From: Hans de Goede <hdegoede@redhat.com>
To: Bjorn Helgaas <helgaas@kernel.org>
Cc: Bjorn Helgaas <bhelgaas@google.com>,
linuxkernelml@undead.fr, linux-acpi@vger.kernel.org,
linux-pci@vger.kernel.org
Subject: Re: [PATCH] x86/PCI: Disable E820 reserved region clipping for Clevo NL4XLU laptops
Date: Wed, 12 Oct 2022 10:23:12 +0200 [thread overview]
Message-ID: <a9203d47-5b85-c035-3ec7-973dcb6a840a@redhat.com> (raw)
In-Reply-To: <20221011174010.GA3001067@bhelgaas>
Hi,
On 10/11/22 19:40, Bjorn Helgaas wrote:
> On Mon, Oct 10, 2022 at 05:02:06PM +0200, Hans de Goede wrote:
>> Clevo NL4XLU barebones have the same E820 reservation covering
>> the entire _CRS 32-bit window issue as the Lenovo *IIL* and
>> Clevo X170KM-G models, relevant dmesg bits (with pci=no_e820):
>>
>> BIOS-e820: [mem 0x000000005bc50000-0x00000000cfffffff] reserved
>> pci_bus 0000:00: root bus resource [mem 0x6d800000-0xbfffffff window]
>>
>> Note how the e820 reservation covers the entire PCI root mem window.
>>
>> Add a no_e820 quirk for these models to fix the touchpad not working
>> (due to Linux being unable to assign a PCI BAR for the i2c-controller).
>
> I do plan to apply this, but a little food for thought below.
>
> I explored this issue a little bit with the ACPI/UEFI folks (see
> https://members.uefi.org/wg/aswg/mail/thread/9265 if you have access).
>
> One aspect I had glossed over earlier is that on most recent machines,
> the "E820 map" Linux uses is actually constructed internally by Linux
> based on the UEFI memory map, and that construction conflates several
> EFI types into E820_TYPE_RESERVED; see
> https://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git/tree/drivers/firmware/efi/libstub/x86-stub.c?id=v5.19#n576
>
> We don't have a dmesg log with "efi=debug" for this case, but in most
> cases where E820 says the entire root mem window is reserved, I think
> it's because an EfiMemoryMappedIO entry was converted to
> E820_TYPE_RESERVED.
>
> From a response in the ACPI/UEFI discussion:
>
> The reason EfiMemoryMappedIO[1] exist in the UEFI memory map is to
> request a virtual mapping for UEFI Runtime Services.
>
> For example if the EFI Runtime Service needed to write to FLASH then
> the NOR FLASH would need a mapping. Also the NOR FLASH controller
> might also need a mapping and this could include PCI Config Space if
> needed registers existed in that space.
>
> Thus the EfiMemoryMappedIO entries just exist to pass up the
> EFI_MEMORY_RUNTIME attribute in the UEFI Memory Map. This is the part
> of the contract for UEFI Runtime Service to use virtual mappings
> provided by the OS. So from an OS point of view EfiMemoryMappedIO has
> no other purpose.
>
> [1] UEFI: Table 7-5 Memory Type Usage before ExitBootServices() "Used
> by system firmware to request that a memory-mapped IO region be
> mapped by the OS to a virtual address so it can be accessed by EFI
> runtime services."
>
> So the point here is that Linux currently converts EfiMemoryMappedIO
> to E820_TYPE_RESERVED, and that likely attaches more meaning to those
> regions than firmware intended.
>
> I'm a little leery of changing that UEFI->E820 conversion because of
> other possible implications, but it may be that omitting
> EfiMemoryMappedIO entries from the E820 map and keeping the original
> "avoid E820 regions" (4dc2287c1805) would also solve this problem.
Actually during my many attempts to fix this I did write a patch
adding a new E820_TYPE_MMIO to the generated e820-memmap which
would only show up in the EFI -> E820 entry generation case
and then used that to not exclude that E820 region, see
this RFC series:
https://lore.kernel.org/linux-pci/20220214151759.98267-1-hdegoede@redhat.com/
Unfortunately this series caused the same X1 carbon gen2 suspend/resume
not working problem as the earlier set pci=no_e820 based on a BIOS date cutoff
attempt which I did earlier and which even briefly was in some -rc kernels
through Rafael's tree.
I also did another series which used the EfiMemoryMappedIO type as
an input to heuristics to automatically set pci=no_e820, see:
https://lore.kernel.org/linux-pci/20220228105259.230903-1-hdegoede@redhat.com/
IIRC that patch eventually got replaced by a similar but simpler
heuristic from you. Which IIRC eventually got dropped again because
it was causing regressions on some models again.
So we ended up with the current set pci=no_e820 using DMI based quirks +
try to enable it for all BIOS-es with date >= 2023 approach,
with the plan to do DMI quirks setting pci=use_e820 if any (buggy)
2023 BIOS-es show up which need this.
Regards,
Hans
>> Link: https://bugzilla.kernel.org/show_bug.cgi?id=216565
>> Signed-off-by: Hans de Goede <hdegoede@redhat.com>
>> ---
>> arch/x86/pci/acpi.c | 13 +++++++++++++
>> 1 file changed, 13 insertions(+)
>>
>> diff --git a/arch/x86/pci/acpi.c b/arch/x86/pci/acpi.c
>> index 2f82480fd430..45ef65d31a40 100644
>> --- a/arch/x86/pci/acpi.c
>> +++ b/arch/x86/pci/acpi.c
>> @@ -189,6 +189,19 @@ static const struct dmi_system_id pci_crs_quirks[] __initconst = {
>> DMI_MATCH(DMI_BOARD_NAME, "X170KM-G"),
>> },
>> },
>> +
>> + /*
>> + * Clevo NL4XLU barebones have the same E820 reservation covering
>> + * the entire _CRS 32-bit window issue as the Lenovo *IIL* models.
>> + * See https://bugzilla.kernel.org/show_bug.cgi?id=216565
>> + */
>> + {
>> + .callback = set_no_e820,
>> + .ident = "Clevo NL4XLU Barebone",
>> + .matches = {
>> + DMI_MATCH(DMI_BOARD_NAME, "NL4XLU"),
>> + },
>> + },
>> {}
>> };
>>
>> --
>> 2.37.3
>>
>
next prev parent reply other threads:[~2022-10-12 8:23 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2022-10-10 15:02 [PATCH] x86/PCI: Disable E820 reserved region clipping for Clevo NL4XLU laptops Hans de Goede
2022-10-11 17:40 ` Bjorn Helgaas
2022-10-12 8:23 ` Hans de Goede [this message]
2022-12-02 21:58 ` Bjorn Helgaas
2022-12-04 9:42 ` Hans de Goede
2022-12-06 17:26 ` Bjorn Helgaas
2022-12-06 19:26 ` Hans de Goede
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=a9203d47-5b85-c035-3ec7-973dcb6a840a@redhat.com \
--to=hdegoede@redhat.com \
--cc=bhelgaas@google.com \
--cc=helgaas@kernel.org \
--cc=linux-acpi@vger.kernel.org \
--cc=linux-pci@vger.kernel.org \
--cc=linuxkernelml@undead.fr \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox