From: "Rob Herring (Arm)" <robh@kernel.org>
To: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
Cc: dri-devel@lists.freedesktop.org, conor+dt@kernel.org,
p.zabel@pengutronix.de, linux-mediatek@lists.infradead.org,
vkoul@kernel.org, chunfeng.yun@mediatek.com,
linux-phy@lists.infradead.org, matthias.bgg@gmail.com,
linux-arm-kernel@lists.infradead.org, kernel@collabora.com,
linux-kernel@vger.kernel.org, neil.armstrong@linaro.org,
justin.yeh@mediatek.com, krzk+dt@kernel.org,
devicetree@vger.kernel.org, chunkuang.hu@kernel.org
Subject: Re: [PATCH 01/12] dt-bindings: phy: Document MT8195 and MT8196 DisplayPort PHYs
Date: Wed, 01 Jul 2026 09:38:50 -0500 [thread overview]
Message-ID: <178291673047.19807.6106947084460440701.robh@kernel.org> (raw)
In-Reply-To: <20260701122008.19509-2-angelogioacchino.delregno@collabora.com>
On Wed, 01 Jul 2026 14:19:57 +0200, AngeloGioacchino Del Regno wrote:
> This adds bindings for the DisplayPort and Embedded DisplayPort
> PHYs found in the MediaTek MT8195 SoC (and variants of) and for
> the Embedded DisplayPort found in the MT8196 SoC (and variants).
>
> This PHY supports varying impedance calibrations for the various
> signals to reach an optimal EYE signal pattern for any specific
> board(s), especially useful for very high bitrates such as HBR3
> and higher, depending on board design.
>
> Signed-off-by: AngeloGioacchino Del Regno <angelogioacchino.delregno@collabora.com>
> ---
> .../bindings/phy/mediatek,mt8195-dp-phy.yaml | 77 +++++++++++++++++++
> 1 file changed, 77 insertions(+)
> create mode 100644 Documentation/devicetree/bindings/phy/mediatek,mt8195-dp-phy.yaml
>
My bot found errors running 'make dt_binding_check' on your patch:
yamllint warnings/errors:
dtschema/dtc warnings/errors:
/builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/phy/mediatek,mt8195-dp-phy.example.dtb: phy@1c500000 (mediatek,mt8195-dp-phy): reg: [[0, 475004928], [0, 8192]] is too long
from schema $id: http://devicetree.org/schemas/phy/mediatek,mt8195-dp-phy.yaml
doc reference errors (make refcheckdocs):
See https://patchwork.kernel.org/project/devicetree/patch/20260701122008.19509-2-angelogioacchino.delregno@collabora.com
The base for the series is generally the latest rc1. A different dependency
should be noted in *this* patch.
If you already ran 'make dt_binding_check' and didn't see the above
error(s), then make sure 'yamllint' is installed and dt-schema is up to
date:
pip3 install dtschema --upgrade
Please check and re-submit after running the above command yourself. Note
that DT_SCHEMA_FILES can be set to your schema file to speed up checking
your schema. However, it must be unset to test all examples with your schema.
--
linux-phy mailing list
linux-phy@lists.infradead.org
https://lists.infradead.org/mailman/listinfo/linux-phy
next prev parent reply other threads:[~2026-07-01 14:38 UTC|newest]
Thread overview: 28+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-07-01 12:19 [PATCH 00/12] PHY: MediaTek DP PHY refactor and MT8196 eDP AngeloGioacchino Del Regno
2026-07-01 12:19 ` [PATCH 01/12] dt-bindings: phy: Document MT8195 and MT8196 DisplayPort PHYs AngeloGioacchino Del Regno
2026-07-01 12:27 ` sashiko-bot
2026-07-01 13:07 ` AngeloGioacchino Del Regno
2026-07-01 14:38 ` Rob Herring (Arm) [this message]
2026-07-01 12:19 ` [PATCH 02/12] phy: phy-mtk-dp: Rename regs to regmap in struct mtk_dp_phy AngeloGioacchino Del Regno
2026-07-01 12:26 ` sashiko-bot
2026-07-01 13:05 ` AngeloGioacchino Del Regno
2026-07-01 12:19 ` [PATCH 03/12] phy: phy-mtk-dp: Allow probing with devicetree match AngeloGioacchino Del Regno
2026-07-01 12:30 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 04/12] phy: phy-mtk-dp: Migrate register offsets to SoC specific pdata AngeloGioacchino Del Regno
2026-07-01 12:36 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 05/12] phy: phy-mtk-dp: Implement power_on and power_off PHY callbacks AngeloGioacchino Del Regno
2026-07-01 12:39 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 06/12] phy: phy-mtk-dp: Support set_lanes in configure and properly cleanup AngeloGioacchino Del Regno
2026-07-01 12:35 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 07/12] phy: phy-mtk-dp: Support setting volt swing and preemphasis values AngeloGioacchino Del Regno
2026-07-01 12:49 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 08/12] phy: phy-mtk-dp: Add support for digital and analog calibration AngeloGioacchino Del Regno
2026-07-01 12:48 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 09/12] phy: phy-mtk-dp: Rewrite and document default driving param macros AngeloGioacchino Del Regno
2026-07-01 12:50 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 10/12] phy: phy-mtk-dp: Add bitrate register val definitions to SoC data AngeloGioacchino Del Regno
2026-07-01 13:02 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 11/12] phy: phy-mtk-dp: Add PHYD Lane EN register mask " AngeloGioacchino Del Regno
2026-07-01 13:07 ` sashiko-bot
2026-07-01 12:20 ` [PATCH 12/12] phy: phy-mtk-dp: Add support for MT8196 eDP PHY AngeloGioacchino Del Regno
2026-07-01 13:01 ` sashiko-bot
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=178291673047.19807.6106947084460440701.robh@kernel.org \
--to=robh@kernel.org \
--cc=angelogioacchino.delregno@collabora.com \
--cc=chunfeng.yun@mediatek.com \
--cc=chunkuang.hu@kernel.org \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=dri-devel@lists.freedesktop.org \
--cc=justin.yeh@mediatek.com \
--cc=kernel@collabora.com \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mediatek@lists.infradead.org \
--cc=linux-phy@lists.infradead.org \
--cc=matthias.bgg@gmail.com \
--cc=neil.armstrong@linaro.org \
--cc=p.zabel@pengutronix.de \
--cc=vkoul@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox