* Problem "waking-up"
@ 2009-06-12 3:08 Isamar Maia
2009-06-21 6:49 ` Pavel Machek
0 siblings, 1 reply; 3+ messages in thread
From: Isamar Maia @ 2009-06-12 3:08 UTC (permalink / raw)
To: linux-pm
Hi Folks,
Hope here is the right place to send this posting.
I am trying to make a notebook working with all its features and I am
facing a hard
work with that.
It is a SiS based Chipset as the lscpi output says below:
00:00.0 Host bridge: Silicon Integrated Systems [SiS] 671MX
00:01.0 PCI bridge: Silicon Integrated Systems [SiS] SiS AGP Port
(virtual PCI-to-PCI bridge)
00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS968 [MuTIOL
Media IO] (rev 01)
00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev 01)
00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
Controller (rev 0f)
00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
Controller (rev 0f)
00:03.3 USB Controller: Silicon Integrated Systems [SiS] USB 2.0 Controller
00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] 191
Gigabit Ethernet Adapter (rev 02)
00:05.0 IDE interface: Silicon Integrated Systems [SiS] SATA
Controller / IDE mode (rev 03)
00:06.0 PCI bridge: Silicon Integrated Systems [SiS] PCI-to-PCI bridge
00:07.0 PCI bridge: Silicon Integrated Systems [SiS] PCI-to-PCI bridge
00:0d.0 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller (rev 05)
00:0d.1 SD Host controller: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro
Host Adapter (rev 22)
00:0d.2 System peripheral: Ricoh Co Ltd R5C843 MMC Host Controller (rev 12)
00:0d.3 System peripheral: Ricoh Co Ltd R5C592 Memory Stick Bus Host
Adapter (rev 12)
00:0d.4 System peripheral: Ricoh Co Ltd xD-Picture Card Controller (rev ff)
00:0f.0 Audio device: Silicon Integrated Systems [SiS] Azalia Audio Controller
01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS]
771/671 PCIE VGA Display Adapter (rev 10)
02:00.0 Ethernet controller: Atheros Communications Inc. AR242x
802.11abg Wireless PCI Express Adapter (rev 01)
For xorg, I am using VESA video driver. For wifi, I am using ath_pci
driver. and for audio, I am using
snd_hda_intel alsa driver.
I can use "suspend" but I cannot "wakeup" back after that. The screen
stays blank and I can see
the CDROM led blinking like trying to detect some media inside.
I am using Fedora 9's kernel 2.6.26.5-45.i686 and, for specific
reasons, I cannot upgrade the kernel at all, but I can apply
any patch if necessary.
I appreciate any help.
--
Isamar Maia
Brazil: 55-71-9146-8575
55-71-4062-8688
日本: +81-(0)3-4550-1212
"In a world without walls. Who needs windows and gates?"
^ permalink raw reply [flat|nested] 3+ messages in thread* Re: Problem "waking-up"
2009-06-12 3:08 Problem "waking-up" Isamar Maia
@ 2009-06-21 6:49 ` Pavel Machek
2009-06-21 13:30 ` Isamar Maia
0 siblings, 1 reply; 3+ messages in thread
From: Pavel Machek @ 2009-06-21 6:49 UTC (permalink / raw)
To: Isamar Maia; +Cc: linux-pm
On Fri 2009-06-12 00:08:38, Isamar Maia wrote:
> Hi Folks,
>
> Hope here is the right place to send this posting.
>
> I am trying to make a notebook working with all its features and I am
> facing a hard
> work with that.
>
> It is a SiS based Chipset as the lscpi output says below:
>
> 00:00.0 Host bridge: Silicon Integrated Systems [SiS] 671MX
> 00:01.0 PCI bridge: Silicon Integrated Systems [SiS] SiS AGP Port
> (virtual PCI-to-PCI bridge)
> 00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS968 [MuTIOL
> Media IO] (rev 01)
> 00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev 01)
> 00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
> Controller (rev 0f)
> 00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
> Controller (rev 0f)
> 00:03.3 USB Controller: Silicon Integrated Systems [SiS] USB 2.0 Controller
> 00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] 191
> Gigabit Ethernet Adapter (rev 02)
> 00:05.0 IDE interface: Silicon Integrated Systems [SiS] SATA
> Controller / IDE mode (rev 03)
> 00:06.0 PCI bridge: Silicon Integrated Systems [SiS] PCI-to-PCI bridge
> 00:07.0 PCI bridge: Silicon Integrated Systems [SiS] PCI-to-PCI bridge
> 00:0d.0 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller (rev 05)
> 00:0d.1 SD Host controller: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro
> Host Adapter (rev 22)
> 00:0d.2 System peripheral: Ricoh Co Ltd R5C843 MMC Host Controller (rev 12)
> 00:0d.3 System peripheral: Ricoh Co Ltd R5C592 Memory Stick Bus Host
> Adapter (rev 12)
> 00:0d.4 System peripheral: Ricoh Co Ltd xD-Picture Card Controller (rev ff)
> 00:0f.0 Audio device: Silicon Integrated Systems [SiS] Azalia Audio Controller
> 01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS]
> 771/671 PCIE VGA Display Adapter (rev 10)
> 02:00.0 Ethernet controller: Atheros Communications Inc. AR242x
> 802.11abg Wireless PCI Express Adapter (rev 01)
>
>
> For xorg, I am using VESA video driver. For wifi, I am using ath_pci
> driver. and for audio, I am using
> snd_hda_intel alsa driver.
