Re: [PATCH V3 3/4] arm64: dts: qcom: hamoa: Add UFS nodes for x1e80100 SoC

[Pradeep Pragallapati <pradeep.pragallapati@oss.qualcomm.com>]

On 1/6/2026 1:36 PM, Manivannan Sadhasivam wrote:
> On Mon, Jan 05, 2026 at 08:16:42PM +0530, Pradeep P V K wrote:
>> Add UFS host controller and PHY nodes for x1e80100 SoC.
>>
> 
> Minor nits below. With those fixed,
> 
> Reviewed-by: Manivannan Sadhasivam <mani@kernel.org>
> 
>> Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
>> Reviewed-by: Abel Vesa <abel.vesa@oss.qualcomm.com>
>> Reviewed-by: Taniya Das <taniya.das@oss.qualcomm.com>
>> Signed-off-by: Pradeep P V K <pradeep.pragallapati@oss.qualcomm.com>
>> ---
>>   arch/arm64/boot/dts/qcom/hamoa.dtsi | 123 +++++++++++++++++++++++++++-
>>   1 file changed, 120 insertions(+), 3 deletions(-)
>>
>> diff --git a/arch/arm64/boot/dts/qcom/hamoa.dtsi b/arch/arm64/boot/dts/qcom/hamoa.dtsi
>> index f7d71793bc77..33899fa06aa4 100644
>> --- a/arch/arm64/boot/dts/qcom/hamoa.dtsi
>> +++ b/arch/arm64/boot/dts/qcom/hamoa.dtsi
>> @@ -835,9 +835,9 @@ gcc: clock-controller@100000 {
>>   				 <0>,
>>   				 <0>,
>>   				 <0>,
>> -				 <0>,
>> -				 <0>,
>> -				 <0>;
>> +				 <&ufs_mem_phy 0>,
>> +				 <&ufs_mem_phy 1>,
>> +				 <&ufs_mem_phy 2>;
>>   
>>   			power-domains = <&rpmhpd RPMHPD_CX>;
>>   			#clock-cells = <1>;
>> @@ -3848,6 +3848,123 @@ pcie4_phy: phy@1c0e000 {
>>   			status = "disabled";
>>   		};
>>   
>> +		ufs_mem_phy: phy@1d80000 {
>> +			compatible = "qcom,x1e80100-qmp-ufs-phy",
>> +				     "qcom,sm8550-qmp-ufs-phy";
>> +			reg = <0x0 0x01d80000 0x0 0x2000>;
>> +
>> +			clocks = <&rpmhcc RPMH_CXO_CLK>,
>> +				 <&gcc GCC_UFS_PHY_PHY_AUX_CLK>,
>> +				 <&tcsr TCSR_UFS_PHY_CLKREF_EN>;
>> +
>> +			clock-names = "ref",
>> +				      "ref_aux",
>> +				      "qref";
>> +			resets = <&ufs_mem_hc 0>;
>> +			reset-names = "ufsphy";
>> +
>> +			power-domains = <&gcc GCC_UFS_MEM_PHY_GDSC>;
>> +
>> +			#clock-cells = <1>;
>> +			#phy-cells = <0>;
>> +
>> +			status = "disabled";
>> +		};
>> +
>> +		ufs_mem_hc: ufs@1d84000 {
> 
> ufshc@
ok, i will update in the next patchset.
> 
>> +			compatible = "qcom,x1e80100-ufshc",
>> +				     "qcom,sm8550-ufshc",
>> +				     "qcom,ufshc",
>> +				     "jedec,ufs-2.0";
> 
> Drop jedec compatible as Qcom UFS controller cannot fallback to generic ufshc
> driver.
"jedec,ufs-2.0" was set to const in dt-bindings, dropping now will lead 
to dtbs_check failures. is it ok, if i continue with it ?
> 
> - Mani
> 


-- 
linux-phy mailing list
linux-phy@lists.infradead.org
https://lists.infradead.org/mailman/listinfo/linux-phy