messages from 2015-12-22 10:16:45 to 2016-01-07 09:45:12 UTC [more...]
[PATCH v3 0/2] Enabling PSCI based idle on ARM 32-bit platforms
2016-01-07 9:46 UTC (11+ messages)
` [PATCH v3 2/2] ARM64: kernel: PSCI: move PSCI idle management code to drivers/firmware
[RFC PATCH 0/2] IRQ based next prediction
2016-01-06 17:40 UTC (4+ messages)
` [RFC PATCH 1/2] irq: Add a framework to measure interrupt timings
` [RFC PATCH 2/2] sched: idle: IRQ based next prediction for idle period
[PATCH v3 0/4] thermal: re-calculate k_po/k_pu when update sustainable power
2016-01-06 15:05 UTC (9+ messages)
` [PATCH v3 1/4] thermal: power_allocator: rework proportional parameter
` [PATCH v3 2/4] thermal: power_allocator: change k_pu_ratio/k_po_ratio as percentage
` [PATCH v3 3/4] thermal: add sys node for k_pu_ratio/k_po_ratio
` [PATCH v3 4/4] thermal: power_allocator: document k_pu_ratio/k_po_ratio
[PATCH v2 0/4] thermal: re-calculate k_po/k_pu when update sustainable power
2016-01-06 8:48 UTC (6+ messages)
` [PATCH v2 1/4] thermal: power_allocator: rework proportional parameter
` [PATCH v2 2/4] thermal: power_allocator: change k_pu_ratio/k_po_ratio as percentage
` [PATCH v2 3/4] thermal: add sys node for k_pu_ratio/k_po_ratio
` [PATCH v2 4/4] thermal: power_allocator: document k_pu_ratio/k_po_ratio
[PATCH v2 0/2] cpufreq: powernv: Redesign the presentation of throttle notification
2016-01-06 6:51 UTC (9+ messages)
` [PATCH v2 1/2] cpufreq: powernv/tracing: Add powernv_throttle tracepoint
` [PATCH v2 2/2] cpufreq: powernv: Redesign the presentation of throttle notification
` [PATCH v3 0/2] "
` [PATCH v3 1/2] cpufreq: powernv/tracing: Add powernv_throttle tracepoint
` [PATCH v3 2/2] cpufreq: powernv: Redesign the presentation of throttle notification
[PATCH] power: bq27xxx_battery: Fix bq27541 AveragePower register address
2016-01-06 6:49 UTC (2+ messages)
[PATCH v11 0/4] Allow USB devices to remain runtime-suspended when sleeping
2016-01-05 23:38 UTC (5+ messages)
` "
[PATCH] PM / OPP: Use snprintf() instead of sprintf()
2016-01-05 19:52 UTC (3+ messages)
[PATCH] thermal: cpu_cooling: fix out of bounds access in time_in_idle
2016-01-05 19:19 UTC (3+ messages)
[PATCH v2] thermal: re-calculate k_po/k_pu when update sustainable power
2016-01-05 18:02 UTC (10+ messages)
[PATCH 0/2] power: Add support for TI BQ24261 charger
2016-01-05 15:20 UTC (4+ messages)
[PATCH] cpufreq-dt: fix handling regulator_get_voltage result
2016-01-05 13:03 UTC (3+ messages)
[PATCH] cpufreq: ondemand: Set MIN_FREQUENCY_UP_THRESHOLD to 1
2016-01-05 13:02 UTC (3+ messages)
[PATCH V3 0/2] PM / OPP: Parse opp-supported-hw/opp-<prop>-<name> bindings
2016-01-05 10:46 UTC (4+ messages)
` [PATCH V3 2/2] PM / OPP: Parse 'opp-<prop>-<name>' bindings
[PATCH] power: bq27xxx_battery: Fix bq27541 AveragePower register address
2016-01-05 10:13 UTC
[PATCH v2 0/3] ARM64: dts: cpufreq: mt8173: Migrate mt8173-cpufreq to use OPPv2 bindings
2016-01-05 10:24 UTC (12+ messages)
` [PATCH v2 1/3] PM/OPP: Don't skip cpu_dev->id when setting up cpumask
` [PATCH v2] PM/OPP: Set cpu_dev->id in cpumask first
` [PATCH v2 2/3] cpufreq: mt8173: migrate to use operating-points-v2 bindings
` [PATCH v2 3/3] ARM64: dts: mt8173: Add CPU OPP, clock and regulator supply properties
