[PATCH v11 2/5] arm64: dts: qcom: qcs8300: enable pcie0

[Ziyue Zhang <ziyue.zhang@oss.qualcomm.com>]

Add configurations in devicetree for PCIe0, including registers, clocks,
interrupts and phy setting sequence.

Add PCIe lane equalization preset properties for 8 GT/s and 16GT/s

Reviewed-by: Manivannan Sadhasivam <manivannan.sadhasivam@linaro.org>
Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
Signed-off-by: Ziyue Zhang <ziyue.zhang@oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/qcs8300.dtsi | 179 +++++++++++++++++++++++++-
 1 file changed, 178 insertions(+), 1 deletion(-)

diff --git a/arch/arm64/boot/dts/qcom/qcs8300.dtsi b/arch/arm64/boot/dts/qcom/qcs8300.dtsi
index 5edb137d1471..a64890033ef1 100644
--- a/arch/arm64/boot/dts/qcom/qcs8300.dtsi
+++ b/arch/arm64/boot/dts/qcom/qcs8300.dtsi
@@ -902,7 +902,7 @@ gcc: clock-controller@100000 {
 			#power-domain-cells = <1>;
 			clocks = <&rpmhcc RPMH_CXO_CLK>,
 				 <&sleep_clk>,
-				 <0>,
+				 <&pcie0_phy>,
 				 <0>,
 				 <0>,
 				 <0>,
@@ -2249,6 +2249,183 @@ mmss_noc: interconnect@17a0000 {
 			qcom,bcm-voters = <&apps_bcm_voter>;
 		};
 
