Re: [PATCH v1] drivers: pci: introduce configurable delay for Rockchip PCIe bus scan

["Vincenzo Palazzo" <vincenzopalazzodev@gmail.com>]

>
> Thanks for raising this issue.  Let's see what we can do to address
> it.
>
> On Tue, May 09, 2023 at 05:39:12PM +0200, Vincenzo Palazzo wrote:
> > Add a configurable delay to the Rockchip PCIe driver to address
> > crashes that occur on some old devices, such as the Pine64 RockPro64.
> > 
> > This issue is affecting the ARM community, but there is no
> > upstream solution for it yet.
>
> It sounds like this happens with several endpoints, right?  And I
> assume the endpoints work fine in other non-Rockchip systems?  If
> that's the case, my guess is the problem is with the Rockchip host
> controller and how it's initialized, not with the endpoints.
>
> The only delays and timeouts I see in the driver now are in
> rockchip_pcie_host_init_port(), where it waits for link training to
> complete.  I assume the link training did completely successfully
> since you don't mention either a gen1 or gen2 timeout (although the
> gen2 message is a dev_dbg() that normally wouldn't go to the console).
>
> I don't know that the spec contains a retrain timeout value.  Several
> other drivers use 1 second, while rockchip uses 500ms (for example,
> see LINK_RETRAIN_TIMEOUT and LINK_UP_TIMEOUT).
>
> I think we need to understand the issue better before adding a DT
> property and a module parameter.  Those are hard for users to deal
> with.  If we can figure out a value that works for everybody, it would
> be better to just hard-code it in the driver and use that all the
> time.
>
> A few minor style/formatting comments below just for future reference:

Due the recent email I think it is worth make a version 2 of this
patch with your suggestion? and iterate over it another time?

Cheers!

Vincent.