From: "Rafael J. Wysocki" <rjw@rjwysocki.net>
To: Linux PM <linux-pm@vger.kernel.org>
Cc: LKML <linux-kernel@vger.kernel.org>,
Len Brown <len.brown@intel.com>,
Linux ACPI <linux-acpi@vger.kernel.org>,
Peter Zijlstra <peterz@infradead.org>,
Jacob Pan <jacob.jun.pan@linux.intel.com>,
Daniel Lezcano <daniel.lezcano@linaro.org>,
Sudeep Holla <sudeep.holla@arm.com>
Subject: [PATCH 1/3] cpuidle: Eliminate the CPUIDLE_DRIVER_STATE_START symbol
Date: Wed, 23 Aug 2017 23:19:57 +0200 [thread overview]
Message-ID: <2660674.9kuByRF0WC@aspire.rjw.lan> (raw)
In-Reply-To: <21794463.WNaOdcSnfv@aspire.rjw.lan>
From: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
On some architectures the first (index 0) idle state is a polling
one and it doesn't really save energy, so there is the
CPUIDLE_DRIVER_STATE_START symbol allowing some pieces of
cpuidle code to avoid using that state.
However, this makes the code rather hard to follow. It is better
to explicitly avoid the polling state, so add a new cpuidle state
flag CPUIDLE_FLAG_POLLING to mark it and make the relevant code
check that flag for the first state instead of using the
CPUIDLE_DRIVER_STATE_START symbol.
In the ACPI processor driver that cannot always rely on the state
flags (like before the states table has been set up) define
a new internal symbol ACPI_IDLE_STATE_START equivalent to the
CPUIDLE_DRIVER_STATE_START one and drop the latter.
Signed-off-by: Rafael J. Wysocki <rafael.j.wysocki@intel.com>
---
drivers/acpi/processor_idle.c | 10 ++++++----
drivers/cpuidle/driver.c | 1 +
drivers/cpuidle/governors/ladder.c | 14 ++++++++------
drivers/cpuidle/governors/menu.c | 13 +++++--------
include/linux/cpuidle.h | 7 +------
5 files changed, 21 insertions(+), 24 deletions(-)
Index: linux-pm/include/linux/cpuidle.h
===================================================================
--- linux-pm.orig/include/linux/cpuidle.h
+++ linux-pm/include/linux/cpuidle.h
@@ -63,6 +63,7 @@ struct cpuidle_state {
/* Idle State Flags */
#define CPUIDLE_FLAG_NONE (0x00)
+#define CPUIDLE_FLAG_POLLING (0x01) /* polling state */
#define CPUIDLE_FLAG_COUPLED (0x02) /* state applies to multiple cpus */
#define CPUIDLE_FLAG_TIMER_STOP (0x04) /* timer is stopped on this state */
@@ -250,12 +251,6 @@ static inline int cpuidle_register_gover
{return 0;}
#endif
-#ifdef CONFIG_ARCH_HAS_CPU_RELAX
-#define CPUIDLE_DRIVER_STATE_START 1
-#else
-#define CPUIDLE_DRIVER_STATE_START 0
-#endif
-
#define CPU_PM_CPU_IDLE_ENTER(low_level_idle_enter, idx) \
({ \
int __ret; \
Index: linux-pm/drivers/cpuidle/driver.c
===================================================================
--- linux-pm.orig/drivers/cpuidle/driver.c
+++ linux-pm/drivers/cpuidle/driver.c
@@ -204,6 +204,7 @@ static void poll_idle_init(struct cpuidl
state->power_usage = -1;
state->enter = poll_idle;
state->disabled = false;
+ state->flags = CPUIDLE_FLAG_POLLING;
}
#else
static void poll_idle_init(struct cpuidle_driver *drv) {}
Index: linux-pm/drivers/cpuidle/governors/menu.c
===================================================================
