Re: [PATCH v2 1/1] PCI: vmd: Avoid acceidental enablement of window when zeroing config space of VMD root ports

["Patel, Nirmal" <nirmal.patel@linux.intel.com>]

On 1/11/2023 2:29 AM, Adrian Huang wrote:
> From: Adrian Huang <ahuang12@lenovo.com>
>
> Commit 6aab5622296b ("PCI: vmd: Clean up domain before enumeration")
> clears PCI configuration space of VMD root ports. However, the host OS
> cannot boot successfully with the following error message:
>
>   vmd 0000:64:05.5: PCI host bridge to bus 10000:00
>   ...
>   vmd 0000:64:05.5: Bound to PCI domain 10000
>   ...
>   DMAR: VT-d detected Invalidation Queue Error: Reason f
>   DMAR: VT-d detected Invalidation Time-out Error: SID ffff
>   DMAR: VT-d detected Invalidation Completion Error: SID ffff
>   DMAR: QI HEAD: UNKNOWN qw0 = 0x0, qw1 = 0x0
>   DMAR: QI PRIOR: UNKNOWN qw0 = 0x0, qw1 = 0x0
>   DMAR: Invalidation Time-out Error (ITE) cleared
>
> The root cause is that memset_io() clears prefetchable memory base/limit
> registers and prefetchable base/limit 32 bits registers sequentially. This
> might enable prefetchable memory if the device disables prefetchable memory
> originally. Here is an example (before memset_io()):
>
>   PCI configuration space for 10000:00:00.0:
>   86 80 30 20 06 00 10 00 04 00 04 06 00 00 01 00
>   00 00 00 00 00 00 00 00 00 01 01 00 00 00 00 20
>   00 00 00 00 01 00 01 00 ff ff ff ff 75 05 00 00
>   00 00 00 00 40 00 00 00 00 00 00 00 00 01 02 00
>
> So, prefetchable memory is ffffffff00000000-575000fffff, which is disabled.
> Here is the quote from section 7.5.1.3.9 of PCI Express Base 6.0 spec:
>
>   The Prefetchable Memory Limit register must be programmed to a smaller
>   value than the Prefetchable Memory Base register if there is no
>   prefetchable memory on the secondary side of the bridge.
>
> When memset_io() clears prefetchable base 32 bits register, the
> prefetchable memory becomes 0000000000000000-575000fffff, which is enabled.
> This behavior (accidental enablement of window) causes that config accesses
> get routed to the wrong place, and the access content of PCI configuration
> space of VMD root ports is 0xff after invoking memset_io() in
> vmd_domain_reset():
>
>   10000:00:00.0 PCI bridge: Intel Corporation Sky Lake-E PCI Express Root Port A (rev ff) (prog-if ff)
>           !!! Unknown header type 7f
>   00: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
>   ...
>   f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
>
>   10000:00:01.0 PCI bridge: Intel Corporation Sky Lake-E PCI Express Root Port B (rev ff) (prog-if ff)
>           !!! Unknown header type 7f
>   00: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
>   ...
>   f0: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
>
> To fix the issue, prefetchable limit upper 32 bits register needs to be
> cleared firstly. This also adheres to the implementation of
> pci_setup_bridge_mmio_pref(). Please see the function for detail.
>
> Bugzilla: https://bugzilla.kernel.org/show_bug.cgi?id=216644
> Fixes: 6aab5622296b ("PCI: vmd: Clean up domain before enumeration")
> Cc: Nirmal Patel <nirmal.patel@linux.intel.com>
> Signed-off-by: Adrian Huang <ahuang12@lenovo.com>
> Reviewed-by: Jon Derrick <jonathan.derrick@linux.dev>
> ---
> Changes since v1:
>   - Changed subject per Bjorn's suggestion
>
>  drivers/pci/controller/vmd.c | 3 +++
>  1 file changed, 3 insertions(+)
>
> diff --git a/drivers/pci/controller/vmd.c b/drivers/pci/controller/vmd.c
> index 769eedeb8802..e520aec55b68 100644
> --- a/drivers/pci/controller/vmd.c
> +++ b/drivers/pci/controller/vmd.c
> @@ -526,6 +526,9 @@ static void vmd_domain_reset(struct vmd_dev *vmd)
>  				     PCI_CLASS_BRIDGE_PCI))
>  					continue;
>  
> +				/* Clear the upper 32 bits of PREF limit. */
> +				memset_io(base + PCI_PREF_LIMIT_UPPER32, 0, 4);
> +
>  				memset_io(base + PCI_IO_BASE, 0,
>  					  PCI_ROM_ADDRESS1 - PCI_IO_BASE);
>  			}

Reviewed-by: Nirmal Patel <nirmal.patel@linux.intel.com>