+		pcie0: pci@1c00000 {
+			device_type = "pci";
+			compatible = "qcom,pcie-qcs8300", "qcom,pcie-sa8775p";
+			reg = <0x0 0x01c00000 0x0 0x3000>,
+			      <0x0 0x40000000 0x0 0xf20>,
+			      <0x0 0x40000f20 0x0 0xa8>,
+			      <0x0 0x40001000 0x0 0x4000>,
+			      <0x0 0x40100000 0x0 0x100000>,
+			      <0x0 0x01c03000 0x0 0x1000>;
+			reg-names = "parf",
+				    "dbi",
+				    "elbi",
+				    "atu",
+				    "config",
+				    "mhi";
+			#address-cells = <3>;
+			#size-cells = <2>;
+			ranges = <0x01000000 0x0 0x00000000 0x0 0x40200000 0x0 0x100000>,
+				 <0x02000000 0x0 0x40300000 0x0 0x40300000 0x0 0x1fd00000>;
+			bus-range = <0x00 0xff>;
+
+			dma-coherent;
+
+			linux,pci-domain = <0>;
+			num-lanes = <2>;
+
+			interrupts = <GIC_SPI 307 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 308 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 309 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 312 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 313 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 314 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 374 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 375 IRQ_TYPE_LEVEL_HIGH>,
+				     <GIC_SPI 306 IRQ_TYPE_LEVEL_HIGH>;
+			interrupt-names = "msi0",
+					  "msi1",
+					  "msi2",
+					  "msi3",
+					  "msi4",
+					  "msi5",
+					  "msi6",
+					  "msi7",
+					  "global";
+
+			#interrupt-cells = <1>;
+			interrupt-map-mask = <0 0 0 0x7>;
+			interrupt-map = <0 0 0 1 &intc GIC_SPI 434 IRQ_TYPE_LEVEL_HIGH>,
+					<0 0 0 2 &intc GIC_SPI 435 IRQ_TYPE_LEVEL_HIGH>,
+					<0 0 0 3 &intc GIC_SPI 438 IRQ_TYPE_LEVEL_HIGH>,
+					<0 0 0 4 &intc GIC_SPI 439 IRQ_TYPE_LEVEL_HIGH>;
+
+			clocks = <&gcc GCC_PCIE_0_AUX_CLK>,
+				 <&gcc GCC_PCIE_0_CFG_AHB_CLK>,
+				 <&gcc GCC_PCIE_0_MSTR_AXI_CLK>,
+				 <&gcc GCC_PCIE_0_SLV_AXI_CLK>,
+				 <&gcc GCC_PCIE_0_SLV_Q2A_AXI_CLK>;
+			clock-names = "aux",
+				      "cfg",
+				      "bus_master",
+				      "bus_slave",
+				      "slave_q2a";
+
+			assigned-clocks = <&gcc GCC_PCIE_0_AUX_CLK>;
+			assigned-clock-rates = <19200000>;
+
+			interconnects = <&pcie_anoc MASTER_PCIE_0 QCOM_ICC_TAG_ALWAYS
+					 &mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
+					<&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ACTIVE_ONLY
+					 &config_noc SLAVE_PCIE_0 QCOM_ICC_TAG_ACTIVE_ONLY>;
+			interconnect-names = "pcie-mem",
+					     "cpu-pcie";
+
+			iommu-map = <0x0 &pcie_smmu 0x0000 0x1>,
+				    <0x100 &pcie_smmu 0x0001 0x1>;
+
+			resets = <&gcc GCC_PCIE_0_BCR>,
+				 <&gcc GCC_PCIE_0_LINK_DOWN_BCR>;
+			reset-names = "pci",
+				      "link_down";
+
+			power-domains = <&gcc GCC_PCIE_0_GDSC>;
+
+			eq-presets-8gts = /bits/ 16 <0x5555 0x5555>;
+			eq-presets-16gts = /bits/ 8 <0x55 0x55>;
+
+			status = "disabled";
+
+			pcie3_opp_table: opp-table {
+				compatible = "operating-points-v2";
+
+				/* GEN 1 x1 */
+				opp-2500000 {
+					opp-hz = /bits/ 64 <2500000>;
+					required-opps = <&rpmhpd_opp_svs_l1>;
+					opp-peak-kBps = <250000 1>;
+				};
+
+				/* GEN 1 x2 and GEN 2 x1 */
+				opp-5000000 {
+					opp-hz = /bits/ 64 <5000000>;
+					required-opps = <&rpmhpd_opp_svs_l1>;
+					opp-peak-kBps = <500000 1>;
+				};
+
+				/* GEN 2 x2 */
+				opp-10000000 {
+					opp-hz = /bits/ 64 <10000000>;
+					required-opps = <&rpmhpd_opp_svs_l1>;
+					opp-peak-kBps = <1000000 1>;
+				};
+
+				/* GEN 3 x1 */
+				opp-8000000 {
+					opp-hz = /bits/ 64 <8000000>;
+					required-opps = <&rpmhpd_opp_svs_l1>;
+					opp-peak-kBps = <984500 1>;
+				};
+
+				/* GEN 3 x2 and GEN 4 x1 */
+				opp-16000000 {
+					opp-hz = /bits/ 64 <16000000>;
+					required-opps = <&rpmhpd_opp_nom>;
+					opp-peak-kBps = <1969000 1>;
+				};
+
+				/* GEN 4 x2 */
+				opp-32000000 {
+					opp-hz = /bits/ 64 <32000000>;
+					required-opps = <&rpmhpd_opp_nom>;
+					opp-peak-kBps = <3938000 1>;
+				};
+			};
+
+			pcieport0: pcie@0 {
+				device_type = "pci";
+				reg = <0x0 0x0 0x0 0x0 0x0>;
+				bus-range = <0x01 0xff>;
+
+				#address-cells = <3>;
+				#size-cells = <2>;
+				ranges;
+				phys = <&pcie0_phy>;
+			};
+		};
+
+		pcie0_phy: phy@1c04000 {
+			compatible = "qcom,qcs8300-qmp-gen4x2-pcie-phy";
+			reg = <0x0 0x01c04000 0x0 0x2000>;
+
+			clocks = <&gcc GCC_PCIE_0_PHY_AUX_CLK>,
+				 <&gcc GCC_PCIE_0_CFG_AHB_CLK>,
+				 <&gcc GCC_PCIE_CLKREF_EN>,
+				 <&gcc GCC_PCIE_0_PHY_RCHNG_CLK>,
+				 <&gcc GCC_PCIE_0_PIPE_CLK>,
+				 <&gcc GCC_PCIE_0_PIPEDIV2_CLK>;
+			clock-names = "aux",
+				      "cfg_ahb",
+				      "ref",
+				      "rchng",
+				      "pipe",
+				      "pipediv2";
+
+			resets = <&gcc GCC_PCIE_0_PHY_BCR>;
+			reset-names = "phy";
+
+			assigned-clocks = <&gcc GCC_PCIE_0_PHY_RCHNG_CLK>;
+			assigned-clock-rates = <100000000>;
+
+			#clock-cells = <0>;
+			clock-output-names = "pcie_0_pipe_clk";
+
+			#phy-cells = <0>;
+
+			status = "disabled";
+		};
+
 		ufs_mem_hc: ufs@1d84000 {
 			compatible = "qcom,qcs8300-ufshc", "qcom,ufshc", "jedec,ufs-2.0";
 			reg = <0x0 0x01d84000 0x0 0x3000>;
-- 
2.43.0