--- linux-pm.orig/drivers/cpuidle/governors/menu.c
+++ linux-pm/drivers/cpuidle/governors/menu.c
@@ -324,8 +324,9 @@ static int menu_select(struct cpuidle_dr
expected_interval = get_typical_interval(data);
expected_interval = min(expected_interval, data->next_timer_us);
- if (CPUIDLE_DRIVER_STATE_START > 0) {
- struct cpuidle_state *s = &drv->states[CPUIDLE_DRIVER_STATE_START];
+ first_idx = 0;
+ if (drv->states[0].flags & CPUIDLE_FLAG_POLLING) {
+ struct cpuidle_state *s = &drv->states[1];
unsigned int polling_threshold;
/*
@@ -336,12 +337,8 @@ static int menu_select(struct cpuidle_dr
polling_threshold = max_t(unsigned int, 20, s->target_residency);
if (data->next_timer_us > polling_threshold &&
latency_req > s->exit_latency && !s->disabled &&
- !dev->states_usage[CPUIDLE_DRIVER_STATE_START].disable)
- first_idx = CPUIDLE_DRIVER_STATE_START;
- else
- first_idx = CPUIDLE_DRIVER_STATE_START - 1;
- } else {
- first_idx = 0;
+ !dev->states_usage[1].disable)
+ first_idx = 1;
}
/*
Index: linux-pm/drivers/cpuidle/governors/ladder.c
===================================================================
--- linux-pm.orig/drivers/cpuidle/governors/ladder.c
+++ linux-pm/drivers/cpuidle/governors/ladder.c
@@ -69,6 +69,7 @@ static int ladder_select_state(struct cp
struct ladder_device *ldev = this_cpu_ptr(&ladder_devices);
struct ladder_device_state *last_state;
int last_residency, last_idx = ldev->last_state_idx;
+ int first_idx = drv->states[0].flags & CPUIDLE_FLAG_POLLING ? 1 : 0;
int latency_req = pm_qos_request(PM_QOS_CPU_DMA_LATENCY);
/* Special case when user has set very strict latency requirement */
@@ -96,13 +97,13 @@ static int ladder_select_state(struct cp
}
/* consider demotion */
- if (last_idx > CPUIDLE_DRIVER_STATE_START &&
+ if (last_idx > first_idx &&
(drv->states[last_idx].disabled ||
dev->states_usage[last_idx].disable ||
drv->states[last_idx].exit_latency > latency_req)) {
int i;
- for (i = last_idx - 1; i > CPUIDLE_DRIVER_STATE_START; i--) {
+ for (i = last_idx - 1; i > first_idx; i--) {
if (drv->states[i].exit_latency <= latency_req)
break;
}
@@ -110,7 +111,7 @@ static int ladder_select_state(struct cp
return i;
}
- if (last_idx > CPUIDLE_DRIVER_STATE_START &&
+ if (last_idx > first_idx &&
last_residency < last_state->threshold.demotion_time) {
last_state->stats.demotion_count++;
last_state->stats.promotion_count = 0;
@@ -133,13 +134,14 @@ static int ladder_enable_device(struct c
struct cpuidle_device *dev)
{
int i;
+ int first_idx = drv->states[0].flags & CPUIDLE_FLAG_POLLING ? 1 : 0;
struct ladder_device *ldev = &per_cpu(ladder_devices, dev->cpu);
struct ladder_device_state *lstate;
struct cpuidle_state *state;
- ldev->last_state_idx = CPUIDLE_DRIVER_STATE_START;
+ ldev->last_state_idx = first_idx;
- for (i = CPUIDLE_DRIVER_STATE_START; i < drv->state_count; i++) {
+ for (i = first_idx; i < drv->state_count; i++) {
state = &drv->states[i];
lstate = &ldev->states[i];
@@ -151,7 +153,7 @@ static int ladder_enable_device(struct c
if (i < drv->state_count - 1)