[PATCHv2 0/3] thermal: rework core to improve userspace interaction
2016-01-05 9:46 UTC (3+ messages)
` [PATCHv2 3/3] thermal: improve hot trip handling
[PATCH 0/8 v5] enable to use thermal-zone on r8a7790/1
2016-01-05 8:08 UTC (5+ messages)
` [PATCH 5/8 v5] thermal: rcar: enable to use thermal-zone on DT
` [PATCH 5/8 v6] "
[PATCH] power: bq27xxx_battery: Fix bq27541 AveragePower register address
2016-01-05 7:04 UTC
[PATCH v2] drivers: qcom: spm: avoid module usage in non-modular SPM driver
2016-01-05 5:45 UTC (2+ messages)
[PATCH] drivers: qcom: spm: avoid module usage in non-modular SPM driver
2016-01-04 18:30 UTC (6+ messages)
[PATCH v12] Add Mediatek thermal support
2016-01-04 15:43 UTC (7+ messages)
` [PATCH 2/3] thermal: Add Mediatek thermal controller support
[PATCH v3 0/4] Hierarchical thermal zones
2016-01-04 14:17 UTC (3+ messages)
` [PATCH v3 2/4] devicetree: bindings: let thermal-sensor point to other "
[PATCH] thermal: imx: update the temperature calibration data for imx6 soc
2016-01-04 7:37 UTC (4+ messages)
[PATCH v7 0/4] Introduce usb charger framework to deal with the usb gadget power negotation
2016-01-04 5:21 UTC (6+ messages)
` [PATCH v7 1/4] gadget: Introduce the usb charger framework
` [PATCH v7 2/4] gadget: Support for "
` [PATCH v7 3/4] gadget: Integrate with the usb gadget supporting for usb charger
` [PATCH v7 4/4] power: wm831x_power: Support USB charger current limit management
[PATCH] PowerCap: constify powercap_zone_ops and powercap_zone_constraint_ops structures
2016-01-03 0:58 UTC (2+ messages)
[PATCH] blackfin-cpufreq: Change return type of cpu_set_cclk() to that of clk_set_rate()
2016-01-03 1:02 UTC (4+ messages)
` [PATCH 2/2] blackfin-cpufreq: Mark cpu_set_cclk() as static
[PATCH v2] PM / OPP: Fix parsing of opp-microvolt and opp-microamp properties
2016-01-03 0:58 UTC (3+ messages)
[PATCH] drivers: power: fix typo in documentation
2016-01-03 0:57 UTC (3+ messages)
[PATCH] cpufreq: governor: Fix negative idle_time when configured with CONFIG_HZ_PERIODIC
2016-01-03 0:56 UTC (2+ messages)
question on autosuspend vs. system suspend
2016-01-02 17:26 UTC (2+ messages)
[PATCH] power_suply: isp1704_charger: Fix isp1704_write() definition
2016-01-02 15:48 UTC (4+ messages)
[GIT PULL] Thermal-SoC management updates for v4.4-rc8
2016-01-02 2:35 UTC (3+ messages)
[PATCH] PM / sleep: Add support for read-only sysfs attributes
2016-01-02 2:09 UTC
[PATCH 0/3][v3] Fix thermal problems during suspend/bootup
2016-01-01 15:38 UTC (8+ messages)
` [PATCH 1/3][v3] Thermal: initialize thermal zone device correctly
` [PATCH 2/3][v3] Thermal: handle thermal zone device properly during system sleep
` [PATCH 3/3][v3] Thermal: do thermal zone update after a cooling device registered
[PATCH 6/7] power: generic-adc-battery: use to_delayed_work
2016-01-01 14:59 UTC
[PATCH 0/6] thermal: iio bindings
2015-12-31 23:31 UTC (5+ messages)
` [PATCH 3/6] thermal: iio device for thermal sensor
[PATCH] MAINTAINERS: Add myself as a reviewer for the bq27xxx driver
2015-12-31 21:11 UTC (4+ messages)
[RFC PATCH] thermal: Schedule a backup thermal shutdown workqueue after a known period of time to tackle failed poweroff
2015-12-31 18:29 UTC (6+ messages)
