Re: [PATCH] thermal: imx8mm: Fix build warning of incorrect argument type

[Daniel Lezcano <daniel.lezcano@linaro.org>]

On 23/03/2020 15:19, Anson Huang wrote:
> Fix below sparse warning:
> 
> drivers/thermal/imx8mm_thermal.c:82:36: sparse: sparse: incorrect type in argument 2 (different address spaces), expected unsigned long const volatile *addr
> drivers/thermal/imx8mm_thermal.c:82:36: sparse: expected unsigned long const volatile *addr
> 
> Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
> ---
>  drivers/thermal/imx8mm_thermal.c | 7 +++----
>  1 file changed, 3 insertions(+), 4 deletions(-)
> 
> diff --git a/drivers/thermal/imx8mm_thermal.c b/drivers/thermal/imx8mm_thermal.c
> index c32308b..0d60f8d 100644
> --- a/drivers/thermal/imx8mm_thermal.c
> +++ b/drivers/thermal/imx8mm_thermal.c
> @@ -75,15 +75,14 @@ static int imx8mp_tmu_get_temp(void *data, int *temp)
>  {
>  	struct tmu_sensor *sensor = data;
>  	struct imx8mm_tmu *tmu = sensor->priv;
> +	unsigned long val;
>  	bool ready;
> -	u32 val;
>  
> -	ready = test_bit(probe_status_offset(sensor->hw_id),
> -			 tmu->base + TRITSR);
> +	val = readl_relaxed(tmu->base + TRITSR);
> +	ready = test_bit(probe_status_offset(sensor->hw_id), &val);
>  	if (!ready)
>  		return -EAGAIN;

Doesn't this patch also fix a bug because the read was done after
testing the bit? :)

> -	val = readl_relaxed(tmu->base + TRITSR);
>  	val = sensor->hw_id ? FIELD_GET(TRITSR_TEMP1_VAL_MASK, val) :
>  	      FIELD_GET(TRITSR_TEMP0_VAL_MASK, val);
>  	if (val & SIGN_BIT) /* negative */
> 


-- 
 <http://www.linaro.org/> Linaro.org │ Open source software for ARM SoCs

Follow Linaro:  <http://www.facebook.com/pages/Linaro> Facebook |
<http://twitter.com/#!/linaroorg> Twitter |
<http://www.linaro.org/linaro-blog/> Blog