[PATCH v2 1/2] dt-bindings: phy: add DT bindings for Amlogic Meson PCIe Phy controller

[Hanjie Lin <hanjie.lin@amlogic.com>]

From: Yue Wang <yue.wang@amlogic.com>

The Meson-PCIE-PHY controller supports the 5-Gbps data rate
of the PCI Express Gen 2 specification and is backward compatible
with the 2.5-Gbps Gen 1.1 specification with only
inferred idle detection supported on Amlogic SoCs.

Signed-off-by: Hanjie Lin <hanjie.lin@amlogic.com>
Signed-off-by: Yue Wang <yue.wang@amlogic.com>
---
 .../bindings/phy/amlogic,meson-pcie-phy.txt         | 21 +++++++++++++++++++++
 1 file changed, 21 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/phy/amlogic,meson-pcie-phy.txt

diff --git a/Documentation/devicetree/bindings/phy/amlogic,meson-pcie-phy.txt b/Documentation/devicetree/bindings/phy/amlogic,meson-pcie-phy.txt
new file mode 100644
index 0000000..e2f0a27
--- /dev/null
+++ b/Documentation/devicetree/bindings/phy/amlogic,meson-pcie-phy.txt
@@ -0,0 +1,21 @@
+* Amlogic Meson AXG PCIE PHY binding
+
+Required properties:
+- compatible:	Should be
+	- "amlogic,axg-pcie-phy"
+- #phys-cells:	must be 0 (see phy-bindings.txt in this directory)
+- reg:		The base address and length of the registers
+- resets:	phandle to the reset lines
+- reset-names:	must contain "phy" and "peripheral"
+	- "phy"	PHY reset
+Optional properties:
+- phy-supply:	see phy-bindings.txt in this directory
+
+Example:
+	pcie_phy: pcie-phy@ff644000 {
+		#phy-cells = <0>;
+		compatible = "amlogic,axg-pcie-phy";
+		reg = <0x0 0xff644000 0x0 0x2000>;
+		resets = <&reset RESET_PCIE_PHY>;
+		reset-names = "phy";
+	};
-- 
2.7.4