[PATCH v4] Documentation: cpufreq: intel_pstate: enhance documentation
2015-12-31 1:45 UTC
[PATCH] thermal: re-calculate k_po/k_pu when update sustainable power
2015-12-30 6:22 UTC (2+ messages)
[PATCH] thermal: hisilicon: increase temperature resolution
2015-12-30 5:13 UTC
[PATCH v3] Documentation: cpufreq: intel_pstate: enhance documentation
2015-12-29 3:23 UTC
Charity/Donation
2015-12-29 1:04 UTC
Assalam o Alaikum
2015-12-29 2:03 UTC
[PATCH v2] Documentation: cpufreq: intel_pstate: enhance documentation
2015-12-29 0:44 UTC (3+ messages)
Charity Donation
2015-12-28 23:10 UTC
[PATCH 0/3] cpufreq: Boost cleanup
2015-12-28 3:29 UTC (7+ messages)
` [PATCH 1/3] cpufreq: Make cpufreq_boost_supported() static
` [PATCH 2/3] cpufreq: acpi-cpufreq: Simplify boost-related code
` [PATCH 3/3] cpufreq: Simplify core code related to boost support
[PATCH] thermal: ensure SoC thermal drivers depend on associated SoC
2015-12-27 16:53 UTC
[PATCH 01/10] PM / devfreq: exynos: use to_platform_device()
2015-12-27 13:15 UTC
[GIT PULL] Power management and ACPI fixes for v4.4-rc7
2015-12-26 21:40 UTC
[PATCH 0/2] two fixes for new bq27000/10 and bq27500 driver
2015-12-25 13:22 UTC (9+ messages)
` [PATCH 1/2] power:bq27xxx: fix reading for bq27000 and bq27010
` [PATCH 2/2] power:bq27xxx: fix register numbers of bq27500
[PATCH 0/2] i2c: proper RuntimePM for the adapter device
2015-12-25 5:53 UTC (8+ messages)
` [PATCH 1/2] i2c: always enable "
` [PATCH 2/2] i2c: s3c2410: remove superfluous runtime PM calls
[PATCH] cpufreq: scpi-cpufreq: signedness bug in scpi_get_dvfs_info()
2015-12-24 9:53 UTC (4+ messages)
[PATCH] PM / Domains: Release mutex when powering on master domain
2015-12-23 11:49 UTC (3+ messages)
[PATCH V4] PM / Domains: Remove intermediate states from the power off sequence
2015-12-23 11:40 UTC (3+ messages)
[PATCH] cpufreq/scpi: fix handling return value of topology_physical_package_id
2015-12-23 10:48 UTC (3+ messages)
[PATCH 00/17] PM / OPP: Introduce APIs to transition OPPs
2015-12-23 3:12 UTC (15+ messages)
` [PATCH 06/17] PM / OPP: Parse clock-latency and voltage-tolerance for v1 bindings
` [PATCH 07/17] PM / OPP: Manage device clk
` [PATCH 08/17] PM / OPP: Add dev_pm_opp_set_rate()
` [PATCH 10/17] cpufreq: dt: Rename 'need_update' to 'opp_v1'
` [PATCH 11/17] cpufreq: dt: OPP layers handles clock-latency for V1 bindings as well
` [PATCH 12/17] cpufreq: dt: Pass regulator name to the OPP core for V1 bindings
` [PATCH 13/17] cpufreq: dt: Unsupported OPPs are already disabled
` [PATCH 14/17] cpufreq: dt: Reuse dev_pm_opp_get_max_transition_latency()
` [PATCH 15/17] cpufreq: dt: Use dev_pm_opp_set_rate() to switch frequency
` [PATCH 16/17] cpufreq: dt: drop references to DT node
` [PATCH 17/17] cpufreq: dt: No need to allocate resources anymore
` [PATCH 09/17] cpufreq: dt: Convert few pr_debug/err() calls to dev_dbg/err()
[PATCH] Documentation: cpufreq: intel_pstate: enhance documentation
2015-12-22 17:48 UTC (3+ messages)
[PATCH] power, test_power: correctly handle empty writes
2015-12-22 17:43 UTC
page: next (older) | prev (newer) | latest
- recent:[subjects (threaded)|topics (new)|topics (active)]
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox;
as well as URLs for NNTP newsgroup(s).