lstate->threshold.promotion_time = state->exit_latency;
- if (i > CPUIDLE_DRIVER_STATE_START)
+ if (i > first_idx)
lstate->threshold.demotion_time = state->exit_latency;
}
Index: linux-pm/drivers/acpi/processor_idle.c
===================================================================
--- linux-pm.orig/drivers/acpi/processor_idle.c
+++ linux-pm/drivers/acpi/processor_idle.c
@@ -48,6 +48,8 @@
#define _COMPONENT ACPI_PROCESSOR_COMPONENT
ACPI_MODULE_NAME("processor_idle");
+#define ACPI_IDLE_STATE_START (IS_ENABLED(CONFIG_ARCH_HAS_CPU_RELAX) ? 1 : 0)
+
static unsigned int max_cstate __read_mostly = ACPI_PROCESSOR_MAX_POWER;
module_param(max_cstate, uint, 0000);
static unsigned int nocst __read_mostly;
@@ -761,7 +763,7 @@ static int acpi_idle_enter(struct cpuidl
if (cx->type != ACPI_STATE_C1) {
if (acpi_idle_fallback_to_c1(pr) && num_online_cpus() > 1) {
- index = CPUIDLE_DRIVER_STATE_START;
+ index = ACPI_IDLE_STATE_START;
cx = per_cpu(acpi_cstate[index], dev->cpu);
} else if (cx->type == ACPI_STATE_C3 && pr->flags.bm_check) {
if (cx->bm_sts_skip || !acpi_idle_bm_check()) {
@@ -813,7 +815,7 @@ static void acpi_idle_enter_s2idle(struc
static int acpi_processor_setup_cpuidle_cx(struct acpi_processor *pr,
struct cpuidle_device *dev)
{
- int i, count = CPUIDLE_DRIVER_STATE_START;
+ int i, count = ACPI_IDLE_STATE_START;
struct acpi_processor_cx *cx;
if (max_cstate == 0)
@@ -840,7 +842,7 @@ static int acpi_processor_setup_cpuidle_
static int acpi_processor_setup_cstates(struct acpi_processor *pr)
{
- int i, count = CPUIDLE_DRIVER_STATE_START;
+ int i, count = ACPI_IDLE_STATE_START;
struct acpi_processor_cx *cx;
struct cpuidle_state *state;
struct cpuidle_driver *drv = &acpi_idle_driver;
@@ -1291,7 +1293,7 @@ static int acpi_processor_setup_cpuidle_
return -EINVAL;
drv->safe_state_index = -1;
- for (i = CPUIDLE_DRIVER_STATE_START; i < CPUIDLE_STATE_MAX; i++) {
+ for (i = ACPI_IDLE_STATE_START; i < CPUIDLE_STATE_MAX; i++) {
drv->states[i].name[0] = '\0';
drv->states[i].desc[0] = '\0';
}
next prev parent reply other threads:[~2017-08-23 21:19 UTC|newest]
Thread overview: 7+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-08-23 21:18 [PATCH 0/3] cpuidle: Rework the handling of the poll state Rafael J. Wysocki
2017-08-23 21:19 ` Rafael J. Wysocki [this message]
2017-08-23 21:21 ` [PATCH 2/3] cpuidle: Move polling state initialization code to separate file Rafael J. Wysocki
2017-08-23 21:22 ` [PATCH 3/3] cpuidle: Make drivers initialize polling state Rafael J. Wysocki
2017-08-24 9:48 ` [PATCH 0/3] cpuidle: Rework the handling of the poll state Sudeep Holla
2017-08-28 21:17 ` Rafael J. Wysocki
2017-08-29 7:13 ` Daniel Lezcano
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=2660674.9kuByRF0WC@aspire.rjw.lan \
--to=rjw@rjwysocki.net \
--cc=daniel.lezcano@linaro.org \
--cc=jacob.jun.pan@linux.intel.com \
--cc=len.brown@intel.com \
--cc=linux-acpi@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-pm@vger.kernel.org \
--cc=peterz@infradead.org \
--cc=sudeep.holla@arm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox