[PATCH v2 2/2] phy: rockchip: inno-hdmi: Remove deprecated way to configure TMDS rate

[Jonas Karlman <jonas@kwiboo.se>]

The TMDS character rate of this PHY is configured using PHY bus width
in downstream vendor kernel and out-of-tree patches, however no in-tree
consumer of this PHY has ever called phy_set_bus_width() to change the
TMDS character rate as currently only 8-bit RGB output is supported by
the HDMI display driver.

The series "Split Generic PHY consumer and provider" clarifies that
phy_set_bus_width() is intended as a provider-only function.

Remove the deprecated unused fallback way to configure TMDS character
rate now that this HDMI PHY support using phy_configure() to configure
the TMDS character rate.

Signed-off-by: Jonas Karlman <jonas@kwiboo.se>
---
v2: New patch, split from original patch
---
 drivers/phy/rockchip/phy-rockchip-inno-hdmi.c | 17 +----------------
 1 file changed, 1 insertion(+), 16 deletions(-)

diff --git a/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c b/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c
index 9cfe956fefe7..5e76a1ea9d9f 100644
--- a/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c
+++ b/drivers/phy/rockchip/phy-rockchip-inno-hdmi.c
@@ -555,24 +555,10 @@ static inline void inno_update_bits(struct inno_hdmi_phy *inno, u8 reg,
 static unsigned long inno_hdmi_phy_get_tmdsclk(struct inno_hdmi_phy *inno,
 					       unsigned long rate)
 {
-	int bus_width;
-
 	if (inno->hdmi_cfg.tmds_char_rate)
 		return inno->hdmi_cfg.tmds_char_rate;
 
-	bus_width = phy_get_bus_width(inno->phy);
-
-	switch (bus_width) {
-	case 4:
-	case 5:
-	case 6:
-	case 10:
-	case 12:
-	case 16:
-		return (u64)rate * bus_width / 8;
-	default:
-		return rate;
-	}
+	return rate;
 }
 
 static irqreturn_t inno_hdmi_phy_rk3328_hardirq(int irq, void *dev_id)
@@ -1437,7 +1423,6 @@ static int inno_hdmi_phy_probe(struct platform_device *pdev)
 
 	phy_set_drvdata(inno->phy, inno);
 	phy_set_mode_ext(inno->phy, PHY_MODE_HDMI, PHY_HDMI_MODE_TMDS);
-	phy_set_bus_width(inno->phy, 8);
 
 	if (inno->plat_data->ops->init) {
 		ret = inno->plat_data->ops->init(inno);
-- 
2.54.0


-- 
linux-phy mailing list
linux-phy@lists.infradead.org
https://lists.infradead.org/mailman/listinfo/linux-phy