[PATCH v2 1/5] PCI: qcom: Wait for PCIE_RESET_CONFIG_WAIT_MS after PERST# deassert

[Manivannan Sadhasivam via B4 Relay <devnull+manivannan.sadhasivam.oss.qualcomm.com@kernel.org>]

From: Manivannan Sadhasivam <manivannan.sadhasivam@oss.qualcomm.com>

PCIe spec r6.0, sec 6.6.1 mandates waiting for 100ms before deasserting
PERST# if the downstream port does not support Link speeds greater than
5.0 GT/s. But in practice, this delay seem to be required irrespective of
the supported link speed as it gives the endpoints enough time to
initialize.

Hence, add the delay by reusing the PCIE_RESET_CONFIG_WAIT_MS definition if
the linkup_irq is not supported. If the linkup_irq is supported, the driver
already waits for 100ms in the IRQ handler post link up.

Also, remove the redundant comment for PCIE_T_PVPERL_MS. Finally, the
PERST_DELAY_US sleep can be moved to PERST# assert where it should be.

Cc: stable+noautosel@kernel.org # non-trivial dependency
Fixes: 82a823833f4e ("PCI: qcom: Add Qualcomm PCIe controller driver")
Signed-off-by: Manivannan Sadhasivam <manivannan.sadhasivam@oss.qualcomm.com>
---
 drivers/pci/controller/dwc/pcie-qcom.c | 8 +++++---
 1 file changed, 5 insertions(+), 3 deletions(-)

diff --git a/drivers/pci/controller/dwc/pcie-qcom.c b/drivers/pci/controller/dwc/pcie-qcom.c
index 294babe1816e4d0c2b2343fe22d89af72afcd6cd..bcd080315d70e64eafdefd852740fe07df3dbe75 100644
--- a/drivers/pci/controller/dwc/pcie-qcom.c
+++ b/drivers/pci/controller/dwc/pcie-qcom.c
@@ -302,20 +302,22 @@ static void qcom_perst_assert(struct qcom_pcie *pcie, bool assert)
 	else
 		list_for_each_entry(port, &pcie->ports, list)
 			gpiod_set_value_cansleep(port->reset, val);
-
-	usleep_range(PERST_DELAY_US, PERST_DELAY_US + 500);
 }
 
 static void qcom_ep_reset_assert(struct qcom_pcie *pcie)
 {
 	qcom_perst_assert(pcie, true);
+	usleep_range(PERST_DELAY_US, PERST_DELAY_US + 500);
 }
 
 static void qcom_ep_reset_deassert(struct qcom_pcie *pcie)
 {
-	/* Ensure that PERST has been asserted for at least 100 ms */
+	struct dw_pcie_rp *pp = &pcie->pci->pp;
+
 	msleep(PCIE_T_PVPERL_MS);
 	qcom_perst_assert(pcie, false);
+	if (!pp->use_linkup_irq)
+		msleep(PCIE_RESET_CONFIG_WAIT_MS);
 }
 
 static int qcom_pcie_start_link(struct dw_pcie *pci)

-- 
2.45.2