[PATCH v3 1/4] phy: qcom: qmp-pcie: Skip PHY reset if already up

[Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>]

If the bootloader has already powered up the PCIe PHY, performing a
full reset and waiting for the PHY to come up again adds unnecessary
delay during boot.

Extend the existing skip_init handling by introducing a skip_reset
condition. When skip_init is active and the PHY status indicates that
the PHY is already operational, skip asserting and deasserting the
no-csr reset while still enabling the required resources during
power-on.

This allows reusing the bootloader-initialized PHY state and avoids
redundant PHY reinitialization and PCIe link retraining, which can
add hundred's of milliseconds of delay.

This relies on the assumption that when skip_init is enabled and the
PHY is reported as up, the bootloader has already configured the PHY
correctly and the link is in a usable state.

Reviewed-by: Abel Vesa <abel.vesa@oss.qualcomm.com>
Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
Tested-by: Qiang Yu <qiang.yu@oss.qualcomm.com>
Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>
---
 drivers/phy/qualcomm/phy-qcom-qmp-pcie.c | 31 +++++++++++++++++++++----------
 1 file changed, 21 insertions(+), 10 deletions(-)

diff --git a/drivers/phy/qualcomm/phy-qcom-qmp-pcie.c b/drivers/phy/qualcomm/phy-qcom-qmp-pcie.c
index d3effad7a074..49e10151cb1e 100644
--- a/drivers/phy/qualcomm/phy-qcom-qmp-pcie.c
+++ b/drivers/phy/qualcomm/phy-qcom-qmp-pcie.c
@@ -4862,6 +4862,7 @@ static int qmp_pcie_init(struct phy *phy)
 	struct qmp_pcie *qmp = phy_get_drvdata(phy);
 	const struct qmp_phy_cfg *cfg = qmp->cfg;
 	void __iomem *pcs = qmp->pcs;
+	bool skip_reset;
 	int ret;
 
 	/*
@@ -4877,6 +4878,9 @@ static int qmp_pcie_init(struct phy *phy)
 		qphy_checkbits(pcs, cfg->regs[QPHY_START_CTRL], SERDES_START | PCS_START) &&
 		qphy_checkbits(pcs, cfg->regs[QPHY_PCS_POWER_DOWN_CONTROL], cfg->pwrdn_ctrl);
 
+	skip_reset = qmp->skip_init && !qphy_checkbits(pcs, cfg->regs[QPHY_PCS_STATUS],
+							    cfg->phy_status);
+
 	if (!qmp->skip_init && !cfg->tbls.serdes_num) {
 		dev_err(qmp->dev, "Init sequence not available\n");
 		return -ENODATA;
@@ -4900,13 +4904,15 @@ static int qmp_pcie_init(struct phy *phy)
 		}
 	}
 
-	ret = reset_control_assert(qmp->nocsr_reset);
-	if (ret) {
-		dev_err(qmp->dev, "no-csr reset assert failed\n");
-		goto err_assert_reset;
-	}
+	if (!skip_reset) {
+		ret = reset_control_assert(qmp->nocsr_reset);
+		if (ret) {
+			dev_err(qmp->dev, "no-csr reset assert failed\n");
+			goto err_assert_reset;
+		}
 
-	usleep_range(200, 300);
+		usleep_range(200, 300);
+	}
 
 	if (!qmp->skip_init) {
 		ret = reset_control_bulk_deassert(cfg->num_resets, qmp->resets);
@@ -4956,8 +4962,11 @@ static int qmp_pcie_power_on(struct phy *phy)
 	void __iomem *pcs = qmp->pcs;
 	void __iomem *status;
 	unsigned int mask, val;
+	bool skip_reset;
 	int ret;
 
+	skip_reset = qmp->skip_init && !qphy_checkbits(pcs, cfg->regs[QPHY_PCS_STATUS],
+							    cfg->phy_status);
 	/*
 	 * Write CSR register for PHY that doesn't support no_csr reset or has not
 	 * been initialized.
@@ -4981,10 +4990,12 @@ static int qmp_pcie_power_on(struct phy *phy)
 	if (ret)
 		return ret;
 
-	ret = reset_control_deassert(qmp->nocsr_reset);
-	if (ret) {
-		dev_err(qmp->dev, "no-csr reset deassert failed\n");
-		goto err_disable_pipe_clk;
+	if (!skip_reset) {
+		ret = reset_control_deassert(qmp->nocsr_reset);
+		if (ret) {
+			dev_err(qmp->dev, "no-csr reset deassert failed\n");
+			goto err_disable_pipe_clk;
+		}
 	}
 
 	if (qmp->skip_init)

-- 
2.34.1


-- 
linux-phy mailing list
linux-phy@lists.infradead.org
https://lists.infradead.org/mailman/listinfo/linux-phy