Re: [RFC PATCH] PCIe: Add PCIe runtime D3cold support

["Rafael J. Wysocki" <rjw@sisk.pl>]

On Monday, April 16, 2012, Yan, Zheng wrote:
> On 04/14/2012 03:41 AM, Rafael J. Wysocki wrote:
> >> > @@ -296,7 +296,8 @@ static void acpi_pci_propagate_run_wake(struct pci_bus *bus, bool enable)
> >> >  
> >> >  static int acpi_pci_run_wake(struct pci_dev *dev, bool enable)
> >> >  {
> >> > -	if (dev->pme_interrupt)
> >> > +	/* PME interrupt isn't available in the D3cold case */
> >> > +	if (dev->pme_interrupt && !dev->runtime_d3cold)
> >
> > This whole thing is wrong.  First off, I don't think that the runtime_d3cold
> > flag makes any sense.  We already cover that in dev->pme_support.
> > 
> > Second, pme_interrupt means that the _root_ _port_, not the device itself will
> > trigger an interrupt whenever the device sends the PME message to it (which
> > very well may happen for a device in D3_cold woken up by an external signal).
> > 
> 
> I rechecked this. The port does trigger PME interrupt, but after the WAKE# signal
> restores device power. So my comments "PME interrupt isn't available in the D3cold
> case" is wrong, but setup ACPI wakeup is still required.

What exactly do you mean by "setup ACPI wakeup"?

Rafael