>
> I can use "suspend" but I cannot "wakeup" back after that. The screen
> stays blank and I can see
> the CDROM led blinking like trying to detect some media inside.
>
> I am using Fedora 9's kernel 2.6.26.5-45.i686 and, for specific
> reasons, I cannot upgrade the kernel at all, but I can apply
> any patch if necessary.
Apply diff between 2.6.26 and 2.6.30?
Ask fedora for help?
Try again with minimum drivers?
Pavel
--
(english) http://www.livejournal.com/~pavelmachek
(cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
^ permalink raw reply [flat|nested] 3+ messages in thread
* Re: Problem "waking-up"
2009-06-21 6:49 ` Pavel Machek
@ 2009-06-21 13:30 ` Isamar Maia
0 siblings, 0 replies; 3+ messages in thread
From: Isamar Maia @ 2009-06-21 13:30 UTC (permalink / raw)
To: Pavel Machek; +Cc: linux-pm
OK. Thank you very much. I will try that.
Isamar
2009/6/21 Pavel Machek <pavel@ucw.cz>:
> On Fri 2009-06-12 00:08:38, Isamar Maia wrote:
>> Hi Folks,
>>
>> Hope here is the right place to send this posting.
>>
>> I am trying to make a notebook working with all its features and I am
>> facing a hard
>> work with that.
>>
>> It is a SiS based Chipset as the lscpi output says below:
>>
>> 00:00.0 Host bridge: Silicon Integrated Systems [SiS] 671MX
>> 00:01.0 PCI bridge: Silicon Integrated Systems [SiS] SiS AGP Port
>> (virtual PCI-to-PCI bridge)
>> 00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS968 [MuTIOL
>> Media IO] (rev 01)
>> 00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev 01)
>> 00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
>> Controller (rev 0f)
>> 00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.1
>> Controller (rev 0f)
>> 00:03.3 USB Controller: Silicon Integrated Systems [SiS] USB 2.0 Controller
>> 00:04.0 Ethernet controller: Silicon Integrated Systems [SiS] 191
>> Gigabit Ethernet Adapter (rev 02)
>> 00:05.0 IDE interface: Silicon Integrated Systems [SiS] SATA
>> Controller / IDE mode (rev 03)
>> 00:06.0 PCI bridge: Silicon Integrated Systems [SiS] PCI-to-PCI bridge
>> 00:07.0 PCI bridge: Silicon Integrated Systems [SiS] PCI-to-PCI bridge
>> 00:0d.0 FireWire (IEEE 1394): Ricoh Co Ltd R5C832 IEEE 1394 Controller (rev 05)
>> 00:0d.1 SD Host controller: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro
>> Host Adapter (rev 22)
>> 00:0d.2 System peripheral: Ricoh Co Ltd R5C843 MMC Host Controller (rev 12)
>> 00:0d.3 System peripheral: Ricoh Co Ltd R5C592 Memory Stick Bus Host
>> Adapter (rev 12)
>> 00:0d.4 System peripheral: Ricoh Co Ltd xD-Picture Card Controller (rev ff)
>> 00:0f.0 Audio device: Silicon Integrated Systems [SiS] Azalia Audio Controller
>> 01:00.0 VGA compatible controller: Silicon Integrated Systems [SiS]
>> 771/671 PCIE VGA Display Adapter (rev 10)
>> 02:00.0 Ethernet controller: Atheros Communications Inc. AR242x
>> 802.11abg Wireless PCI Express Adapter (rev 01)
>>
>>
>> For xorg, I am using VESA video driver. For wifi, I am using ath_pci
>> driver. and for audio, I am using
>> snd_hda_intel alsa driver.
>>
>> I can use "suspend" but I cannot "wakeup" back after that. The screen
>> stays blank and I can see
>> the CDROM led blinking like trying to detect some media inside.
>>
>> I am using Fedora 9's kernel 2.6.26.5-45.i686 and, for specific
>> reasons, I cannot upgrade the kernel at all, but I can apply
>> any patch if necessary.
>
> Apply diff between 2.6.26 and 2.6.30?
>
> Ask fedora for help?
>
> Try again with minimum drivers?
> Pavel
> --
> (english) http://www.livejournal.com/~pavelmachek
> (cesky, pictures) http://atrey.karlin.mff.cuni.cz/~pavel/picture/horses/blog.html
>
--
Isamar Maia
Brazil: 55-71-9146-8575
55-71-4062-8688
日本: +81-(0)3-4550-1212
"In a world without walls. Who needs windows and gates?"
^ permalink raw reply [flat|nested] 3+ messages in thread
end of thread, other threads:[~2009-06-21 13:30 UTC | newest]
Thread overview: 3+ messages (download: mbox.gz follow: Atom feed
-- links below jump to the message on this page --
2009-06-12 3:08 Problem "waking-up" Isamar Maia
2009-06-21 6:49 ` Pavel Machek
2009-06-21 13:30 ` Isamar Maia
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox