[PATCH v5 7/9] thermal: exynos: split initialization of TMU and the thermal zone

Mateusz Majewski
2023-11-20T14:52:19Z

This will be needed in the future, as the thermal zone subsystem might
call our callbacks right after devm_thermal_of_zone_register. Currently
we just make get_temp return EAGAIN in such case, but this will not be
possible with state-modifying callbacks, for instance set_trips.

Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Signed-off-by: Mateusz Majewski <m.majewski2@samsung.com>
---
v3 -> v4: Reordered calls done while leaving exynos_tmu_initialize so
that they mirror the calls done while entering this function.
v1 -> v2: We take clocks into account; exynos_tmu_initialize needs both
clocks, as tmu_initialize might use the base_second registers. However,
exynos_thermal_zone_configure only needs clk.

drivers/thermal/samsung/exynos_tmu.c | 104 +++++++++++++++------------
1 file changed, 60 insertions(+), 44 deletions(-)

diff --git a/drivers/thermal/samsung/exynos_tmu.c b/drivers/thermal/samsung/exynos_tmu.c
index d918bf6d5359..6b3a7dd05c68 100644
--- a/drivers/thermal/samsung/exynos_tmu.c
+++ b/drivers/thermal/samsung/exynos_tmu.c
@@ -251,25 +251,8 @@ static void sanitize_temp_error(struct exynos_tmu_data *data, u32 trim_info)
static int exynos_tmu_initialize(struct platform_device *pdev)
{
struct exynos_tmu_data *data = platform_get_drvdata(pdev);
- struct thermal_zone_device *tzd = data->tzd;
- int num_trips = thermal_zone_get_num_trips(tzd);
unsigned int status;
- int ret = 0, temp;
-
- ret = thermal_zone_get_crit_temp(tzd, &temp);
- if (ret && data->soc != SOC_ARCH_EXYNOS5433) { /* FIXME */
- dev_err(&pdev->dev,
- "No CRITICAL trip point defined in device tree!\n");
- goto out;
- }
-
- if (num_trips > data->ntrip) {
- dev_info(&pdev->dev,
- "More trip points than supported by this TMU.\n");
- dev_info(&pdev->dev,
- "%d trip points should be configured in polling mode.\n",
- num_trips - data->ntrip);
- }
+ int ret = 0;

mutex_lock(&data->lock);
clk_enable(data->clk);
@@ -280,32 +263,63 @@ static int exynos_tmu_initialize(struct platform_device *pdev)
if (!status) {
ret = -EBUSY;
} else {
- int i, ntrips =
- min_t(int, num_trips, data->ntrip);
-
data->tmu_initialize(pdev);
-
- /* Write temperature code for rising and falling threshold */
- for (i = 0; i < ntrips; i++) {
-
- struct thermal_trip trip;
-
- ret = thermal_zone_get_trip(tzd, i, &trip);
- if (ret)
- goto err;
-
- data->tmu_set_trip_temp(data, i, trip.temperature / MCELSIUS);
- data->tmu_set_trip_hyst(data, i, trip.temperature / MCELSIUS,
- trip.hysteresis / MCELSIUS);
- }
-
data->tmu_clear_irqs(data);
}
+
+ if (!IS_ERR(data->clk_sec))
+ clk_disable(data->clk_sec);
+ clk_disable(data->clk);
+ mutex_unlock(&data->lock);
+
+ return ret;
+}
+
+static int exynos_thermal_zone_configure(struct platform_device *pdev)
+{
+ struct exynos_tmu_data *data = platform_get_drvdata(pdev);
+ struct thermal_zone_device *tzd = data->tzd;
+ int i, num_trips = thermal_zone_get_num_trips(tzd);
+ int ret = 0, temp;
+
+ ret = thermal_zone_get_crit_temp(tzd, &temp);
+
+ if (ret && data->soc != SOC_ARCH_EXYNOS5433) { /* FIXME */
+ dev_err(&pdev->dev,
+ "No CRITICAL trip point defined in device tree!\n");
+ goto out;
+ }
+
+ mutex_lock(&data->lock);
+
+ if (num_trips > data->ntrip) {
+ dev_info(&pdev->dev,
+ "More trip points than supported by this TMU.\n");
+ dev_info(&pdev->dev,
+ "%d trip points should be configured in polling mode.\n",
+ num_trips - data->ntrip);
+ }
+
+ clk_enable(data->clk);
+
+ num_trips = min_t(int, num_trips, data->ntrip);
+
+ /* Write temperature code for rising and falling threshold */
+ for (i = 0; i < num_trips; i++) {
+ struct thermal_trip trip;
+
+ ret = thermal_zone_get_trip(tzd, i, &trip);
+ if (ret)
+ goto err;
+
+ data->tmu_set_trip_temp(data, i, trip.temperature / MCELSIUS);
+ data->tmu_set_trip_hyst(data, i, trip.temperature / MCELSIUS,
+ trip.hysteresis / MCELSIUS);
+ }
+
err:
clk_disable(data->clk);
mutex_unlock(&data->lock);
- if (!IS_ERR(data->clk_sec))
- clk_disable(data->clk_sec);
out:
return ret;
}
@@ -1044,10 +1058,12 @@ static int exynos_tmu_probe(struct platform_device *pdev)
break;
}

- /*
- * data->tzd must be registered before calling exynos_tmu_initialize(),
- * requesting irq and calling exynos_tmu_control().
- */
+ ret = exynos_tmu_initialize(pdev);
+ if (ret) {
+ dev_err(&pdev->dev, "Failed to initialize TMU\n");
+ return ret;
+ }
+
data->tzd = devm_thermal_of_zone_register(&pdev->dev, 0, data,
&exynos_sensor_ops);
if (IS_ERR(data->tzd)) {
@@ -1058,9 +1074,9 @@ static int exynos_tmu_probe(struct platform_device *pdev)
goto err_sclk;
}

- ret = exynos_tmu_initialize(pdev);
+ ret = exynos_thermal_zone_configure(pdev);
if (ret) {
- dev_err(&pdev->dev, "Failed to initialize TMU\n");
+ dev_err(&pdev->dev, "Failed to configure the thermal zone\n");
goto err_sclk;
}

--
2.42.0