From: Lorenzo Pieralisi <lorenzo.pieralisi@arm.com>
To: Vignesh R <vigneshr@ti.com>, Kishon Vijay Abraham I <kishon@ti.com>
Cc: devicetree@vger.kernel.org, Tony Lindgren <tony@atomide.com>,
linux-pci@vger.kernel.org, linux-kernel@vger.kernel.org,
Rob Herring <robh+dt@kernel.org>,
Chris Welch <Chris.Welch@viavisolutions.com>,
Bjorn Helgaas <bhelgaas@google.com>,
linux-omap@vger.kernel.org, linux-arm-kernel@lists.infradead.org
Subject: Re: [PATCH 1/4] pci: dwc: pci-dra7xx: Enable errata i870 for both EP and RC mode
Date: Tue, 19 Dec 2017 16:24:22 +0000 [thread overview]
Message-ID: <20171219162421.GD21501@red-moon> (raw)
In-Reply-To: <20171201061311.16691-2-vigneshr@ti.com>
On Fri, Dec 01, 2017 at 11:43:08AM +0530, Vignesh R wrote:
> Errata i870 is applicable in both EP and RC mode. Therefore rename
> function dra7xx_pcie_ep_unaligned_memaccess(), that implements errata
> workaround, to dra7xx_pcie_unaligned_memaccess() and call it from a
> common place. So, that errata workaround is applied for both modes of
> operation.
>
> Reported-by: Chris Welch <Chris.Welch@viavisolutions.com>
> Signed-off-by: Vignesh R <vigneshr@ti.com>
> ---
> drivers/pci/dwc/pci-dra7xx.c | 12 ++++++------
> 1 file changed, 6 insertions(+), 6 deletions(-)
I need Kishon's ACK to apply it, thanks.
Lorenzo
> diff --git a/drivers/pci/dwc/pci-dra7xx.c b/drivers/pci/dwc/pci-dra7xx.c
> index e77a4ceed74c..53f721d1cc40 100644
> --- a/drivers/pci/dwc/pci-dra7xx.c
> +++ b/drivers/pci/dwc/pci-dra7xx.c
> @@ -546,7 +546,7 @@ static const struct of_device_id of_dra7xx_pcie_match[] = {
> };
>
> /*
> - * dra7xx_pcie_ep_unaligned_memaccess: workaround for AM572x/AM571x Errata i870
> + * dra7xx_pcie_unaligned_memaccess: workaround for AM572x/AM571x Errata i870
> * @dra7xx: the dra7xx device where the workaround should be applied
> *
> * Access to the PCIe slave port that are not 32-bit aligned will result
> @@ -556,7 +556,7 @@ static const struct of_device_id of_dra7xx_pcie_match[] = {
> *
> * To avoid this issue set PCIE_SS1_AXI2OCP_LEGACY_MODE_ENABLE to 1.
> */
> -static int dra7xx_pcie_ep_unaligned_memaccess(struct device *dev)
> +static int dra7xx_pcie_unaligned_memaccess(struct device *dev)
> {
> int ret;
> struct device_node *np = dev->of_node;
> @@ -703,6 +703,10 @@ static int __init dra7xx_pcie_probe(struct platform_device *pdev)
> if (dra7xx->link_gen < 0 || dra7xx->link_gen > 2)
> dra7xx->link_gen = 2;
>
> + ret = dra7xx_pcie_unaligned_memaccess(dev);
> + if (ret)
> + goto err_gpio;
> +
> switch (mode) {
> case DW_PCIE_RC_TYPE:
> dra7xx_pcie_writel(dra7xx, PCIECTRL_TI_CONF_DEVICE_TYPE,
> @@ -715,10 +719,6 @@ static int __init dra7xx_pcie_probe(struct platform_device *pdev)
> dra7xx_pcie_writel(dra7xx, PCIECTRL_TI_CONF_DEVICE_TYPE,
> DEVICE_TYPE_EP);
>
> - ret = dra7xx_pcie_ep_unaligned_memaccess(dev);
> - if (ret)
> - goto err_gpio;
> -
> ret = dra7xx_add_pcie_ep(dra7xx, pdev);
> if (ret < 0)
> goto err_gpio;
> --
> 2.15.0
>
_______________________________________________
linux-arm-kernel mailing list
linux-arm-kernel@lists.infradead.org
http://lists.infradead.org/mailman/listinfo/linux-arm-kernel
next prev parent reply other threads:[~2017-12-19 16:24 UTC|newest]
Thread overview: 11+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-12-01 6:13 [PATCH 0/4] pci-dra7xx: Fix legacy IRQ handling and errata handling Vignesh R
2017-12-01 6:13 ` [PATCH 1/4] pci: dwc: pci-dra7xx: Enable errata i870 for both EP and RC mode Vignesh R
2017-12-19 16:24 ` Lorenzo Pieralisi [this message]
2017-12-20 4:15 ` Vignesh R
2017-12-01 6:13 ` [PATCH 2/4] dt-bindings: PCI: dra7xx: Add bindings for unaligned access in host mode Vignesh R
2017-12-04 21:40 ` Rob Herring
2017-12-01 6:13 ` [PATCH 3/4] ARM: dts: dra7: Add DT property to allow unaligned mem access to PCIe RC Vignesh R
2017-12-01 6:13 ` [PATCH 4/4] PCI: dwc: pci-dra7xx: Fix legacy IRQ handling Vignesh R
2017-12-08 18:35 ` Lorenzo Pieralisi
2017-12-11 4:42 ` Vignesh R
2017-12-01 6:15 ` [PATCH 0/4] pci-dra7xx: Fix legacy IRQ handling and errata handling Vignesh R
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20171219162421.GD21501@red-moon \
--to=lorenzo.pieralisi@arm.com \
--cc=Chris.Welch@viavisolutions.com \
--cc=bhelgaas@google.com \
--cc=devicetree@vger.kernel.org \
--cc=kishon@ti.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-omap@vger.kernel.org \
--cc=linux-pci@vger.kernel.org \
--cc=robh+dt@kernel.org \
--cc=tony@atomide.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).