[PATCH v3 0/3] Add exynosautov920 thermal support

[Shin Son <shin.son@samsung.com>]

This change merges the new exynosautov920-specific register definitions and
timing parameters into the exynos-tmu driver, ensuring consistent behavior
across all Exynos series. All new code paths have been tested on a
exynosautov920 board and verified to correctly read temperatures and
emulate behavior.

Changes in v3:
- Removed redundant commit message.
- Rephrased the sentences to describe the hardware clearly.
- Restricted sensor indices to V920.
- Set #thermal-sensor-celss per variant.
- Replaced 'additionalProperties' with 'unevaluatedProperties'.
- Removed the duplicate #define and use the original.
- Used lowercase hex in #define.
- Simplified 'temp_to_code' and 'code_to_temp' to one computation
  path by normalizing calib_temp.

Changes in v2:
- Replace the generic property with a vendor-specific one.
- Added an indices property instead of ranges.
- Shortened thermal node name and made them more generic.
- Updated the indices logic accordingly after removing the ranges property.

Shin Son (3):
  dt-bindings: thermal: samsung: Add a hw-sensor-indices property
  thermal: exynos_tmu: Support new hardware and update TMU interface
  arm64: dts: exynosautov920: Add tmu hardware binding

 .../thermal/samsung,exynos-thermal.yaml       |  40 ++-
 .../boot/dts/exynos/exynosautov920-tmu.dtsi   |  97 ++++++
 .../arm64/boot/dts/exynos/exynosautov920.dtsi |  31 ++
 drivers/thermal/samsung/exynos_tmu.c          | 324 ++++++++++++++++--
 4 files changed, 453 insertions(+), 39 deletions(-)
 create mode 100644 arch/arm64/boot/dts/exynos/exynosautov920-tmu.dtsi

-- 
2.50.1