[PATCH] PCI: mediatek: Remove the usage of virt_to_phys

[Jianjun Wang <jianjun.wang@mediatek.com>]

Remove the usage of virt_to_phys, as it will cause sparse warnings when
building on some platforms.

Signed-off-by: Jianjun Wang <jianjun.wang@mediatek.com>
---
 drivers/pci/controller/pcie-mediatek.c | 19 ++++++++++++-------
 1 file changed, 12 insertions(+), 7 deletions(-)

diff --git a/drivers/pci/controller/pcie-mediatek.c b/drivers/pci/controller/pcie-mediatek.c
index 3bcfc4e58ba2..dc1e5fd6c7aa 100644
--- a/drivers/pci/controller/pcie-mediatek.c
+++ b/drivers/pci/controller/pcie-mediatek.c
@@ -178,6 +178,7 @@ struct mtk_pcie_soc {
  * @phy: pointer to PHY control block
  * @slot: port slot
  * @irq: GIC irq
+ * @msg_addr: MSI message address
  * @irq_domain: legacy INTx IRQ domain
  * @inner_domain: inner IRQ domain
  * @msi_domain: MSI IRQ domain
@@ -198,6 +199,7 @@ struct mtk_pcie_port {
 	struct phy *phy;
 	u32 slot;
 	int irq;
+	phys_addr_t msg_addr;
 	struct irq_domain *irq_domain;
 	struct irq_domain *inner_domain;
 	struct irq_domain *msi_domain;
@@ -393,12 +395,10 @@ static struct pci_ops mtk_pcie_ops_v2 = {
 static void mtk_compose_msi_msg(struct irq_data *data, struct msi_msg *msg)
 {
 	struct mtk_pcie_port *port = irq_data_get_irq_chip_data(data);
-	phys_addr_t addr;
 
 	/* MT2712/MT7622 only support 32-bit MSI addresses */
-	addr = virt_to_phys(port->base + PCIE_MSI_VECTOR);
 	msg->address_hi = 0;
-	msg->address_lo = lower_32_bits(addr);
+	msg->address_lo = lower_32_bits(port->msg_addr);
 
 	msg->data = data->hwirq;
 
@@ -510,10 +510,8 @@ static int mtk_pcie_allocate_msi_domains(struct mtk_pcie_port *port)
 static void mtk_pcie_enable_msi(struct mtk_pcie_port *port)
 {
 	u32 val;
-	phys_addr_t msg_addr;
 
-	msg_addr = virt_to_phys(port->base + PCIE_MSI_VECTOR);
-	val = lower_32_bits(msg_addr);
+	val = lower_32_bits(port->msg_addr);
 	writel(val, port->base + PCIE_IMSI_ADDR);
 
 	val = readl(port->base + PCIE_INT_MASK);
@@ -913,6 +911,7 @@ static int mtk_pcie_parse_port(struct mtk_pcie *pcie,
 	struct mtk_pcie_port *port;
 	struct device *dev = pcie->dev;
 	struct platform_device *pdev = to_platform_device(dev);
+	struct resource *regs;
 	char name[10];
 	int err;
 
@@ -921,12 +920,18 @@ static int mtk_pcie_parse_port(struct mtk_pcie *pcie,
 		return -ENOMEM;
 
 	snprintf(name, sizeof(name), "port%d", slot);
-	port->base = devm_platform_ioremap_resource_byname(pdev, name);
+	regs = platform_get_resource_byname(pdev, IORESOURCE_MEM, name);
+	if (!regs)
+		return -EINVAL;
+
+	port->base = devm_ioremap_resource(dev, regs);
 	if (IS_ERR(port->base)) {
 		dev_err(dev, "failed to map port%d base\n", slot);
 		return PTR_ERR(port->base);
 	}
 
+	port->msg_addr = regs->start + PCIE_MSI_VECTOR;
+
 	snprintf(name, sizeof(name), "sys_ck%d", slot);
 	port->sys_ck = devm_clk_get(dev, name);
 	if (IS_ERR(port->sys_ck)) {
-- 
2.46.0