[PATCH] phy: phy-mtk-tphy: Update names and format of kernel-doc comments

[Vinod Koul <vkoul@kernel.org>]

mtk_phy_pdata documentation does not use correct tag for struct, while at
it fix one of member wrongly documented.

Warning: drivers/phy/mediatek/phy-mtk-tphy.c:289 cannot understand function prototype: 'struct mtk_phy_pdata'
Warning: drivers/phy/mediatek/phy-mtk-tphy.c:296 struct member 'slew_ref_clock_mhz' not described in 'mtk_phy_pdata'

Signed-off-by: Vinod Koul <vkoul@kernel.org>
---
 drivers/phy/mediatek/phy-mtk-tphy.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/phy/mediatek/phy-mtk-tphy.c b/drivers/phy/mediatek/phy-mtk-tphy.c
index f6504e0ecd1a..acf506529507 100644
--- a/drivers/phy/mediatek/phy-mtk-tphy.c
+++ b/drivers/phy/mediatek/phy-mtk-tphy.c
@@ -276,14 +276,14 @@ enum mtk_phy_version {
 };
 
 /**
- * mtk_phy_pdata - SoC specific platform data
+ * struct mtk_phy_pdata - SoC specific platform data
  * @avoid_rx_sen_degradation: Avoid TX Sensitivity level degradation (MT6795/8173 only)
  * @sw_pll_48m_to_26m:        Workaround for V3 IP (MT8195) - switch the 48MHz PLL from
  *                            fractional mode to integer to output 26MHz for U2PHY
  * @sw_efuse_supported:       Switches off eFuse auto-load from PHY and applies values
  *                            read from different nvmem (usually different eFuse array)
  *                            that is pointed at in the device tree node for this PHY
- * @slew_ref_clk_mhz:         Default reference clock (in MHz) for slew rate calibration
+ * @slew_ref_clock_mhz:         Default reference clock (in MHz) for slew rate calibration
  * @slew_rate_coefficient:    Coefficient for slew rate calibration
  * @version:                  PHY IP Version
  */
-- 
2.43.0


-- 
linux-phy mailing list
linux-phy@lists.infradead.org
https://lists.infradead.org/mailman/listinfo/linux-phy