ret = clk_rpmh_send(c, RPMH_ACTIVE_ONLY_STATE, &cmd, enable);
>>           if (ret) {
>>               dev_err(c->dev, "set active state of %s failed: (%d)\n",
>>
>> base-commit: 42226c989789d8da4af1de0c31070c96726d990c
>