[PATCH RFC 12/12] arm64: dts: mediatek: mt8188-geralt: Add WiFi/BT as M.2 E-key slot

[Chen-Yu Tsai <wenst@chromium.org>]

The MT8188 Geralt design features a chip-on-board WiFi/BT solution. This
is a M.2 E-key WiFi/BT board layout directly inserted into the mainboard
design. The connections to the rest of the board are almost the same as
if it were a separate M.2 card. The only addition is the PMU_EN pin on
the chip; on M.2 cards this would be tied to the primary power source.

Model the chip-on-board WiFi/BT solution as a M.2 E-key slot with PCIe,
USB and auxiliary signals. The PMU_EN pin, which enables the internal
power controls and regulators, is modeled as a regulator fed by the
pp3300_wlan regulator. Since power sequencing is now correctly modeled
using the M.2 E-key slot, drop the "regulator-always-on" property one
pp3300_wlan regulator. Also drop the comment in xhci2 saying "MT7921's
power is controlled by PCIe".

Also drop the voltage range on the pp3300_wlan regulator. This
"regulator" is just a load switch and does not provide any regulation.

Signed-off-by: Chen-Yu Tsai <wenst@chromium.org>
---
 .../boot/dts/mediatek/mt8188-geralt.dtsi      | 93 ++++++++++++++++++-
 1 file changed, 89 insertions(+), 4 deletions(-)

diff --git a/arch/arm64/boot/dts/mediatek/mt8188-geralt.dtsi b/arch/arm64/boot/dts/mediatek/mt8188-geralt.dtsi
index 4cb23595d17b..d7b5eb95ba0f 100644
--- a/arch/arm64/boot/dts/mediatek/mt8188-geralt.dtsi
+++ b/arch/arm64/boot/dts/mediatek/mt8188-geralt.dtsi
@@ -86,13 +86,11 @@ pp3300_z1: regulator-pp3300-z1 {
 	pp3300_wlan: regulator-pp3300-wlan {
 		compatible = "regulator-fixed";
 		regulator-name = "pp3300_wlan";
-		regulator-always-on;
-		regulator-min-microvolt = <3300000>;
-		regulator-max-microvolt = <3300000>;
 		enable-active-high;
 		gpio = <&pio 12 GPIO_ACTIVE_HIGH>;
 		pinctrl-0 = <&wlan_en>;
 		pinctrl-names = "default";
+		/* load switch */
 		vin-supply = <&pp3300_z1>;
 	};
 
@@ -159,6 +157,17 @@ ppvar_mipi_disp_avee: regulator-ppvar-mipi-disp-avee {
 		vin-supply = <&pp5000_z1>;
 	};
 
+	/* PMU_EN pin controls internal regulators and power sequence */
+	wlan_pmu: regulator-wlan-pmu {
+		compatible = "regulator-fixed";
+		regulator-name = "wlan-pmu";
+		enable-active-high;
+		gpio = <&pio 145 GPIO_ACTIVE_HIGH>;
+		pinctrl-0 = <&wlan_pmu_en>;
+		pinctrl-names = "default";
+		vin-supply = <&pp3300_wlan>;
+	};
+
 	reserved_memory: reserved-memory {
 		#address-cells = <2>;
 		#size-cells = <2>;
@@ -193,6 +202,39 @@ adsp_dma_mem: memory@61000000 {
 			no-map;
 		};
 	};
+
+	wifi-bt-connector {
+		compatible = "pcie-m2-e-connector";
+		pinctrl-names = "default";
+		pinctrl-0 = <&m2_e_key_kill_pins>;
+		vpcie1v8-supply = <&mt6359_vcn18_ldo_reg>;
+		vpcie3v3-supply = <&wlan_pmu>;
+		w-disable1-gpios = <&pio 13 GPIO_ACTIVE_LOW>;
+		w-disable2-gpios = <&pio 14 GPIO_ACTIVE_LOW>;
+
+		ports {
+			#address-cells = <1>;
+			#size-cells = <0>;
+
+			/* PCIe for WiFi */
+			port@0 {
+				reg = <0>;
+
+				wifi_ep: endpoint {
+					remote-endpoint = <&pcie_ep>;
+				};
+			};
+
+			/* USB for Bluetooth */
+			port@2 {
+				reg = <2>;
+
+				bt_ep: endpoint {
+					remote-endpoint = <&usb2_ep>;
+				};
+			};
+		};
+	};
 };
 
 &adsp {
@@ -656,6 +698,22 @@ &pcie {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pcie_pins>;
 	status = "okay";
+
+	pcie@0 {
+		compatible = "pciclass,0604";
+		reg = <0 0 0 0 0>;
+		device_type = "pci";
+		num-lanes = <1>;
+		#address-cells = <3>;
+		#size-cells = <2>;
+		ranges;
+
+		port {
+			pcie_ep: endpoint {
+				remote-endpoint = <&wifi_ep>;
+			};
+		};
+	};
 };
 
 &pciephy {
@@ -999,6 +1057,14 @@ pins-bus {
 		};
 	};
 
+	m2_e_key_kill_pins: m2-e-key-kill-pins {
+		pins-kill {
+			pinmux = <PINMUX_GPIO13__FUNC_B_GPIO13>,
+				 <PINMUX_GPIO14__FUNC_B_GPIO14>;
+			output-high;
+		};
+	};
+
 	mipi_disp_avdd_en: mipi-disp-avdd-en-pins {
 		pins-en-ppvar-mipi-disp {
 			pinmux = <PINMUX_GPIO3__FUNC_B_GPIO3>;
@@ -1163,6 +1229,13 @@ pins-bus {
 		};
 	};
 
+	wlan_pmu_en: wlan-pmu-en-pins {
+		pins-wlan-pmu-en {
+			pinmux = <PINMUX_GPIO145__FUNC_B_GPIO145>;
+			output-low;
+		};
+	};
+
 	wlan_en: wlan-en-pins {
 		pins-en-pp3300-wlan {
 			pinmux = <PINMUX_GPIO12__FUNC_B_GPIO12>;
@@ -1342,10 +1415,22 @@ vdosys1_ep_ext: endpoint@1 {
 };
 
 &xhci2 {
-	/* no power supply since MT7921's power is controlled by PCIe */
 	/* MT7921's USB BT has issues with USB2 LPM */
 	usb2-lpm-disable;
 	status = "okay";
+
+	ports {
+		#address-cells = <1>;
+		#size-cells = <0>;
+
+		port@1 {
+			reg = <1>;
+
+			usb2_ep: endpoint {
+				remote-endpoint = <&bt_ep>;
+			};
+		};
+	};
 };
 
 #include <arm/cros-ec-keyboard.dtsi>
-- 
2.54.0.563.g4f69b47b94-goog