messages from 2026-10-16 16:20:04 to 2026-10-16 22:55:26 UTC [more...]
[PATCH v2 0/2] PCI/P2PDMA: Allow P2PDMA in VMware and Hyper-V guests on Intel hosts
2026-10-16 22:55 UTC (6+ messages)
` [PATCH v2 1/2] PCI/P2PDMA: Allow P2PDMA in VMware "
` [PATCH v2 2/2] PCI/P2PDMA: Allow P2PDMA in Hyper-V "
[PATCH 0/3] cxl: Fix link latency calculations and QTG latency units
2026-10-16 22:41 UTC (3+ messages)
` [PATCH 2/3] cxl: Account for link width in latency calculation
[PATCH v3 0/8] PCI/ASPM: Add pci_force_enable_link_state() API and convert Atheros drivers
2026-10-16 22:09 UTC (2+ messages)
[PATCH 0/2] PCI/P2PDMA: Allow P2PDMA in VMware and Hyper-V guests on Intel hosts
2026-10-16 22:01 UTC (16+ messages)
[PATCH] PCI: Disable async suspend for AMD rev 0x62 ACP and HD Audio
2026-10-16 21:43 UTC (2+ messages)
[PATCH] PCI/PM: Skip the suspend_noirq config save if runtime-suspended
2026-10-16 21:41 UTC (2+ messages)
[PATCH RESEND] PCI/DOE: Poll briefly for a response before sleeping
2026-10-16 20:45 UTC (3+ messages)
[PATCH] PCI: iproc-msi: Bound events handled per IRQ
2026-10-16 20:10 UTC (3+ messages)
[PATCH v27 0/4] rust: leds: Add led classdev abstractions
2026-10-16 18:24 UTC (8+ messages)
` [PATCH v27 1/4] rust: leds: Add basic "
` [PATCH v27 2/4] rust: leds: Add Mode trait
` [PATCH v27 3/4] rust: leds: Add multicolor classdev abstractions
` [PATCH v27 4/4] MAINTAINERS: rust: leds: Add rust abstraction entry
[GIT PULL] PCI fixes for v7.3
2026-10-16 18:13 UTC
[PATCH] PCI: Ignore Immediate Readiness on Samsung 990 EVO Plus NVMe
2026-10-16 17:15 UTC (2+ messages)
[PATCH v6 00/31] vfio/pci: Add CXL Type-2 device passthrough support
2026-10-16 16:18 UTC (31+ messages)
` [PATCH v6 02/31] cxl/regs: Let a BAR-owning driver own the component register block
` [PATCH v6 03/31] cxl: Move component register defines to uapi/cxl/cxl_regs.h
` [PATCH v6 04/31] PCI/CXL: Let the driver that owns the HDM range run CXL Reset
` [PATCH v6 05/31] PCI: Refuse bus and slot reset below a CXL port with SBR masked
` [PATCH v6 06/31] vfio/pci: Add the CXL provider ops registration interface
` [PATCH v6 07/31] vfio/pci: Detect CXL devices and load the CXL provider on demand
` [PATCH v6 08/31] vfio/pci: Add a generic excluded-range list
` [PATCH v6 09/31] vfio/pci: Advertise the mmap areas around excluded ranges
` [PATCH v6 10/31] vfio/pci: Refuse ioeventfds and dma-buf exports over "
` [PATCH v6 11/31] vfio/pci: Virtualize the CXL DVSEC in vfio_pci_config.c
` [PATCH v6 12/31] vfio/pci: Call the CXL open and close hooks around device use
` [PATCH v6 13/31] vfio/pci: Bracket PCI resets with the CXL reset hooks
` [PATCH v6 14/31] vfio/pci: Provide an opt-out for the CXL Type-2 extensions
` [PATCH v6 15/31] vfio/pci: Route every reset point through a try-reset helper
` [PATCH v6 16/31] vfio/pci: Revoke and re-arm one device-specific region
` [PATCH v6 17/31] vfio/pci: Call the device provider across low-power transitions
` [PATCH v6 18/31] vfio/cxl: Add the vfio-cxl provider module skeleton
` [PATCH v6 19/31] vfio/cxl: Create the CXL memdev and set media ready at bind
` [PATCH v6 20/31] vfio/cxl: Own the whole component register BAR
` [PATCH v6 21/31] vfio/cxl: Expose the HDM memory region to the guest
` [PATCH v6 22/31] vfio/cxl: Allow mmap of the HDM memory region
` [PATCH v6 23/31] vfio/cxl: Contain HDM memory errors with memory_failure()
` [PATCH v6 24/31] vfio/cxl: Expose the HDM decoder registers read-only to the guest
` [PATCH v6 25/31] vfio/cxl: Exclude the HDM decoder registers from direct BAR access
` [PATCH v6 26/31] vfio/cxl: Restore the HDM decoder after a hot reset
` [PATCH v6 27/31] vfio/cxl: Describe the CXL device and decoder geometry to userspace
` [PATCH v6 28/31] vfio/cxl: Export the HDM memory region as a dma-buf
` [PATCH v6 29/31] vfio/cxl: Run the CXL reset at the vfio reset points
` [PATCH v6 30/31] Documentation: vfio-pci: Document CXL Type-2 device passthrough
` [PATCH v6 31/31] selftests/vfio: Add CXL Type-2 passthrough tests
page: | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox