Re: [PATCH v2 1/2] PCI/PM: refactor pci_pm_suspend_noirq()

["Rafael J. Wysocki" <rafael.j.wysocki@intel.com>]

On 3/18/2022 12:31 AM, Rajvi Jingar wrote:
> The state of the device is saved during pci_pm_suspend_noirq(), if it
> has not already been saved, regardless of the skip_bus_pm flag value. So
> skip_bus_pm check is removed before saving the device state.
>
> v2: add comments to the changes

As mentioned by Dave, this shouldn't be here.


> Signed-off-by: Rajvi Jingar <rajvi.jingar@intel.com>
> Suggested-by: David E. Box <david.e.box@linux.intel.com>
> ---
>   drivers/pci/pci-driver.c | 18 ++++++------------
>   1 file changed, 6 insertions(+), 12 deletions(-)
>
> diff --git a/drivers/pci/pci-driver.c b/drivers/pci/pci-driver.c
> index 588588cfda48..ffe76f238d7e 100644
> --- a/drivers/pci/pci-driver.c
> +++ b/drivers/pci/pci-driver.c
> @@ -834,20 +834,14 @@ static int pci_pm_suspend_noirq(struct device *dev)
>   		}
>   	}
>   
> -	if (pci_dev->skip_bus_pm) {
> +	if (!pci_dev->state_saved) {
> +		pci_save_state(pci_dev);
>   		/*
> -		 * Either the device is a bridge with a child in D0 below it, or
> -		 * the function is running for the second time in a row without
> -		 * going through full resume, which is possible only during
> -		 * suspend-to-idle in a spurious wakeup case.  The device should
> -		 * be in D0 at this point, but if it is a bridge, it may be
> -		 * necessary to save its state.
> +		 * If the device is a bridge with a child in D0 below it, it needs to
> +		 * stay in D0, so check skip_bus_pm to avoid putting it into a
> +		 * low-power state in that case.
>   		 */
> -		if (!pci_dev->state_saved)
> -			pci_save_state(pci_dev);
> -	} else if (!pci_dev->state_saved) {
> -		pci_save_state(pci_dev);
> -		if (pci_power_manageable(pci_dev))
> +		if (!pci_dev->skip_bus_pm && pci_power_manageable(pci_dev))
>   			pci_prepare_to_sleep(pci_dev);
>   	}
>